Engineering topics
Li, Rui
Publications and source records attributed to Li, Rui.
Carbon sequestration of steel slag and carbonation for activating RO phase
Carbonation of Ca/Mg minerals in industrial alkaline residues is a technology to sequester CO{sub 2} and reduce its emissions to the atmosphere. In this work, BSE-EDS were used to determine the mineral phase in steel slag; compositions of RO phase were identified and simulated. The carbon sequestration of steel slag was studied, and RO phase was activated by carbonation. Result shows that the amount of CO{sub 2} sequestered in steel slag and RO phase increases as carbonation time increases. Under autoclaving condition, the hydration ratio of MgO in RO phase was 20.10%. Through carbonation, up to 58.83% of MgO in RO phase can be converted into MgCO{sub 3}, and the activation of RO phase by carbonation was manifested. The mechanical properties and volume stability of carbonated steel slag were improved, proving that the positive effect of carbonation on steel slag when applied in cement and cementitious materials.
Magnetocaloric Effect in a Frustrated Gd-Garnet with No Long-Range Magnetic Order
Abstract not provided
Numerical study of the convective heat transfer coefficient of the hand and the effect of wind
Not Available
MCBI in an Electron-Ion Collider
The luminosity performance for an electron-ion collider demands high-current operation for both the electron and ion beams, for a wide range of collision energies. This poses many challenges on the beam stability with regard to collective effects. In this paper, we present preliminary estimations of coherent instabilities for both of the EIC designs, i.e., JLEIC and eRHIC. Mitigation mechanisms or schemes envisioned for suppression of the instabilities are also discussed.
Application of consumer RGB-D cameras for fruit detection and localization in field: A critical review
Not Available
Statistics of the NiCoCr medium-entropy alloy: Novel aspects of an old puzzle
Abstract We study the K -state phenomenon in the NiCoCr medium-entropy alloy using first-principles techniques jointly with the efficient Wang–Landau Monte Carlo and simulated annealing algorithms. Our theoretical results successfully explain the existence of the peak around 940 K in the experimental specific heat curve that characterizes the K -state phenomenon and give a fine picture of its atomic origin. The peak is caused by the maximum change of the local configurations characterized by the short-range-order (SRO) parameters at that temperature. The maximum change in SRO parameters is dominated by the nearest-neighbor interactions of atoms but substantially tuned by the many-body interactions. One surprising aspect revealed by the reciprocal-space SRO parameters is that the Ni–Co pair distribution is not random even above the ordering transition temperature, dramatically different from Ni–Cr and Co–Cr, indicating the system cannot be treated as a pseudo binary alloy. This prototypical example shows the complicated nature of multicomponent alloys, different from binary alloys. Our methods can be directly used to study the important K -state phenomenon observed in a number of other composition-concentrated alloys regardless of their number of components.
Non-OH Chemistry in Oxidation Flow Reactors for the Study of Atmospheric Chemistry Systematically Examined by Modeling
Oxidation flow reactors (OFRs) using low-pressure Hg lamp emission at 185 and 254 nm produce OH radicals efficiently and are widely used in atmospheric chemistry and other fields. However, knowledge of detailed OFR chemistry is limited, allowing speculation in the literature about whether some non-OH reactants, including several not relevant for tropospheric chemistry, may play an important role in these OFRs. These non-OH reactants are UV radiation, O(1D), O(3P), and O3. In this study, we investigate the relative importance of other reactants to OH for the fate of reactant species in OFR under a wide range of conditions via box modeling. The relative importance of non-OH species is less sensitive to UV light intensity than to relative humidity (RH) and external OH reactivity (OHRext), as both non-OH reactants and OH scale roughly proportional to UV intensity. We show that for field studies in forested regions and also the urban area of Los Angeles, reactants of atmospheric interest are predominantly consumed by OH. We find that O(1D), O(3P), and O3 have relative contributions to VOC consumption that are similar or lower than in the troposphere. The impact of O atoms can be neglected under most conditions in both OFR and troposphere. Under pathological OFR conditions of low RH and/or high OHRext, the importance of non-OH reactants is enhanced because OH is suppressed. Some biogenics can have substantial destructions by O3, and photolysis at non-tropospheric wavelengths (185 and 254 nm) may also play a significant role in the degradation of some aromatics under pathological conditions. Working under low O2 with the OFR185 mode allows OH to completely dominate over O3 reactions even for the biogenic species most reactive with O3. Non-tropospheric VOC photolysis may have been a problem in some laboratory and source studies, but can be avoided or lessened in future studies by diluting source emissions and working at lower precursor concentrations in lab studies, and by humidification. SOA photolysis is shown to be insignificant for most functional groups, except for nitrates and especially aromatics, which may be photolyzed at high UV flux settings. Our work further establishes the OFR's usefulness as a tool to study atmospheric chemistry and enables better experiment design and interpretation, as well as improved future reactor design.
Non-OH Chemistry in Oxidation Flow Reactors for the Study of Atmospheric Chemistry Systematically Examined by Modeling
Oxidation flow reactors (OFRs) using low-pressure Hg lamp emission at 185 and 254 nm produce OH radicals efficiently and are widely used in atmospheric chemistry and other fields. However, knowledge of detailed OFR chemistry is limited, allowing speculation in the literature about whether some non-OH reactants, including several not relevant for tropospheric chemistry, may play an important role in these OFRs. These non-OH reactants are UV radiation, O(1D), O(3P), and O3. In this study, we investigate the relative importance of other reactants to OH for the fate of reactant species in OFR under a wide range of conditions via box modeling. The relative importance of non-OH species is less sensitive to UV light intensity than to relative humidity (RH) and external OH reactivity (OHRext), as both non-OH reactants and OH scale roughly proportional to UV intensity. We show that for field studies in forested regions and also the urban area of Los Angeles, reactants of atmospheric interest are predominantly consumed by OH. We find that O(1D), O(3P), and O3 have relative contributions to VOC consumption that are similar or lower than in the troposphere. The impact of O atoms can be neglected under most conditions in both OFR and troposphere. Under pathological OFR conditions of low RH and/or high OHRext, the importance of non-OH reactants is enhanced because OH is suppressed. Some biogenics can have substantial destructions by O3, and photolysis at non-tropospheric wavelengths (185 and 254 nm) may also play a significant role in the degradation of some aromatics under pathological conditions. Working under low O2 with the OFR185 mode allows OH to completely dominate over O3 reactions even for the biogenic species most reactive with O3. Non-tropospheric VOC photolysis may have been a problem in some laboratory and source studies, but can be avoided or lessened in future studies by diluting source emissions and working at lower precursor concentrations in lab studies, and by humidification. SOA photolysis is shown to be insignificant for most functional groups, except for nitrates and especially aromatics, which may be photolyzed at high UV flux settings. Our work further establishes the OFR's usefulness as a tool to study atmospheric chemistry and enables better experiment design and interpretation, as well as improved future reactor design.
Evidence of Mineral Dust Altering Cloud Microphysics and Precipitation
Multi-platform and multi-sensor observations are employed to investigate the impact of mineral dust on cloud microphysical and precipitation processes in mesoscale convective systems. It is clearly evident that for a given convection strength,small hydrometeors were more prevalent in the stratiform rain regions with dust than in those regions that were dust free. Evidence of abundant cloud ice particles in the dust sector, particularly at altitudes where heterogeneous nucleation process of mineral dust prevails, further supports the observed changes of precipitation. The consequences of the microphysical effects of the dust aerosols were to shift the precipitation size spectrum from heavy precipitation to light precipitation and ultimately suppressing precipitation.
Unsteady Aerodynamic Response of a Linear Cascade of Airfoils in Separated Flow
The overall objective of this research program was to investigate methods to modify the leading edge separation region, which could lead to an improvement in aeroelastic stability of advanced airfoil designs. The airfoil section used is representative of current low aspect ratio fan blade tip sections. The experimental potion of this study investigated separated zone boundary layer from removal through suction slots. Suction applied to a cavity in the vicinity of the separation onset point was found to be the most effective location. The computational study looked into the influence of front camber on flutter stability. To assess the influence of the change in airfoil shape on stability the work-per-cycle was evaluated for torsion mode oscillations. It was shown that the front camberline shape can be an important factor for stabilizing the predicted work-per-cycle and reducing the predicted extent of the separation zone. In addition, data analysis procedures are discussed for reducing data acquired in experiments that involve periodic unsteady data. This work was conducted in support of experiments being conducted in the NASA Glenn Research Center Transonic Flutter Cascade. The spectral block averaging method is presented. This method is shown to be able to account for variations in airfoil oscillation frequency that can occur in experiments that force oscillate the airfoils to simulate flutter.