Engineering topics

Lin, Yuze

Publications and source records attributed to Lin, Yuze.

5 records

DOE OSTI2023

Sensitive photodetection below silicon bandgap using quinoid-capped organic semiconductors

High-sensitivity organic photodetectors (OPDs) with strong near-infrared (NIR) photoresponse have attracted enormous attention due to potential applications in emerging technologies. However, few organic semiconductors have been reported with photoelectric response beyond ~1.1 μm, the detection limit of silicon detectors. Here, we extend the absorption of organic small-molecule semiconductors to below silicon bandgap, and even to 0.77 eV, through introducing the newly designed quinoid-terminals with high Mulliken-electronegativity (5.62 eV). The fabricated photodiode-type NIR OPDs exhibit detectivity (D*) over 10 12 Jones in 0.41 to 1.2 μm under zero bias with a maximum of 2.9 × 10 12 Jones at 1.02 μm, which is the highest D* for reported OPDs in photovoltaic-mode with response spectra beyond 1.1 μm. The high D* in 0.9 to 1.2 μm is comparable to those of commercial InGaAs photodetectors, despite the detection limit of our OPDs is shorter than InGaAs (~1.7 μm). A spectrometer prototype with a wide measurable region (0.4 to 1.25 μm) and NIR imaging under 1.2-μm illumination are demonstrated successfully in OPDs.

36 MATERIALS SCIENCE↗

DOE OSTI2022

Two‐Dimensional Polycyclic Photovoltaic Molecule with Low Trap Density for High‐Performance Photocatalytic Hydrogen Evolution

Abstract Typical organic semiconductors show a high trap density of states (10 16 –10 18 cm −3 ), providing a large number of centers for charge‐carrier recombination, thus hindering the development of photocatalytic hydrogen evolution. Here, we design and synthesize a two‐dimensional polycyclic photovoltaic material, named as TPP, to reduce the trap density to as low as 2.3×10 15 cm −3 , which is 1–3 orders of magnitude lower than those of typical organic semiconductors. Moreover, TPP exhibits a broad and strong absorption, ordered molecular packing with a large crystalline coherence length and enhanced electron mobility. Then, the bulk heterojunction nanoparticles (BHJ‐NPs) based on a blend of polymer donor (PM6) and TPP exhibit an average hydrogen evolution rate (HER) of 64.31 mmol h −1 g −1 under AM1.5G sunlight (100 mW cm −2 ), and 72.75 mmol h −1 g −1 under 330–1100 nm illumination (198 mW cm −2 ) higher than that of the control NPs based on typical PM6 : Y6 (62.67 mmol h −1 g −1 ).

Zhang, Zhenzhen↗

DOE OSTI2021

Two-Dimensional Polycyclic Photovoltaic Molecule with Low Trap Density for High-Performance Photocatalytic Hydrogen Evolution

Typical organic semiconductors show a high trap density of states (10 16 –10 18 cm -3 ), providing a large number of centers for charge-carrier recombination, thus hindering the development of photocatalytic hydrogen evolution. In this report we design and synthesize a two-dimensional polycyclic photovoltaic material, named as TPP, to reduce the trap density to as low as 2.3×10 15 cm -3 , which is 1–3 orders of magnitude lower than those of typical organic semiconductors. Moreover, TPP exhibits a broad and strong absorption, ordered molecular packing with a large crystalline coherence length and enhanced electron mobility. Then, the bulk heterojunction nanoparticles (BHJ-NPs) based on a blend of polymer donor (PM6) and TPP exhibit an average hydrogen evolution rate (HER) of 64.31 mmol h -1 g -1 under AM1.5G sunlight (100,mW cm -2 ), and 72.75 mmol h -1 g -1 under 330–1100 nm illumination (198 mW cm -2 ) higher than that of the control NPs based on typical PM6 : Y6 (62.67 mmol h -1 g -1 ).

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2021

Crystallization in one-step solution deposition of perovskite films: Upward or downward?

Despite the fast progress of perovskite photovoltaic performances, understanding the crystallization and growth of perovskite films is still lagging. One unanswered fundamental question is whether the perovskite films are grown from top (air side) to bottom (substrate side) or from bottom to top despite 10 years of development. Here, by using grazing incidence x-ray diffraction and morphology characterizations, we unveil that the perovskite films prepared by one-step solution processes, including antisolvent-assisted spin coating and blade coating, follow the downward growth from intermediate phase during thermal annealing. Such a top-to-bottom downward growth is initialized by the evaporation of residual solvent from the top surface of “wet” films and is less sensitive to perovskite compositions and the wettability of underlying substrates. Addressing this fundamental question is important to understand the heterogeneity of perovskite films along the vertical direction, which markedly affects the efficiency and stability of perovskite solar cells.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Simplified interconnection structure based on C 60 /SnO 2-x for all-perovskite tandem solar cells

The efficiencies of all-perovskite tandem devices are improving quickly. However, their complex interconnection layer (ICL) structures – with typically four or more layers deposited by different processes – limit their prospects for applications. Here, we report an ICL in all-perovskite tandem cells consisting merely of a fullerene layer and a SnO 2-x (0 60 layer is unintentionally n-doped by iodine ions from the perovskite and thus acts as an effective electron collecting layer. The SnO 2-x layer, formed by the incomplete oxidization of tin (x=1.76), has ambipolar carrier transport property enabled by the presence of a large density of Sn 2+ . The C 60 /SnO 1.76 ICL forms Ohmic contacts with both wide and narrow bandgap perovskite subcells with low contact resistivity. The ICL boosts the efficiencies of small-area tandem cells (5.9 mm 2 ) and large-area tandem cells (1.15 cm 2 ) to 24.4% and 22.2%, respectively. Lastly, the tandem cells remain 94% of its initial efficiency after continues 1-sun illumination for 1,000 hours.

14 SOLAR ENERGY↗