Search NASA⌕ Search

Engineering topics

Lisabeth, Harrison

Publications and source records attributed to Lisabeth, Harrison.

Concurrent measurement of strain and chemical reaction rates in a calcite grain pack undergoing pressure solution: Evidence for surface-reaction controlled dissolution

Pressure solution is inferred to be a significant contributor to sediment compaction and lithification, especially in carbonate sediments. For a sediment deforming primarily by pressure solution, the compaction rate should be directly related to the rate of calcite dissolution, transport along grain contacts, and calcite reprecipitation. Previous experimental work has shown that there is evidence that deformation in wet calcite grain packs is consistent with control by pressure solution, but considerable ambiguity remains regarding the rate limiting mechanism. We present the results of laboratory compaction experiments designed to directly measure calcite dissolution and precipitation rates (recrystallization rates) concurrently with strain rate to test whether measured rates are consistent with predicted rates both in absolute magnitude and time evolution. Recrystallization rates are measured using trace element chemistry (Sr/Ca, Mg/Ca) and isotopes (87Sr/86Sr) of fluids flowing slowly through a compacting grain pack as it is being triaxially compressed. Imaging techniques are used to characterize the grain contacts and strain effects in the post-experiment grain pack. Our data show that calcite recrystallization rates calculated from all three geochemical parameters are in approximate agreement and that the rates closely track strain rate. The geochemically inferred rates are close to predicted rates in absolute magnitude. Uncertainty in grain contact dimensions makes distinguishing between surface reaction control and diffusion control difficult. Measured reaction rates decrease faster than predicted from standard pressure solution creep flow laws. This inconsistency may indicate that calcite dissolution rates at grain contacts are more complex, and more time-dependent, than suggested by geometric models designed to predict grain contact stresses.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Calcite Twinning in Mollusk Shells and Carrara Marble

Mollusk shells protect the animals that form and inhabit them. They are composites of minerals and organics, with diverse mesostructures, including nacre, prismatic calcite, crossed-lamellar aragonite, and foliated calcite. Twins, that is, crystals mirror symmetric with respect to their coherent interface, occurring as formation or deformation twins, are observed in all mollusk shell mesostructures but never within calcite prisms. Here, nanotwins and microwins within single calcite prisms are observed in different shells. Using Polarization-dependent Imaging Contrast (PIC) mapping with 20–60 nm resolution, twins are observed to be 0.2–3 µm thick layers of differently oriented and colored crystals with respect to the main prism crystal. Multiple twins are interspersed with the prism crystal, parallel to one another, and similarly oriented. When comparing images of calcite prisms and twins obtained by PIC mapping and by Electron Back-Scattered Diffraction (EBSD), the images correspond precisely. All twins are e-twin types, with 127° angular distance between c-axes. E-twins are the most common deformation twins in geologic calcite, as also observed here in Carrara marble. Location of all twins near the outer surface of all shells and e-twin type both suggest that twins within calcite prisms in mollusk shells result from deformation twinning.

36 MATERIALS SCIENCE↗

Analysis of time-dependent strain heterogeneity in shales using X-ray microscopy and digital volume correlation

In this paper, we report the results of a 4-dimensional (3 spatial dimensions plus time) in-situ creep experiment on a milli-core shale plug from Barnett formation in Texas. An outstanding challenge in shale mechanics is connecting observable characteristics to predictable mechanical and hydraulic behavior. We employ novel imaging and analysis techniques to statistically link sample mineralogy and structure to observed deformation. In particular, we focus on mechanisms of porosity reduction during transient response to step changes in stress, analogous to the aseismic deformation that occurs after an episode of fracturing. Our main goal in this study is to take the first steps to visualize and capture the small-scale deformation mechanisms involved in creep of shales, using imaging techniques. To do so, we conducted a uniaxial creep experiment inside an Xradia Versa 520 micro-CT system for 12 h at room temperature under a constant uniaxial stress of 25 MPa. We employed a Digital Volume Correlation (DVC) method to measure micro-scale deforspmation of the sample by comparing the resulting volumetric images with a high-resolution scan of the sample obtained prior to the creep experiment. The results indicate that the time-dependent deformation in the compliant clay plus kerogen matrix constituents facilitates rigid grain rotation and compaction of intergranular porosity at the boundary between rigid grains and matrix.

58 GEOSCIENCES↗

Dissolution-Assisted Pattern Formation During Olivine Carbonation

Olivine and pyroxene bearing rocks in the oceanic crust react with hydrothermal fluids producing changes in the physical characteristics and behaviors of the altered rocks. Notably, these reactions tend to increase solid volume, reducing pore volume, permeability and available reactive surface area; yet, entirely hydrated and/or carbonated rocks are commonly observed in the field. We investigate the evolution of porosity and permeability of fractured dunites reacted with CO 2 -rich solutions in laboratory experiments. The alteration of crack surfaces changes the mechanical and transport properties of the bulk samples. Analysis of three-dimensional microstructural data shows that although precipitation of secondary minerals causes the total porosity of the sample to decrease, an interconnected network of porosity is maintained through channelized dissolution and coupled carbonate precipitation. Lastly, the observed microstructure appears to be the result of chemo-mechanical coupling, which may provide a mechanism of porosity maintenance without the need to invoke reaction-driven cracking.

58 GEOSCIENCES↗

Geo-Chemo-Mechanical Studies for Permanent CO 2 Storage in Geologic Reservoirs

This two-pronged study investigated the rates and mechanisms of formation of Ca and Mg carbonate minerals via reaction of aqueous fluids with silicate minerals and rocks, and the geomechanical effects of such reactions. The kinetic studies focused on the separation of variables, following from previous studies demonstrating rapid formation of carbonates via reaction of the mineral olivine with aqueous fluids rich in NaHCO 3 (plus KHCO 3 and RbHCO 3 ) and NaCl at a high partial pressure of CO 2 . We wished to separate and quantify the effects of NaHCO 3 and NaCl, and to investigate whether bicarbonate-rich, aqueous fluids would also cause rapid formation of carbonates via reaction with other minerals and rocks. Further, we wished to improve upon previous work by adding precise characterization of grain size distributions and surface area, and their changes as a result of reaction. We confirmed previous reports of very rapid olivine carbonation. We found that at a given temperature and CO 2 partial pressure the previously observed rate enhancement in olivine carbonation is due mainly to NaHCO 3 , and not to dissolved NaCl. Further, though reaction of the mineral plagioclase, and two rock compositions, were all faster in the presence of NaHCO 3 -rich fluids, compared with saline and de-ionized water, they were all much slower than reaction of olivine. In the experiments showing the fastest reaction rate, average grain size tended to increase during experiments, presumably due to dissolution of small reactant grains plus growth of product phases on reactant surfaces. Porosity/surface area of grains tended to change with reaction progress, due to the formation of dissolution pits and irregular growth of product phases on reactant grain surfaces. Development of a passivating phase (e.g., a layer of silica) due to incongruent dissolution of solid reactants and/or precipitation of solid products was detected, but was relatively minor and did not have a discernable effect on reaction progress. Geomechanical experiments did not identify pressure-temperature-composition conditions under which porous olivine aggregates undergo reaction driven cracking. Little carbonate formed in these experiments. Though we fulfilled the milestones for this project, a variety of reasons for this remain to be investigated in the future. Reaction of porous olivine aggregates with brines rich in NaHCO 3 caused substantial weakening of samples in compression, due to formation of dissolution pits along olivine-olivine grain boundaries, reducing the solid-solid surface area. A preliminary modeling study funded in part by this grant emphasized potential rate enhancements due to reaction-driven cracking. In related research, not funded by this grant, several additional experimental and modeling studies of reaction-driven cracking are underway.

54 ENVIRONMENTAL SCIENCES↗