Search NASA⌕ Search

Engineering topics

Li, Jiantao

Publications and source records attributed to Li, Jiantao.

40 records · Page 3
All sourcesNASA NTRSDOE OSTI
DOE OSTI2021

Understanding the Role of Lithium Iodide in Lithium–Oxygen Batteries

Lithium–oxygen (Li–O 2 ) batteries possess a high theoretical energy density, which means they could become a potential alternative to lithium-ion batteries. Nevertheless, the charging process of Li–O 2 batteries requires much higher energy, due to the insulating nature of the discharge product. It has been revealed that the anion additive, lithium iodide (LiI), can tune the cell chemistry to form lithium hydroxide (LiOH) as the product and facilitate the kinetics during the charging process. Although numerous studies have been reported, the role of this additive is still under investigation. Herein, the recent advances focusing on the use of LiI in Li–O 2 batteries are reviewed, its catalytic behavior on discharge and charge is discussed, and its synergistic effect with water is understood. Here, the ambiguity existing among the studies are also revealed, and solutions to the current issues are introduced.

25 ENERGY STORAGE↗
DOE OSTI2021

Correlating Catalyst Design and Discharged Product to Reduce Overpotential in Li-CO 2 Batteries

Li-CO 2 batteries with dual efficacy for greenhouse gas CO 2 sequestration and high energy output have been regarded as a promising electrochemical energy storage technology. However, battery feasibility has been hampered by inferior electrochemical performance due to large overpotentials and low cyclability primarily caused by the difficult decomposition of ultra-stable Li 2 CO 3 during charge. The use of cathode catalysts has been highlighted as a promising solution and catalyst properties, as well as the nature of discharge products, are closely correlated with electrochemical performance. Here, the catalyst design strategies that include active site enrichment, electrical transport enhancement, and mass transfer improvement are summarized. Catalyst effects on product decomposition are then subsequently introduced, while product geometry and chemical composition will be explored, with an emphasis on the formation/decomposition of Li 2 C 2 O 4 instead of Li 2 CO 3 . Building on previous research, future directions that facilitate improvements in catalyst design are put forward to reinforce the fundamental development of Li-CO 2 batteries.

25 ENERGY STORAGE↗
DOE OSTI2021

Isolated copper–tin atomic interfaces tuning electrocatalytic CO 2 conversion

Direct experimental observations of the interface structure can provide vital insights into heterogeneous catalysis. Examples of interface design based on single atom and surface science are, however, extremely rare. Here, we report Cu–Sn single-atom surface alloys, where isolated Sn sites with high surface densities (up to 8%) are anchored on the Cu host, for efficient electrocatalytic CO 2 reduction. The unique geometric and electronic structure of the Cu–Sn surface alloys (Cu 97 Sn 3 and Cu 99 Sn 1 ) enables distinct catalytic selectivity from pure Cu 100 and Cu 70 Sn 30 bulk alloy. The Cu 97 Sn 3 catalyst achieves a CO Faradaic efficiency of 98% at a tiny overpotential of 30 mV in an alkaline flow cell, where a high CO current density of 100 mA cm –2 is obtained at an overpotential of 340 mV. Density functional theory simulation reveals that it is not only the elemental composition that dictates the electrocatalytic reactivity of Cu–Sn alloys; the local coordination environment of atomically dispersed, isolated Cu–Sn bonding plays the most critical role.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗