Search NASA⌕ Search

Engineering topics

Li, Peng

Publications and source records attributed to Li, Peng.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
DOE OSTI2020

MPC-Based Local Voltage Control Strategy of DGs in Active Distribution Networks

The increasing penetration of distributed generators (DGs) exacerbates the voltage violations in active distribution networks (ADNs). The commonly used centralized voltage control may aggravate the burden of computation and communication. Local voltage control can realize fast response to frequent voltage fluctuations. However, effective local control for DGs still needs to be further investigated. In this paper, a model predictive control (MPC)-based local voltage control strategy of DGs is proposed to cope with voltage violation problems and enhance the adaptation to the DG volatility. DGs are regulated with local Q-V control curves to respond to voltage fluctuations rapidly. Based on the dynamic network partition, a unified control curve for DGs is set in the same area to realize efficient operation. To further improve the performance of voltage control, the parameter tuning of control curves is regularly conducted based on decentralized inter-area coordination with the rolling of the control horizon. Finally, case study is verified on the modified IEEE 33-node distribution system. The proposed local control strategy of DGs can effectively improve the voltage profile and reduce power losses of the whole network without high computation and communication burden.

active distribution network (ADN)↗
DOE OSTI2020

General approaches for shear-correcting coordinate transformations in Bragg coherent diffraction imaging. Part II

X-ray Bragg coherent diffraction imaging (BCDI) has been demonstrated as a powerful 3D microscopy approach for the investigation of sub-micrometre-scale crystalline particles. The approach is based on the measurement of a series of coherent Bragg diffraction intensity patterns that are numerically inverted to retrieve an image of the spatial distribution of the relative phase and amplitude of the Bragg structure factor of the diffracting sample. This 3D information, which is collected through an angular rotation of the sample, is necessarily obtained in a non-orthogonal frame in Fourier space that must be eventually reconciled. To deal with this, the approach currently favored by practitioners (detailed in Part I) is to perform the entire inversion in conjugate non-orthogonal real- and Fourier-space frames, and to transform the 3D sample image into an orthogonal frame as a post-processing step for result analysis. In this article, which is a direct follow-up of Part I, two different transformation strategies are demonstrated, which enable the entire inversion procedure of the measured data set to be performed in an orthogonal frame. The new approaches described here build mathematical and numerical frameworks that apply to the cases of evenly and non-evenly sampled data along the direction of sample rotation ( i.e. the rocking curve). The value of these methods is that they rely on the experimental geometry, and they incorporate significantly more information about that geometry into the design of the phase-retrieval Fourier transformation than the strategy presented in Part I. Finally, two important outcomes are (1) that the resulting sample image is correctly interpreted in a shear-free frame and (2) physically realistic constraints of BCDI phase retrieval that are difficult to implement with current methods are easily incorporated. Computing scripts are also given to aid readers in the implementation of the proposed formalisms.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Reticular exploration of uranium-based metal—organic frameworks with hexacarboxylate building units

We report that the rational reticular design of metal–organic frameworks (MOFs) from building units of known geometries is essential for enriching the diversity of MOF structures. Unexpected and intriguing structures, however, can also arise from subtle changes in the rigidity/length of organic linkers and/or synthetic conditions. Herein, we report three uranium-based MOF structures—i.e., NU-135X (X = 0, 1, 2)—synthesized from trigonal planar uranyl nodes and triptycene-based hexacarboxylate ligands with variable arm lengths. A new chiral 3,6-connected nuc net was observed in NU-1350, while the extended versions of the ligand led to 3-fold catenated MOFs (NU-1351 and NU-1352) with rare 3,6-connected cml-c3 nets. Lastly, the differences in the topology of NU-1350 and NU-1351/NU-1352 could be attributed to the slight distortions of the shorter linker in the former from the ideal trigonal prism geometry to an octahedral geometry when coordinated to the trigonal planar uranyl nodes.

3,6-connected net↗
DOE OSTI2020

Single-Crystal Polycationic Polymers Obtained by Single-Crystal-to-Single-Crystal Photopolymerization

The efficient preparation of single-crystalline ionic polymers and fundamental understanding of their structure–property relationships at the molecular level remains a challenge in chemistry and materials science. Herein, we observe the single-crystal structure of a highly ordered polycationic polymer (polyelectrolyte) and its proton conductivity. The polyelectrolyte single crystals can be prepared on a gram-scale in quantitative yield, by taking advantage of an ultraviolet/sunlight-induced topochemical polymerization, from a tricationic monomer—a self-complementary building block possessing a preorganized conformation. A single-crystal-to-single-crystal photopolymerization was revealed unambiguously by in situ single-crystal X-ray diffraction analysis, which was also employed to follow the progression of molecular structure from the monomer, to a partially polymerized intermediate, and, finally, to the polymer itself. Collinear polymer chains are held together tightly by multiple Coulombic interactions involving counterions to form two-dimensional lamellar sheets (1 nm in height) with sub-nanometer pores (5 Å). The polymer is extremely stable under 254 nm light irradiation and high temperature (above 500 K). The extraordinary mechanical strength and environmental stability—in combination with its impressive proton conductivity (~3 × 10 –4 S cm –1 )—endow the polymer with potential applications as a robust proton-conducting material. By marrying supramolecular chemistry with macromolecular science, the outcome represents a major step toward the controlled synthesis of single-crystalline polyelectrolyte materials with perfect tacticity.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2019

Growth of 2H stacked WSe 2 bilayers on sapphire

Bilayer WSe 2 nuclei were initially grown along the atomic steps of a sapphire substrate, resembling a “graphoepitaxial mechanism” and gradually formed into overlapped 2H stacked WSe 2 bilayers.

36 MATERIALS SCIENCE↗
DOE OSTI2019

Large Fermi surface expansion through anisotropic mixing of conduction and $\textit{f}$ electrons in the semimetallic Kondo lattice CeBi

Using angle-resolved photoemission spectroscopy (ARPES) and resonant ARPES, we report evidence of strong anisotropic conduction-$\textit{f}$ electron mixing ($\textit{c-f}$ mixing) in CeBi by observing a largely expanded Ce 5$d$ pocket at low temperature, with no change in the Bi-6$\textit{p}$ bands. We note the Fermi surface (FS) expansion is accompanied by a pronounced spectral weight transfer from the local 4$f^0$ peak of Ce (corresponding to Ce 3+ ) to the itinerant conduction bands near the Fermi level. Careful analysis suggests that the observed large FS change (with a volume expansion of the electron pocket up to 40%) can most naturally be explained by a small valence change (~1%) of Ce, which coexists with a very weak Kondo screening. Our work therefore provides evidence for a FS change driven by real charge fluctuations deep in the Kondo limit, which are made possible by the low carrier density. Our results highlight the large tunability of the FS in low carrier density Kondo systems.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2019

Ultrathin interfacial layer with suppressed room temperature magnetization in magnesium aluminum ferrite thin films

Low-damping magnetic oxide thin films with small thicknesses are essential for efficient insulator spintronic devices, particularly those driven by spin torque effects. Here, we investigate the depth-resolved compositional and magnetic properties of epitaxial spinel MgAl 0.5 Fe 1.5 O 4 (MAFO), which has recently been reported as a promising low-damping insulator. We find that ≈11nm films exhibit optimal Gilbert damping, with a typical damping parameter of 0.001. While defects due to strain relaxation in the bulk of the film contribute to increased damping for large film thickness, the damping increase in thinner films is attributed to the presence of a chemically disordered magnetic dead layer at the film/substrate interface. This interfacial dead layer arises from an Fe-deficient MAFO layer. Notably, this layer is only about one-sixth the thickness of that found at the interface between yttrium iron garnet films and gadolinium gallium garnet substrates, making MAFO an ideal thin-film insulator for spin-torque applications.

36 MATERIALS SCIENCE↗
DOE OSTI2019

Broadband Optical Detection Using the Spin Seebeck Effect

The generation, control, and detection of spin currents in solid-state devices are critical for Joule-heating minimization, spin-based computation, and electrical-energy generation from thermal gradients. Although incorporation of spin functionality into technologically important architectures is still in its infancy, advantages over all-electric devices are increasingly becoming clear. Here, we utilize the spin Seebeck effect (SSE) in Pt/Y 3 Fe 5 O 12 devices to detect light from 390 to 2200 nm. We find that the device responsivity is remarkably flat across this technologically important wavelength range, closely following the Pt absorption coefficient. As expected from a SSE-generation mechanism, we observe that the photovoltage and Pt heating dynamics are in strong agreement. To precisely determine the optically created thermal gradient produced from a pointlike heat source, we introduce a field-modulation method for measuring the SSE. Furthermore, our results show that broadband optical detection can be performed with devices based solely on spin-current generation and detection.

36 MATERIALS SCIENCE↗
DOE OSTI2019

Ambient Synthesis of Single‐Atom Catalysts from Bulk Metal via Trapping of Atoms by Surface Dangling Bonds

Abstract Single‐atom catalysts (SACs) feature the maximum atom economy and superior performance for various catalysis fields, attracting tremendous attention in materials science. However, conventional synthesis of SACs involves high energy consumption at high temperature, complicated procedures, a massive waste of metal species, and poor yields, greatly impeding their development. Herein, a facile dangling bond trapping strategy to construct SACs under ambient conditions from easily accessible bulk metals (such as Fe, Co, Ni, and Cu) is presented. When mixing graphene oxide (GO) slurry with metal foam and drying in ambient conditions, the M 0 would transfer electrons to the dangling oxygen groups on GO, obtaining M δ+ (0 < δ < 3) species. Meanwhile, M δ+ coordinates with the surface oxygen dangling bonds of GO to form MO bonds. Subsequently, the metal atoms are pulled out of the metal foam by the MO bonds under the assistance of sonication to give M SAs/GO materials. This synthesis at room temperature from bulk metals provides a versatile platform for facile and low‐cost fabrication of SACs, crucial for their mass production and practical application in diverse industrial reactions.

Qu, Yunteng↗
DOE OSTI2019

Magnetization switching using topological surface states

Topological surface states (TSSs) in a topological insulator are expected to be able to produce a spin-orbit torque that can switch a neighboring ferromagnet. This effect may be absent if the ferromagnet is conductive because it can completely suppress the TSSs, but it should be present if the ferromagnet is insulating. This study reports TSS-induced switching in a bilayer consisting of a topological insulator Bi 2 Se 3 and an insulating ferromagnet BaFe 12 O 19 . A charge current in Bi 2 Se 3 can switch the magnetization in BaFe 12 O 19 up and down. When the magnetization is switched by a field, a current in Bi 2 Se 3 can reduce the switching field by ~4000 Oe. The switching efficiency at 3 K is 300 times higher than at room temperature; it is ~30 times higher than in Pt/BaFe 12 O 19 . These strong effects originate from the presence of more pronounced TSSs at low temperatures due to enhanced surface conductivity and reduced bulk conductivity.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗
DOE OSTI2019

In Situ Formation of Unprecedented Neptunium-Oxide Wheel Clusters Stabilized in a Metal–Organic Framework

An isostructural series of Np(V) MOFs with shp -topology were synthesized and characterized. Xray diffraction data revealed an unusual wheel-shaped node of 18 neptunyl polyhedra stabilized in the framework. Strong distortion in local coordination of the neptunium atoms is evidenced by Np–Oyl bond lengths that lie outside the typical range for Np(V). As a result, the structure was further interrogated by Raman spectroscopy and density functional theory calculations to assign the vibrational modes.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗