Engineering topics

Lin, J. G.

Publications and source records attributed to Lin, J. G..

4 records

NASA NTRS1991

Stability of Y-Ba-Cu-oxide phases in salt flux

The results of an investigation into the possibility of growing YBa2Cu3O7 (or Y123) single crystals from a NaCl-KCl flux (salt flux) are presented. They are compared with results for Y123 crystals grown from a Ba-Cu-oxide flux system. The chosen salt flux composition was 1:1 (NaCl:KCl). The preparation method of the solutes is presented, with particular attention given to the compounds surrounding the Y123 phase, such as Y2BaCuO6 (Y211). Optical microscopy was introduced to study the morphology of the sample; X-ray diffraction was used for phase identification; and a chemical analysis was effected. The Y123, Y211, and BaCuO2 phases were shown to be dissociated in the NaCl-KCl flux, and could not be recrystallized. A small amount of the flux could be added to create large-grain Y123 crystals, but single-crystal growth was not possible in a top-seeded NaCl-KCl solution. This is attributed to significant differences in solubility of the crystal elements, and phase separation caused by CuO crystal formation.

Tao, Y. K.↗

NASA NTRS1986

Rapid torque-limited line-of-sight pointing of SCOLE (Spacecraft Control Laboratory Experiment) configuration

The design concept of a control for rapid torque-limited slewing of a rigid-mast version of the NASA SCOLE configuration is presented and demonstrated by means of numerical simulation. The time-optimal control problem for the system is decomposed into separate single-axis problems, expanding analytically the implicit nonlinear transcendental expression for the SCOLE line-of-sight error, and the final Euler attitude angles and slew angles are determined. The simulation results are presented in tables and graphs, and it is found that bang-bang or bang-pause-bang slew maneuvers with control moment applied to the Shuttle and control force applied to the reflector, and with a 5-deg/s slew-rate limit, produce the best pointing accuracy and the shortest slew times, although the specified line-of-sight error of 0.02 deg cannot be achieved using such open-loop single-axis maneuvers.

Lin, J. G.↗

NASA NTRS1985

Time-optimal bang-bang slew of rigidized SCOLE configuration

This paper addresses: (1) an application of the well-known time-optimal bang-bang control theory to the design of minimal-time limited-torque single-axis slew maneuvers for the rigidized configuration of NASA Langley Research Center's Spacecraft Control Laboratory Experiment (SCOLE) and (2) the associated generic side effects due to spillover of slew motions and applied torques. Numerical experiments that helped pinpoint the specific causes of performance degradation are discussed. Analytical as well as scientifically interesting numerical research results are given.

Lin, J. G.↗

NASA NTRS1980

An improved output feedback control of flexible large space structures

A special output feedback control design technique for flexible large space structures is proposed. It is shown that the technique will increase both the damping and frequency of selected modes for more effective control. It is also able to effect integrated control of elastic and rigid-body modes and, in particular, closed-loop system stability and robustness to modal truncation and parameter variation. The technique is seen as marking an improvement over previous work concerning large space structures output feedback control.

Lin, Y. H.↗