Electronic Impurity Doping of a 2D Hybrid Lead Iodide Perovskite by Bi and Sn
Not Available
Engineering topics
Publications and source records attributed to Li, Tianyang.
Not Available
Two-dimensional (2D) hybrid organic-inorganic perovskites consisting of alternating organic and inorganic layers are a new class of layered structures. They have attracted increasing interest for photovoltaic, optoelectronic, and thermoelectric applications, where knowing their thermal transport properties is critical. In this study, we carry out both experimental and computational studies on thermal transport properties of 2 D butylammonium lead iodide crystals and find their thermal conductivity is ultralow (below 0.3 W m( -1 ) K -1 ) with very weak anisotropy (around 1.5) among layered crystals. Further analysis reveals that the unique structure with the preferential alignment of organic chains and complicated energy landscape leads to moderately smaller phonon lifetimes in the out-of-plane direction and comparable phonon group velocities in in-plane and out-of-plane directions. These new findings may guide the future design of novel hybrid materials with desired thermal conductivity for various applications.
Perovskite solar cells have received substantial attention due to their potential for low-cost photovoltaic devices on flexible or rigid substrates. Thiocyanate (SCN)-containing additives, such as MASCN (MA = methylammonium), have been shown to control perovskite film crystallization and the film microstructure to achieve effective room-temperature perovskite absorber processing. Nevertheless, the crystallization pathways and mechanisms of perovskite formation involved in MASCN additive processing are far from clear. Using in situ X-ray diffraction and photoluminescence, we investigate the crystallization pathways of MAPbI 3 and reveal the mechanisms of additive-assisted perovskite formation during spin coating and subsequent N 2 drying. In this work, we confirm that MASCN induces large precursor aggregates in solution and, during spin coating, promotes the formation of the perovskite phase with lower nucleation density and overall larger initial nuclei size, which forms upon reaching supersaturation in solution, in addition to intermediate solvent-complex phases. Finally, during the subsequent N 2 drying, MASCN facilitates the dissociation of these precursor aggregates and the solvate phases, leading to further growth of the perovskite crystals. Our results show that the nature of the intermediate phases and their formation/dissociation kinetics determine the nucleation and growth of the perovskite phase, which subsequently impact the film microstructure. These findings provide mechanistic insights underlying room-temperature, additive-assisted perovskite processing and help guide further development of such facile room-temperature synthesis routes.
Incorporating chiral organic molecules into organic/inorganic hybrid 2D-layered metal-halide perovskites results in a novel family of chiral hybrid semiconductors with unique spin-dependent properties. The embedded chiral organic moieties induce a chiroptical response from the inorganic metal-halide sublattice. However, the structural interplay between the chiral organic molecules and the inorganic sublattice, as well as their synergic effect on the resulting electronic band structure need to be explored in a broader material scope. Here we present three new layered tin iodide perovskites templated by chiral ( R/S -)methylbenzylammonium ( R/S -MBA), i.e. ( R-/S -MBA) 2 SnI 4 , and their racemic phase ( rac -MBA) 2 SnI 4 . These MBA 2 SnI 4 compounds exhibit the largest level of octahedral bond distortion compared to any other reported layered tin iodide perovskite. The incorporation of chiral MBA cations leads to circularly polarized absorption from the inorganic Sn–I sublattice, displaying chiroptical activity in the 300–500 nm wavelength range. The bandgap and chiroptical activity are modulated by alloying Sn with Pb, in the series of (MBA) 2 Pb 1-x Sn x I 4 . Finally, we show that vertical charge transport through oriented ( R-/S -MBA) 2 SnI 4 thin films is highly spin-dependent, arising from a chiral-induced spin selectivity (CISS) effect. We demonstrate a spin-polarization in the current-voltage characteristics as high as 94%. Our work shows the tremendous potential of these chiral hybrid semiconductors for controlling both spin and charge degrees of freedom.
In a quest for Pb-free perovskites suitable for solar energy applications, Cs 2 TiBr 6 has recently been reported as a promising compound, with appropriate optical and electrical properties as well as high stability under environmental stresses. In this study, we pursue investigation on this compound, demonstrating phase pure Cs 2 TiBr 6 powder formation using solution synthesis and providing complementary experimental characterization and theoretical calculations. An experimental absorption onset of around 2.0 eV is extracted and a weak broad photoluminescence is measured. Density functional theory calculations predict an indirect bandgap, parity-forbidden for both the direct and indirect transitions, which explains the weak and Stokes shifted luminescence. Additionally, we highlight the strong instability of Cs 2 TiBr 6 powder in ambient atmosphere. Therefore, our experimental results supported by theoretical calculations differ from previous results and raise doubts on the suitability of Cs 2 TiBr 6 in its pristine form for solar energy applications.
Hybrid organic-inorganic lead halide perovskites have shown promising results as active layers in light-emitting diodes, typically utilizing the near-monochromatic, free exciton emission. Some perovskite compounds, however, show broad-band emission that is more intense than the free exciton counterpart. In this study, we show that the light emission properties of Ruddlesden-Popper hybrid perovskites PEA 2 MA n-1 Pb n I 3n+1 (PEA = phenethylammonium, MA = methylammonium) can be tuned by Sn alloying and are highly sensitive to Sn %. With increasing dimensionality, the broad-band emission quantum yield decreases drastically, from 23% in n = 1 to <1% for the n = 3 compound. Using density functional theory calculations and transient reflectance spectroscopy, the broad emission is identified as originating from self-trapped excitons. A dynamic picture of the formation process is also presented, for which ultrafast (<5 ps) hole-trapping at the Sn site is the first step, followed by electron localization from Coulombic interaction. These findings are particularly valuable for designing perovskite materials with intense room-temperature broad-band emission for solid-state lighting applications.
The separation of refined silicon from Al-Si alloys through a solvent refining process was studied. Purified silicon particles were separated by air pressure filtration using stainless steel sieves as the filtration media. After the efficient removal of impurities in the refining process, the effects of the mesh number (N), separation temperature (T), silicon content in the alloy (ω{sub (a)}), and pressure differential (p) on the separation efficiency were evaluated. At N = 80, T = 873 K (600 °C), ω{sub (a)} = 45 wt pct and p = 0.25 MPa, the recovery rate of refined silicon was 98.2 pct, and the residual aluminum in the separated silicon was less than 8 wt pct. The separation process was efficient when N = 60 to 150. It was advisable for the separation temperature to approach the eutectic temperature. Efficient filtration could be achieved when ω{sub (a)} = 35 to 55 wt pct. The filtration efficiency was improved with a higher pressure differential, and the separation was efficient at p ≥ 0.10 MPa. The results show that air pressure filtration is a promising method to separate refined silicon.
Not Available
Lead-free antimony-based mixed sulfide and iodide perovskite phases have recently been reported to be synthesized experimentally and to exhibit reasonable photovoltaic performance. In this work, through a combination of experimental validation and computational analysis, we show no evidence of the formation of the mixed sulfide and iodide perovskite phase, MASbSI 2 (MA = CH 3 NH 3 + ), and instead that the main products are a mixture of the binary and ternary compounds (Sb 2 S 3 and MA 3 Sb 2 I 9 ). Density functional theory calculations also indicate that such a mixed sulfide and iodide perovskite phase should be thermodynamically less stable compared with binary/ternary anion-segregated secondary phases and less likely to be synthesized under equilibrium conditions. Additionally, band structure calculations show that this mixed sulfide and iodide phase, if possible to synthesize (e.g., under nonequilibrium conditions), should have a suitable direct band gap for photovoltaic application.
CH 3 NH 3 PbI 3 films with micrometer grains and microsecond carrier lifetimes are prepared through additive engineering.