Search NASA⌕ Search

Engineering topics

Li, J

Publications and source records attributed to Li, J.

At least 91 records · Page 5

Measurement of the inclusive semileptonic branching fraction B ( B s 0 → X - ℓ + ν ℓ ) at Belle

Here, we report a measurement of the inclusive semileptonic B s 0 branching fraction in a 121 fb - 1 data sample collected near the Υ ( 5 S ) resonance with the Belle detector at the KEKB asymmetric energy e + e - collider. Events with B s 0 ( * ) B ¯ s 0 ( * ) pairs are selected by reconstructing a tag side D s + and identifying a signal side lepton ℓ + ( ℓ = e , μ ) that is required to have the same-sign charge to ensure that both originate from different B s 0 mesons. The B s 0 → X - ℓ + ν ℓ branching fraction is extracted from the ratio of the measured yields of D s + mesons and D s + ℓ + pairs and the known production and branching fractions. The inclusive semileptonic branching fraction is measured to be [ 10.6 ± 0.5 ( stat ) ± 0.7 ( syst ) ] % .

72 PHYSICS OF ELEMENTARY PARTICLES AND FIELDS↗

Different Factors Affecting Short Circuit Behavior of a Wind Power Plant

A wind power plant consists of a large number of turbines interconnected by underground cable. A pad-mount transformer at each turbine steps up the voltage from generating voltage (690 V) to a medium voltage (34.5 kV). All turbines in the plant are connected to the substation transformer where the voltage is stepped up to the transmission level. An important aspect of wind power plant (WPP) impact studies is to evaluate the short-circuit (SC) current contribution of the plant into the transmission network under different fault conditions. This task can be challenging to protection engineers due to the topology differences between different types of wind turbine generators (WTGs) and the conventional generating units. This paper investigates the short circuit behavior of a wind power plant for different types of faults. The impact of wind turbine types, the transformer configuration, and the reactive compensation capacitor will be investigated. The voltage response at different buses will be observed. Finally, the SC line currents will be presented along with its symmetrical components.

Fault contribution, induction generator, protectio↗

Engineering Catalytic Contacts and Thermal Stability: Gold/Iron Oxide Binary Nanocrystal Superlattices for CO Oxidation

Well-defined surface, such as surface of a single crystal, is being used to provide precise interpretation of catalytic processes, while the nanoparticulate model catalyst more closely represents the real catalysts that are used in industrial processes. Nanocrystal superlattice, which combines the chemical and physical properties of different materials in a single crystalline structure, is an ideal model catalyst, that bridge between conventional models and real catalysts. We identify the active sites for carbon monoxide (CO) oxidation on Au-FeOx catalysts by using Au-FeOx binary superlattices correlating the activity to the number density of catalytic contacts between Au and FeOx. Moreover, using nanocrystal superlattices, we propose a general strategy of keeping active metals spatially confined to enhance the stability of metal catalysts. With a great range of nanocrystal superlattice structures and compositions, we establish that nanocrystal superlattices are useful model materials through which to explore, understand, and improve catalytic processes bridging the gap between traditional single crystal and supported catalyst studies.

Kang, YJ↗

Comprehensive dielectric performance of bismuth acceptor doped BaTiO3 based nanocrystal thin film capacitors

We present a novel approach to preparing bismuth acceptor doped barium titanate nanocrystal formulations that can be deposited in conjunction with polymers in order to prepare a thin film nanocomposite dielectric that exhibits desirable capacitor characteristics. Exploring the limits of dielectric function in nanocomposites is an important avenue of materials research, while paying strict attention to the overall device quality, namely permittivity, loss and equivalent series resistance (ESR). Pushing capacitor function to higher frequencies, a desirable goal from an electrical engineering point of view, presents a new set of challenges in terms of minimizing interfacial, space charge and polarization effects within the dielectric. We show the ability to synthesize BaTi0.96Bi0.04O3 or BaTi0.97Bi0.03O3 depending on nominal molar concentrations of bismuth at the onset. The low temperature solvothermal route allows for substitution at the titanium site (strongly supported by Rietveld and Raman analysis). Characterization is performed by XRD with Rietveld refinement, Raman Spectroscopy, SEM and HRTEM. A mechanism is proposed for bismuth acceptor substitution, based on the chemical reaction of the alkoxy-metal precursors involving nucleophilic addition. Dielectric analysis of the nanocrystal thin films is performed by preparing nanocrystal/PVP 2-2 nanocomposites (no annealing) and comparing BaTi0.96Bi0.04O3 and BaTi0.97Bi0.03O3 with undoped BaTiO3. Improvements of up to 25% in capacitance (permittivity) are observed, with lower loss and dramatically improved ESR, all to very high frequency ranges (>10 MHz).

Liu, SY↗

Intrinsic dielectric frequency dependent spectrum of a single domain tetragonal BaTiO3

The intrinsic dielectric frequency dependent spectrum of single domain barium titanate (BaTiO3) at room temperature is investigated by considering the vibration of phonons and the conductivity of the tetragonal system in a wide frequency range up to THz. The proposed model combines Debye type of dissipation, soft mode theory, and the influence of conductivity on the dielectric loss to obtain a more precise dielectric frequency spectrum. The calculated results were compared with experimental data on single domain nanocrystals of BaTiO3, both free standing and suspended in a low dielectric medium. The comparisons provide insight into the mechanism for the dielectric behavior, which can be extended to apply to a range of composites that comprise single domain dielectrics embedded in continuous media. At the lower frequency range, conductivity plays a dominant role in the contribution to the dielectric loss along both a-and c-axes, while the phonon vibration controls the dielectric behavior of the system at higher frequency range. When the conductivity of the system increases, the dielectric loss increases below the MHz range, with such an effect diminishing when the frequency reaches the GHz regime. (C) 2012 American Institute of Physics. [http://dx.doi.org/10.1063/1.4734004]

Liu, SY↗

Enhanced electrical and noise properties of nanocomposite vanadium oxide thin films by reactive pulsed-dc magnetron sputtering

Thin films of VO{sub x} (1.3 {<=} x {<=} 2) were deposited by reactive pulsed-dc magnetron sputtering of a vanadium metal target while RF-biasing the substrate. Rutherford back scattering, glancing angle x-ray, and cross-sectional transmission electron microscopy measurements revealed the formation of nanocolumns with nanotwins within VO{sub x} samples. The resistivity of nanotwinned VO{sub x} films ranged from 4 m{Omega}{center_dot}cm to 0.6 {Omega}{center_dot}cm and corresponding temperature coefficient of resistance between -0.1% and -2.6% per K, respectively. The 1/f electrical noise was analyzed in these VO{sub x} samples using the Hooge-Vandamme relation. These VO{sub x} films are comparable or surpass commercial VO{sub x} films deposited by ion beam sputtering.

36 MATERIALS SCIENCE↗

Comparative Study of Zn(O,S) Buffer Layers and CIGS Solar Cells Fabricated by CBD, ALD, and Sputtering: Preprint

Zn(O,S) thin films were deposited by chemical bath deposition (CBD), atomic layer deposition, and sputtering. Composition of the films and band gap were measured and found to follow the trends described in the literature. CBD Zn(O,S) parameters were optimized and resulted in an 18.5% efficiency cell that did not require post annealing, light soaking, or an undoped ZnO layer. Promising resultswere obtained with sputtering. A 13% efficiency cell was obtained for a Zn(O,S) emitter layer deposited with 0.5%O2. With further optimization of process parameters and an analysis of the loss mechanisms, it should be possible to increase the efficiency.

14 SOLAR ENERGY↗

Regimes of Diurnal Variation of Summer Rainfall over Subtropical East Asia

Using hourly rain gauge records and Tropical Rainfall Measuring Mission 3B42 from 1998 to 2006, the authors present an analysis of the diurnal characteristics of summer rainfall over subtropical East Asia. The study shows that there are four different regimes of distinct diurnal variation of rainfall in both the rain gauge and the satellite data. They are located over the Tibetan Plateau with late-afternoon and midnight peaks, in the western China plain with midnight to early-morning peaks, in the eastern China plain with double peaks in late afternoon and early morning, and over the East China Sea with an early-morning peak. No propagation of diurnal phases is found from the land to the ocean across the coastlines. The different diurnal regimes are highly correlated with the inhomogeneous underlying surface, such as the plateau, plain, and ocean, with physical mechanisms consistent with the large-scale 'mountain-valley' and 'land-sea' breezes and convective instability. These diurnal characteristics over subtropical East Asia can be used as diagnostic metrics to evaluate the physical parameterization and hydrological cycle of climate models over East Asia.

54 ENVIRONMENTAL SCIENCES↗

LONG-TERM MONITORING OF THE HIGH-ENERGY {gamma}-RAY EMISSION FROM LS I +61 Degree-Sign 303 AND LS 5039

The Fermi Large Area Telescope (LAT) reported the first definitive GeV detections of the binaries LS I +61 Degree-Sign 303 and LS 5039 in the first year after its launch in 2008 June. These detections were unambiguous as a consequence of the reduced positional uncertainty and the detection of modulated {gamma}-ray emission on the corresponding orbital periods. An analysis of new data from the LAT, comprising 30 months of observations, identifies a change in the {gamma}-ray behavior of LS I +61 Degree-Sign 303. An increase in flux is detected in 2009 March and a steady decline in the orbital flux modulation is observed. Significant emission up to 30 GeV is detected by the LAT; prior data sets led to upper limits only. Contemporaneous TeV observations no longer detected the source, or found it-in one orbit-close to periastron, far from the phases at which the source previously appeared at TeV energies. The detailed numerical simulations and models that exist within the literature do not predict or explain many of these features now observed at GeV and TeV energies. New ideas and models are needed to fully explain and understand this behavior. A detailed phase-resolved analysis of the spectral characterization of LS I +61 Degree-Sign 303 in the GeV regime ascribes a power law with an exponential cutoff spectrum along each analyzed portion of the system's orbit. The on-source exposure of LS 5039 is also substantially increased with respect to our prior publication. In this case, whereas the general {gamma}-ray properties remain consistent, the increased statistics of the current data set allows for a deeper investigation of its orbital and spectral evolution.

79 ASTRONOMY AND ASTROPHYSICS↗

Scanning secondary-electron microscopy on ferroelectric domains and domain walls in YMnO{sub 3}

Ferroelectric domain structures in YMnO{sub 3} single crystals on the hexagonal polar surface have been investigated by scanning electron microscopy in secondary electron emission mode. The experimental results demonstrate that the domain, as well as domain walls, can be clearly revealed under the operation voltages ranging from 0.6 to 3 kV. Evolution of domain contrasts arising from electron-beam irradiation can be mainly explained by the pyroelectric effect and related charging process. A rich variety of microstructure features of ferroelectric domains can be clearly revealed in YMnO{sub 3} by this high-resolution technique.

36 MATERIALS SCIENCE↗

Highly Active Pt(3)Pb and Core-Shell Pt(3)Pb-Pt Electrocatalysts for Formic Acid Oxidation

Formic acid is a promising chemical fuel for fuel cell applications. However, due to the dominance of the indirect reaction pathway and strong poisoning effects, the development of direct formic acid fuel cells has been impeded by the low activity of existing electrocatalysts at desirable operating voltage. We report the first synthesis of Pt{sub 3}Pb nanocrystals through solution phase synthesis and show they are highly efficient formic acid oxidation electrocatalysts. The activity can be further improved by manipulating the Pt{sub 3}Pb-Pt core-shell structure. Combined experimental and theoretical studies suggest that the high activity from Pt{sub 3}Pb and the Pt-Pb core-shell nanocrystals results from the elimination of CO poisoning and decreased barriers for the dehydrogenation steps. Therefore, the Pt{sub 3}Pb and Pt-Pb core-shell nanocrystals can improve the performance of direct formic acid fuel cells at desired operating voltage to enable their practical application.

30 DIRECT ENERGY CONVERSION↗