Engineering topics

Lin, T. L.

Publications and source records attributed to Lin, T. L..

41 records · Page 3

NASA NTRS1988

Room-temperature codeposition growth technique for pinhole reduction in epitaxial CoSi2 on Si (111)

A solid-phase epitaxy has been developed for the growth of CoSi2 films on Si (111) with no observable pinholes (1000/sq cm detection limit). The technique utilizes room-temperature codeposition of Co and Si in stoichiometric ratio, followed by the deposition of an amorphous Si capping layer and subsequent in situ annealing at 550-600 C. CoSi2 films grown without the Si cap are found to have pinhole densities of (1-10) x 10 to the 7th/sq cm when annealed at similar temperatures. A CF4 plasma-etching technique was used to increase the visibility of the pinholes in the silicide layer.

Lin, T. L.↗

NASA NTRS1988

Transmission electron microscopy study of the formation of epitaxial CoSi2/Si (111) by a room-temperature codeposition technique

Co and Si have been codeposited on Si (111) substrates near room temperature in a stoichiometric 1:2 ratio in a molecular beam epitaxy system. Annealing of these deposits yields high-quality single-crystal CoSi2 layers. Transmission electron microscopy has been used to examine as-deposited layers and layers annealed at 300, 500, and 600 C. Single-crystal epitaxial grains of CoSi2 embedded in a matrix of amorphous Co/Si are observed in as-deposited samples, while the layer is predominantly single-crystal, inhomogeneously strained CoSi2 at 300 C. At 600 C, a homogeneously strained single-crystal layer with a high density of pinholes is observed. In contrast to other solid phase epitaxy techniques used to grow CoSi2 on Si (111), no intermediate silicide phases are observed prior to the formation of CoSi2.

D'Anterroches, Cecile↗

NASA NTRS1988

Nucleation and growth of CrSi2 on Si(111)

The nucleation and growth of CrSi2 on Si(111) by MBE and solid-phase epitaxy (SPE), was investigated using SEM and TEM observations of 2-mm-thick layers grown under a variety of conditions, including the use of a CoSi2 buffer. During growth, the wafers were monitored in situ using reflection high-energy electron diffraction. Island growth was observed, with islands found to nucleate with three epitaxial orientations. The morphology of CrSi2 islands was found to be affected by the degree and direction of substrate misorientation, the growth technique, and the use of CoSi2 buffer. However, the reconstruction of the Si surface does not appear to be an important factor in controlling SPE growth.

Fathauer, R. W.↗

NASA NTRS1987

Growth and characterization of molecular beam epitaxial GaAs layers on porous silicon

GaAs layers have been grown on porous silicon (PS) substrates with good crystallinity by molecular beam epitaxy. In spite of the surface irregularity of PS substrates, no surface morphology deterioration was observed on epitaxial GaAs overlayers. A 10-percent Rutherford backscattering spectroscopy minimum channeling yield for GaAs-on-PS layers as compared to 16 percent for GaAs-on-Si layers grown under the same condition indicates a possible improvement of crystallinity when GaAs is grown on PS. Transmission electron microscopy reveals that the dominant defects in the GaAs-on-PS layers are microtwins and stacking faults, which originate from the GaAs/PS interface. GaAs is found to penetrate into the PS layers. n-type GaAs/p-type PS heterojunction diodes were fabricated with good rectifying characteristics.

Lin, T. L.↗

NASA NTRS1984

Numerical analysis of some problems related to the mechanics of pneumatic tires: Finite deformation/rolling contact of a viscoelastic cylinder and finite deformation of cord-reinforced rubber composites

The formulation and numerical analysis of several problems related to the behavior of pneumatic tires are considered. These problems include the general rolling contact problem of a rubber-like viscoelastic cylinder undergoing finite deformations and the finite deformation of cord-reinforced rubber composites. New finite element models are developed for these problems. Numerical results obtained for several representative cases are presented.

Oden, J. T.↗