UAVSAR G-III Precision Autopilot Overview and Results
This viewgraph presentation gives a general overview of the Uninhabited Aerial Vehicle Synthetic Aperture Radar (UAVSAR) G-III precision autopilot.
Lin, Victor↗
Engineering topics
Lin, Victor
Publications and source records attributed to Lin, Victor.
G-III Precision Autopilot Development in Support of UAVSAR Program
The primary objective of the UAVSAR Project is to develop a miniaturized polarimetric L-band synthetic aperture radar (SAR) for use on an unmanned aerial vehicle (UAV) or minimally piloted vehicle. Five Cycle 1 precision autopilot flights have been completed as of May 14, 2007. The first flight was open-loop controller, the second, third, fourth, and fifth flights were closed loop. The fifth flight demonstrated increasing duration within ten meter tube (approximately 90% of the time in the ten meter tube over a 200km course).
Lee, James↗
Autonomous Soaring
A guidance and control method was developed to detect and exploit thermals for energy gain. Latency in energy rate estimation degraded performance. The concept of a UAV harvesting energy from the atmosphere has been shown to be feasible with existing technology. Many UAVs have similar mission constraints to birds and sailplanes. a) Surveillance; b) Point to point flight with minimal energy; and c) Increased ground speed.
Lin, Victor↗
G-III Precision Autopilot Development in Support of UAVSAR Program
This viewgraph presentation reviews NASA Dryden's role in the UAVSAR Program. The primary objective of the UAVSAR Project is to develop a miniaturized polarimetric L-band synthetic aperture radar (SAR) for use on an unmanned aerial vehicle (UAV) or minimally piloted vehicle. Dryden's work in developing the Platform Precision Autopilot (PPA) capability is described in this presentation. The goal for the development is that the PPA shall fly the G-III within a 10 m (32.8 ft) diameter tube for at least 90% of each data take in conditions of calm to light atmospheric disturbances, as defined. The G-III aircraft is descrbed, the test plan is outlined, and the initial test results are reviewed.
Lee, James↗
Guidance and Control of an Autonomous Soaring UAV
Thermals caused by convection in the lower atmosphere are commonly used by birds and glider pilots to extend flight duration, increase cross-country speed, improve range, or simply to conserve energy. Uninhabited Aerial Vehicles (UAVs) can also increase performance and reduce energy consumption by exploiting atmospheric convection. An autonomous soaring research project was conducted at the NASA Dryden Flight Research Center to evaluate the concept through flight test of an electric-powered motorglider with a wingspan of 4.27 m (14 ft). The UAV's commercial autopilot software was modified to include outer-loop soaring guidance and control. The aircraft total energy state was used to detect and soar within thermals. Estimated thermal size and position were used to calculate guidance commands for soaring flight. Results from a total of 23 thermal encounters show good performance of the guidance and control algorithms to autonomously detect and exploit thermals. The UAV had an average climb of 172 m (567 ft) during these encounters.
Allen, Michael J.↗