Search NASA⌕ Search

Engineering topics

Li, M.

Publications and source records attributed to Li, M..

At least 73 records · Page 4

Observation of fast expansion velocity with insulating tungsten wires on ∼80 kA facility

This paper presents experimental results on the effects of insulating coatings on tungsten planar wire array Z-pinches on an 80 kA, 100 ns current facility. Expansion velocity is obviously increased from ∼0.25 km/s to ∼3.5 km/s by using the insulating coatings. It can be inferred that the wire cores are in gaseous state with this fast expansion velocity. An optical framing camera and laser probing images show that the standard wire arrays have typical ablation process which is similar to their behaviors on mega-ampere facilities. The ablation process and precursor plasma are suppressed for dielectric tungsten wires. The wire array implosion might be improved if these phenomena can be reproduced on Mega-ampere facilities.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Fabrication of Electrostatically Actuated Microshutters Arrays

A new fabrication process has been developed to actuate microshutter arrays (MSA) electrostatically at NASA Goddard Space Flight Center. The microshutters, made with silicon nitride membranes with a pixel size of 100 x 200 sq microns, rotate on torsion bars. The microshutters are actuated, latched, and addressed electrostatically by applying voltages on the electrodes the front and back sides of the microshutters. The atomic layer deposition (ALD) of aluminum oxide was used to insulate electrodes on the back side of walls; the insulation can withstand over 100 V. The ALD aluminum oxide is dry etched, and then the microshutters are released in vapor HF.

microshutter arrays (MSA)↗

In situ studies on radiation tolerance of nanotwinned Cu

We investigate the radiation response of nanotwinned Cu by using in situ Kr ion irradiation technique inside a transmission electron microscope. In comparison with coarse grained Cu, nanotwinned Cu exhibits smaller defect size and lower defect density. In situ studies also show that twin boundaries effectively remove a large number of defect clusters. The life time of defect clusters in nanotwinned Cu is very different from that in its coarse grained counterpart. This study provides further evidence on twin-boundary enabled radiation tolerance in nanotwinned metals.

Material Science↗

Ridge InGaAs/InP multi-quantum-well selective growth in nanoscale trenches on Si (001) substrate

Metal organic chemical vapor deposition of InGaAs/InP multi-quantum-well in nanoscale V-grooved trenches on Si (001) substrate was studied using the aspect ratio trapping method. A high quality GaAs/InP buffer layer with two convex (111) B facets was selectively grown to promote the highly uniform, single-crystal ridge InP/InGaAs multi-quantum-well structure growth. Material quality was confirmed by transmission electron microscopy and room temperature micro-photoluminescence measurements. This approach shows great promise for the fabrication of photonics devices and nanolasers on Si substrate.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Study of EAST LH antennas coupling at ENEA-Frascati

The two Lower Hybrid (LH) launchers of the EAST tokamak have been analysed using some tools available at ENEA-Frascati research centre. The antennas, working at 2.45 and 4.6 GHz, have been assessed in terms of reflection coefficient and launched power spectrum for several plasma loads differing in the electron density profile. Fitting an experimental profile we derived a set of parameterised realistic density profiles to compute the coupling performances of different spectra, launched by considering different phasing between antenna modules. The sensitivity to the tilt of the magnetic field with respect to the equatorial plane as well as to an additional progressive phasing at the mouth due to the toroidal curvature has been studied too. The most suitable operational conditions for the minimization of reflected power and side lobes in the n{sub ||} spectra are identified.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Continuum absorption in the vicinity of the toroidicity-induced Alfvén gap

Excitation of Alfvén modes is commonly viewed as a concern for energetic particle confinement in burning plasmas. The 3.5 MeValpha particles produced by fusion may be affected as well as other fast ions in both present and future devices. Continuum damping of such modes is one of the key factors that determine their excitation thresholds and saturation levels. This work examines the resonant dissipative response of the Alfvén continuum to an oscillating driving current when the driving frequency is slightly outside the edges of the toroidicity-induced spectral gap. The problem is largely motivated by the need to describe the continuum absorption in the frequency sweeping events. Akey element of this problem is the negative interference of the two closely spaced continuum crossing points.Weexplain why the lower and upper edges of the gap can have very different continuum absorption features. Lastly, the difference is associated with an eigenmode whose frequency can be arbitrarily close to the upper edge of the gap whereas the lower edge of the gap is always a finite distance away from the closest eigenmode.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Microstructure chemistry and mechanical properties of Ni-based superalloy Rene N4 under irradiation at room temperature

Nickel superalloys with cubic L12 structured γ' (Ni 3 (Al, Ti)) precipitates exhibit high strength at high temperatures and excellent corrosion resistance when exposed to water. Unlike prior studies on irradiation damage of other Ni-based superalloys, our study on Rene N4 involves much larger γ' precipitates, ~450 nm in size, a size regime where the irradiation-induced disordering and dissolution kinetics and the corresponding mechanical property evolution are unknown. Under heavy ion irradiation at room temperature, the submicron-sized γ' precipitates were fully disordered at ~0.3 dpa and only later partially dissolved after 75 dpa irradiation. Nanoindentation experiments indicate that the mechanical properties of the alloy change significantly, with a dramatic decrease in hardness, with irradiation dose. Three contributions to the change in hardness were examined: defect clusters, disordering and dissolution. Moreover, the generation of defect clusters in the matrix and precipitates slightly increased the indentation hardness, while disordering of the submicron-sized γ' precipitates resulted in a dramatic decrease in the total hardness, which decreased further during the early stages of the intermixing between γ' precipitates and matrix (<18 dpa). As a result, controlling the long-range-ordering and chemical intermixing can be used to tailor the mechanical properties of Ni-based superalloys under irradiation.

36 MATERIALS SCIENCE↗

Pore connectivity, electrical conductivity, and partial water saturation: Network simulations

Abstract The electrical conductivity of brine‐saturated rock is predominantly dependent on the geometry and topology of the pore space. When a resistive second phase (e.g., air in the vadose zone and oil/gas in hydrocarbon reservoirs) displaces the brine, the geometry and topology of the pore space occupied by the electrically conductive phase are changed. We investigated the effect of these changes on the electrical conductivity of rock partially saturated with brine. We simulated drainage and imbibition as invasion and bond percolation processes, respectively, in pipe networks assumed to be perfectly water‐wet. The simulations included the formation of a water film in the pipes invaded by the nonwetting fluid. During simulated drainage/imbibition, we measured the changes in resistivity index as well as a number of relevant microstructural parameters describing the portion of the pore space saturated with water. Except Euler topological number, all quantities considered here showed a significant level of “universality,” i.e., insensitivity to the type of lattice used (simple cubic, body‐centered cubic, or face‐centered cubic). Hence, the coordination number of the pore network appears to be a more effective measure of connectivity than Euler number. In general, the simulated resistivity index did not obey Archie's simple power law. In log‐log scale, the resistivity index curves displayed a substantial downward or upward curvature depending on the presence or absence of a water film. Our network simulations compared relatively well with experimental data sets, which were obtained using experimental conditions and procedures consistent with the simulations. Finally, we verified that the connectivity/heterogeneity model proposed by Bernabé et al. (2011) could be extended to the partial brine saturation case when water films were not present.

Li, M.↗

Overview of results from the MST reversed field pinch experiment

An overview of recent results from the MST reversed field pinch programme is presented here. With neutral beam injection, bursty energetic particle (EP) modes are observed. The profiles of the magnetic and density fluctuations associated with these EP modes are measured using a far infrared interferometer–polarimeter. Equilibrium reconstructions of the quasi-single-helicity 3D helical state are provided by the V3FIT code that now incorporates several of MST's advanced diagnostics. The orientation of the helical structure is controlled using a new resonant magnetic perturbation technique. Gyrokinetic simulations based on experimental equilibria predict unstable trapped-electron modes (TEMs), and small-scale density fluctuations are detected in improved-confinement plasmas with TEM-like features. Upgraded pellet injection permits study of density and beta limits over MST's full range of operation, and an MST-record line-average density of 0.9 × 1020 m3 (n/nG = 1.4) has been obtained. Impurity ion temperature measurements reveal a charge-to-mass-ratio dependence in the rapid heating that occurs during a sawtooth crash. Runaway of NBI-born fast ions during the impulsive sawtooth event agrees with test-particle theory. Magnetic self-organization studies include measurements of the dynamo emf with an applied ac inductive electric field using oscillating field current drive.

beta limit↗

Positive temperature coefficient of coercivity in Sm{sub 1−x}Dy{sub x}(Co{sub 0.695}Fe{sub 0.2}Cu{sub 0.08}Zr{sub 0.025}){sub 7.2} magnets with spin-reorientation-transition cell boundary phases

Positive temperature coefficients of coercivity are first obtained in the series of Sm{sub 1−x}Dy{sub x} (Co{sub 0.695}Fe{sub 0.2}Cu{sub 0.08}Zr{sub 0.025}){sub 7.2} magnets. The temperature range with a positive temperature coefficient of coercivity is gradually moving to higher temperature with the increase of x. Thermal magnetic analysis shows a spin reorientation transition of cell boundary phase in these magnets. It is interesting to find the abnormal coercivity is controlled by the spin-reorientation-transition cell boundary phases, and the spin reorientation temperature of cell boundary phase is consisted with the start point of the temperature range with abnormal behavior. The different temperature coefficients are discussed in terms of a nucleation model.

36 MATERIALS SCIENCE↗

In situ observation of defect annihilation in Kr ion-irradiated bulk Fe/amorphous-Fe 2 Zr nanocomposite alloy

Enhanced irradiation tolerance in crystalline multilayers has received significant attention lately. However, little is known on the irradiation response of crystal/amorphous nanolayers. We report on in situ Kr ion irradiation studies of a bulk Fe 96 Zr 4 nanocomposite alloy. Irradiation resulted in amorphization of Fe 2 Zr and formed crystal/amorphous nanolayers. α-Fe layers exhibited drastically lower defect density and size than those in large α-Fe grains. In situ video revealed that mobile dislocation loops in α-Fe layers were confined by the crystal/amorphous interfaces and kept migrating to annihilate other defects. This study provides new insights on the design of irradiation-tolerant crystal/amorphous nanocomposites.

36 MATERIALS SCIENCE↗