Search NASA⌕ Search

Engineering topics

Li, R.

Publications and source records attributed to Li, R..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
DOE OSTI2019

Rydberg and autoionizing states of tellurium studied by laser resonance ionization spectroscopy

Multistep laser-resonance-ionization spectroscopy of tellurium (Te) has been performed at TRIUMF's off-line laser ion source test stand. Six clean and regular even-parity Rydberg series $5p^3$ ($^{4}S^0_{3/2}$) np $^{3}P_{ 0,1,2}$, n p $^{5}P_{1,2}$, and nf $^{3}F_{2}$/$^{5}P_{1,2}$ were observed. The ionization potential of Te was extracted from the measured series as 72669.110(44) stat (20) sys cm -1 . Excited from two different intermediate levels, seven odd-parity autoionization Rydberg series converging to the $5s^25p^3$ ($^{2}D^0_{3/2}$) core state of Te were obtained. Three of them are first time reported in the energy range of 92940 cm -1 .

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
NASA NTRS2019

The Changing Changing-Look AGN 1ES 1927+654

We report on X-ray follow-up observations of the March 2018 nuclear transient event AT2018zf (ASASSN-18el) from an ongoing campaign that includes XMM-Newton, NuSTAR, Swift, and high cadence (daily-to-weekly) NICER observations. The event was associated with the Seyfert galaxy 1ES 1927+654, a "True Type-2" that, nevertheless, showed an X-ray spectrum typical of an unobscured Type 1 AGN. Optical monitoring revealed the emergence of broad Balmer emission lines following the outburst, suggesting a transition from a Type 2 to a Type 1 AGN on timescales consistent with the light-travel time between the central black hole and the broad line region. The optical outburst was followed by a dramatic shift in the X-ray spectrum as the hard X-ray luminosity of the corona plunged by >2 orders of magnitude and the spectrum became dominated by a 10^6 K thermal component. The subsequent X-ray evolution of 1ES 1927+654 includes an additional two-order of magnitude decline in overall luminosity, followed by an extended period of quiescence, and re-brightening to levels that make it the brightest AGN currently in the X-ray sky. Throughout its evolution, the source has displayed X-ray flux variability of factors of several on timescales less than hour, and of ~100 on timescales less than a day. The X-ray spectrum varies along a consistent luminosity-dependent track, wherein increases in flux are accompanied by a spectral hardening. We seem to be witnessing the onset of an instability in the pre-existing AGN disc and corona, followed by a still-continuing re-emergence of the corona. If the initial transient is identified as the tidal disruption of a star, it is possible that this was the instigator of this unique behavior.

Loewenstein, M.↗
DOE OSTI2019

Microscopic nonequilibrium energy transfer dynamics in a photoexcited metal/insulator heterostructure

The element specificity of soft x-ray spectroscopy makes it an ideal tool for analyzing the microscopic origin of ultrafast dynamics induced by localized optical excitation in metal-insulator heterostructures. As such, using [Fe/MgO]$_n$ as a model system, we perform ultraviolet pump/soft x-ray probe experiments, which are sensitive to all constituents of these heterostructures, to probe both electronic and lattice excitations. Complementary ultrafast electron diffraction experiments independently analyze the lattice dynamics of the Fe constituent, and together with ab initio calculations yield comprehensive insight into the microscopic processes leading to local relaxation within a single constituent or nonlocal relaxation between two constituents. Besides electronic excitations in Fe, which are monitored at the Fe L 3 absorption edge and relax within 1 ps by electron-phonon coupling, soft x-ray analysis identifies a change at the oxygen K absorption edge of theMgO layers which occurs within 0.5 ps. This ultrafast energy transfer across the Fe-MgO interface is mediated by high-frequency, interface vibrational modes, which are excited by hot electrons in Fe and couple to vibrations in MgO in a mode-selective, nonthermal manner. A second, slower timescale is identified at the oxygen K pre-edge and the Fe L 3 edge. The slower process represents energy transfer by acoustic phonons and contributes to thermalization of the entire heterostructure. We thus find that the interfacial energy transfer is associated with nonequilibrium behavior in the phonon system. Because our experiments lack signatures of charge transfer across the interface, we conclude that phonon-mediated processes dominate the competition of electronic and lattice excitations in these nonlocal, nonequilibrium dynamics.

36 MATERIALS SCIENCE↗
DOE OSTI2019

Precision Plasmonics with Monomers and Dimers of Spherical Gold Nanoparticles: Nonequilibrium Dynamics at the Time and Space Limits

Monomers and dimers of spherical gold nanoparticles (NPs) exhibit highly uniform plasmonic properties at the single-particle level due to their high structural homogeneity (precision plasmonics). Recent investigations in precision plasmonics have largely focused on static properties using conventional techniques such as transmission electron microscopy and optical dark-field microscopy. Here in this Feature Article, we first highlight the application of femtosecond time-resolved electron diffraction for monitoring the nonequilibrium dynamics of spherical gold NPs after ultrafast optical excitation. The analysis of the transient diffraction patterns allows us to directly obtain quantitative information on the incoherent excitation of the lattice, that is, heating upon electron–lattice equilibration, as well as on the development of strain due to lattice expansion on picosecond time scales. The controlled assembly of two spherical gold NPs into a dimer with a few nanometers gap leads to unique optical properties. Specifically, extremely high electric fields (hot spot) in the gap are generated upon resonant optical excitation. Conventional optical microscopy cannot spatially resolve this unique hot spot due to the optical diffraction limit. We therefore employed nonlinear photoemission electron microscopy to visualize hot spots in single dimers of spherical gold NPs. A quantitative comparison of different single dimers confirms the homogeneity of the hot spots on the single-particle level. Finally, overall, these initial results are highly encouraging because they pave the way to investigate nonequilibrium dynamics in highly uniform plasmonic nanostructures at the time and space limits.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2019

Instrumentation for In situ/Operando X-ray Scattering Studies of Polymer Additive Manufacturing Processes

With new opportunities and challenges from additive manufacturing (AM), novel characterization approaches are needed to realize reliable and industry-transferrable material systems and processes. The Complex Scattering Program at the National Synchrotron Light Source II (NSLS-II), a Department of Energy (DOE) Office of Science User Research Facility located at Brookhaven National Laboratory, has capabilities on three beamlines to support in situ and operando soft material additive manufacturing measurements. In this article, we describe some of the additive manufacturing capabilities that have been implemented on these beamlines, including in-line 3D printers for Continuous-flow Direct Writing (CDW), Fused Filament Fabrication (FFF) printing, and an instrument for Electrospray Deposition (ESD). We also describe a development program in autonomous experimentation that will be critical for addressing the complexity involved in optimizing additive manufacturing processes and materials.

36 MATERIALS SCIENCE↗
DOE OSTI2018

Transition from the twinning induced plasticity to the γ-ε transformation induced plasticity in a high manganese steel

Neutron-diffraction investigation on the deformation of a Fe-18Mn-3Si-0.6C-0.4Al steel reveals that the twinning is mainly dominant at a stress below 900 MPa, above which the twinning behavior is largely outweighed by phase transformation from the face-centered-cubic (FCC) γ-austenite to the hexagonal-close-packed (HCP) ε-martensite. In the deformed grains, the distribution of ε-martensite is parallel with the twin boundary. Both the well-known {111} γ //{0001} ε relationship and an additional {111} γ //{11–21} ε orientation relation were identified. After the phase transformation, both phases deformed further with the lattice rotating around an axis perpendicular to the tensile direction. Transition from the twinning dominant behavior to the phase transformation induced plasticity effect is explained by the grain orientation dependence of the effective stacking fault energy (ESFE). An asymmetric and inverse relationship between the width of stacking faults (SF) and the ESFE is obtained from the density functional theory (DFT). The tensile stress always increases proportionally with the SF width in the twinning favorable grains and thus a decreasing ESFE. The replacement of twinning activities by phase transformation could be due to both the nucleation site of ε-martensite at the SF of the twin boundary and the decrease of the ESFE in grains which originally favors the twinning.

Materials Science↗
DOE OSTI2018

Studies of CSR and Microbunching at Jefferson Laboratory ERLs

One attractive feature of energy recovery linacs (ERLs) is they are source limited. However as beam brightness increases so too do the effects of coherent synchrotron radiation (CSR) and the microbunching instability. The Low Energy Recirculator Facility at Jefferson Laboratory provides a test bed to characterize aspects of CSR's effect on the beam by measuring the energy extraction via CSR as a function of bunch compression. Data was recorded with acceleration occurring on the rising part of the RF waveform while the full compression point was moved along the backleg of the machine and the response of the beam measured. Acceleration was moved to the falling part of the RF waveform and the experiment repeated. Initial start-to-end simulations using a 1D CSR model show good agreement with measurements. The experiment motivated the design of a modified Continuous Electron Beam Accelerator Facility-style arc with control of CSR and the microbunching gain. Insights gained from that study informed designs for recirculation arcs in an ERL-driven electron cooler for Jefferson Laboratory's Electron Ion Collider. Progress on the design and outstanding challenges of the cooler are discussed.

Tennant, C.↗
DOE OSTI2017

The in-depth residual strain heterogeneities due to an indentation and a laser shock peening for Ti-6Al-4V titanium alloy

In this paper, heterogeneity of the through-thickness residual strain due to the laser shock peening (LSP) in comparison with that due to the indentation was studied in Ti-6Al-4V alloy samples. The latter is almost a quasi-static process while the former features extremely high strain-rate deformation. The synchrotron based high-energy X-ray diffraction was employed to investigate the through-thickness residual strain distribution. The studied two samples after the two processing procedures share the following features: (i) the pressure affected depths are both ~2 mm and (ii) the largest magnitudes of the compressive residual strains parallel to the surface are ~4,000 με. However, the pit depth for the indentation sample is ~9 times larger than that for the LSP. The position featuring the largest magnitude of the compressive residual strain is in the sub-surface for the indentation while it is in the surface for the LSP. Results of the elastic-visco-plastic finite element simulation for the indentation indicate that the position featuring the maximum accumulative plastic shear as defined in this paper corresponds to the location with the largest magnitude of compressive residual strain. To validate this finding, full width at half maximum (FWHM) of the X-ray diffraction profile, which is proportional to the level of the plastic deformation, is also studied. Finally, it is found that positions with the largest FWHM indeed correspond to the largest magnitude of compressive residual strain for both tests.

36 MATERIALS SCIENCE↗
DOE OSTI2017

Plasma channel undulator excited by high-order laser modes

The possibility of utilizing plasma undulators and plasma accelerators to produce compact ultraviolet and X-ray sources, has attracted considerable interest for a few decades. This interest has been driven by the great potential to decrease the threshold for accessing such sources, which are mainly provided by a few dedicated large-scale synchrotron or free-electron laser (FEL) facilities. However, the broad radiation bandwidth of such plasma devices limits the source brightness and makes it difficult for the FEL instability to develop. Here in this paper, using multi-dimensional particle-in-cell (PIC) simulations, we demonstrate that a plasma undulator generated by the beating of a mixture of high-order laser modes propagating inside a plasma channel, leads to a few percent radiation bandwidth. The strength of the undulator can reach unity, the period can be less than a millimeter, and the number of undulator periods can be significantly increased by a phase locking technique based on the longitudinal tapering. Polarization control of such an undulator can be achieved by appropriately choosing the phase of the modes. According to our results, in the fully beam loaded regime, the electron current in the plasma undulator can reach 0.3 kA level, making such an undulator a potential candidate towards a table-Top FEL.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
DOE OSTI2016

Surface-plasmon enhanced photoemission of a silver nano-patterned photocathode

Here, nano-patterned photocathodes (NPC) take advantage of plasmonic effects to resonantly increase absorption of light and localize electromagnetic field intensity on metal surfaces leading to surface-plasmon enhanced photoemission. In this paper, we report the status of NPC research at UCLA including in particular the optimization of the dimensions of a nanohole array on a silver wafer to enhance plasmonic response at 800 nm light, the development of a spectrally-resolved reflectivity measurement setup for quick nanopattern validation, and of a novel cathode plug to enable high power tests of NPCs on single crystal substrates in a high gradient radiofrequency gun.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
NASA NTRS2014

Ancient Aqueous Environments at Endeavour Crater, Mars

Opportunity has investigated in detail rocks on the rim of the Noachian age Endeavour crater, where orbital spectral reflectance signatures indicate the presence of Fe(+3)-rich smectites. The signatures are associated with fine-grained, layered rocks containing spherules of diagenetic or impact origin. The layered rocks are overlain by breccias, and both units are cut by calcium sulfate veins precipitated from fluids that circulated after the Endeavour impact. Compositional data for fractures in the layered rocks suggest formation of Al-rich smectites by aqueous leaching. Evidence is thus preserved for water-rock interactions before and after the impact, with aqueous environments of slightly acidic to circum-neutral pH that would have been more favorable for prebiotic chemistry and microorganisms than those recorded by younger sulfate-rich rocks at Meridiani Planum.

Research Support, U.S. Gov't, Non-P.H.S.↗