Search NASA⌕ Search

Engineering topics

Lindahl, John M

Publications and source records attributed to Lindahl, John M.

Infrared Preheating to Enhance Interlayer Strength of Components Printed on the Big Area Additive Manufacturing (BAAM) System

The Big Area Additive Manufacturing (BAAM) system has the capacity to print structures on the order of several meters at a rate exceeding 50 kg/h, thereby having the potential to significantly impact the production of components in automotive, aerospace and energy sectors. However, a primary issue that limits the functional use of such parts is mechanical anisotropy. The strength of printed parts across successive layers in the build direction (z-direction) is significantly lower than the corresponding in-plane strength (x-y directions). This is largely due to poor bonding between the printed layers as the lower layers cool below the glass transition temperature (Tg) before the next layer is deposited. This work explores the use of infrared heating to increase the surface temperature of the printed layer just prior to deposition of new material to improve the interlayer strength of the components. The material used in this study was acrylonitrile butadiene styrene (ABS) reinforced with 20% chopped carbon fiber by weight. Significant improvements in z-strength were observed for the parts whose surface temperature was increased from below Tg to close to or above Tg using infrared heating. Parameters such as print speed, nozzle diameter and extrusion temperature were also found to impact the heat input required to enhance interlayer adhesion without significantly degrading the polymer and compromising on surface finish.

Kishore, Vidya↗

INVESTIGATION OF IN-AUTOCLAVE ADDITIVE MANUFACTURING COMPOSITE TOOLING

The autoclave is a crucial piece of equipment for fabricating Tier 1 polymer composite aerospace structural components with very low void content (i.e. < 5 %). The essential component in this composite manufacturing process is the rigid mold that defines the final shape of the fabricated composite component. The Big Area Additive Manufacturing (BAAM) system located at Oak Ridge National Laboratory s (ORNL) Manufacturing Demonstration Facility (MDF) has been used to manufacture a new generation of in-autoclave tools that can be used to fabricate various aerospace composite parts. Different tools made form Polyphenylene sulfide (PPS) with 50 % by weight carbon fiber and Polyphenylsulfone (PPSU) with 25 % carbon fiber are investigated in this study. The behavior of the printed tools under different temperature ramp rates for the autoclave cycles was observed and analyzed.

Kunc, Vlastimil↗