Search NASA⌕ Search

Engineering topics

Liu, Na

Publications and source records attributed to Liu, Na.

11 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Experimental investigation into coal wettability changes caused by reactions with scCO 2 -H 2 O

Geological CO 2 sequestration (GCS) can help mitigate global warming and enhance methane recovery from coal beds. However, few studies have linked the effects of CO 2 to surface chemistry changes controlling wetting behavior in deep coal beds. Contact angles (CAs) of CO 2 /N 2 -high volatile bituminous coal-water systems were measured under different temperatures and pressures. The surface chemistry and physical structure of coals were characterized to investigate changes in physicochemical properties and their relations with wettability after reactions. For N 2 treatment, the time-dependence of static and dynamic CAs were insignificant, ranging within 4°. For gaseous CO 2 treatment, the static CAs and the average advancing angles increased slightly. With supercritical (sc) CO 2 , both the static and dynamic CAs increased significantly, and θ adv changed to intermediate-wet (92°). Reactions with minerals exposed to scCO 2 resulted in greater surface roughness and heterogeneity, greater contact angle hysteresis and more surface sites occupied by scCO 2 rather than H 2 O. Increases in hydrophobic functional groups and decreases in hydrophilicity were shown by FTIR spectra, reflecting the shedding of polar oxygen-containing functional groups, reduction of hydrogen bonds, and increasing percentage of hydrocarbons. XRD patterns obtained following scCO 2 -treatment showed that crystallite growth and molecular polymerization were higher toward graphite-like. The calculated structural parameters of functional groups and crystallites both showed elevated coal rank. Changes in crystallite structure, notably higher carbon content and decreased negative surface charge, are unfavorable for water-wetting. Finally, this study contributes to understanding surface chemistry changes responsible for decreased wettability during CO 2 -enhanced coal bed methane recovery and GCS in coal reservoirs.

01 COAL, LIGNITE, AND PEAT↗
DOE OSTI2024

Broadband and Tunable Microwave Absorption Properties from Large Magnetic Loss in Ni–Zn Ferrite

Highly effective electromagnetic (EM) wave absorber materials with strong reflection loss (RL) and a wide absorption bandwidth (EBW) in gigahertz (GHz) frequencies are crucial for advanced wireless applications and portable electronics. Traditional microwave absorbers lack magnetic loss and struggle with impedance matching, while ferrites are stable, exhibit excellent magnetic and dielectric losses, and offer better impedance matching. However, achieving the desired EBW in ferrites remains a challenge, necessitating further composition design. In this study, impedance matching is successfully enhanced and EBW in Ni–Zn ferrite is broadened by successive doping with Mn and Co , without incorporation of any polymer filler. It is found that Ni 0.4 Co 0.1 Zn 0.5 Fe 1.9 Mn 0.1 O 4 material exhibits exceptional EM wave absorption, with a maximum RL of −48.7 dB. It also featured a significant EBW of 10.8 GHz, maintaining a 90% absorption rate (RL < −10 dB) for a thickness of 4.5 mm. These outstanding properties result from substantial magnetic losses and favorable impedance matching. These findings represent a significant step forward in the development of microwave absorber materials, addressing EM wave pollution concerns within GHz frequencies, including the frequency band used in popular 5G technology.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Half-Heusler alloys as emerging high power density thermoelectric cooling materials

Abstract To achieve optimal thermoelectric performance, it is crucial to manipulate the scattering processes within materials to decouple the transport of phonons and electrons. In half-Heusler (hH) compounds, selective defect reduction can significantly improve performance due to the weak electron-acoustic phonon interaction. This study utilized Sb-pressure controlled annealing process to modulate the microstructure and point defects of Nb 0.55 Ta 0.40 Ti 0.05 FeSb compound, resulting in a 100% increase in carrier mobility and a maximum power factor of 78 µW cm −1 K −2 , approaching the theoretical prediction for NbFeSb single crystal. This approach yielded the highest average zT of ~0.86 among hH in the temperature range of 300-873 K. The use of this material led to a 210% enhancement in cooling power density compared to Bi 2 Te 3 -based devices and a conversion efficiency of 12%. These results demonstrate a promising strategy for optimizing hH materials for near-room-temperature thermoelectric applications.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Toward High Conversion Efficiency of Thermoelectric Modules through Synergistical Optimization of Layered Materials

Abstract Waste‐heat electricity generation using high‐efficiency solid‐state conversion technology can significantly decrease dependence on fossil fuels. Here, a synergistical optimization of layered half‐Heusler (hH) materials and module to improve thermoelectric conversion efficiency is reported. This is realized by manufacturing multiple thermoelectric materials with major compositional variations and temperature‐gradient‐coupled carrier distribution by one‐step spark plasma sintering. This strategy provides a solution to overcome the intrinsic concomitants of the conventional segmented architecture that only considers the matching of the figure of merit ( zT ) with the temperature gradient. The current design is dedicated to temperature‐gradient‐coupled resistivity and compatibility matching, optimum zT matching, and reducing contact resistance sources. By enhancing the quality factor of the materials by Sb‐vapor‐pressure‐induced annealing, a superior zT of 1.47 at 973 K is achieved for (Nb, Hf)FeSb hH alloys. Along with the low‐temperature high‐ zT hH alloys of (Nb, Ta, Ti, V)FeSb, the single stage layered hH modules are developed with efficiencies of ≈15.2% and ≈13.5% for the single‐leg and unicouple thermoelectric modules, respectively, under Δ T of 670 K. Therefore, this work has a transformative impact on the design and development of next‐generation thermoelectric generators for any thermoelectric material families.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗
DOE OSTI2021

A constitutive model incorporating grain refinement strengthening on metallic alloys

Surface nano-crystallization techniques have been recently developed as one of the most efficient ways to optimize materials’ structure, and therefore develop the local and global mechanical behavior as to increase strength without compromising ductility. Here, in this work, we present a constitutive model incorporating grain refinement hardening to simulate the nano-crystallization technique, specifically, surface mechanical attrition treatment. The computation is implemented using user-defined VUMAT subroutines. As an example of its application, a geometry model with full coverage of random impacts are employed. The results show that the model has rather precise predictability of grain size evolution during plastic deformation. The readily embedded with a computational code of material dynamics enables this novel model to be a promising tool to study the dynamic evolution of microstructures under plastic deformation.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Enabling room temperature ferromagnetism in monolayer MoS2 via in situ iron-doping

Abstract Two-dimensional semiconductors, including transition metal dichalcogenides, are of interest in electronics and photonics but remain nonmagnetic in their intrinsic form. Previous efforts to form two-dimensional dilute magnetic semiconductors utilized extrinsic doping techniques or bulk crystal growth, detrimentally affecting uniformity, scalability, or Curie temperature. Here, we demonstrate an in situ substitutional doping of Fe atoms into MoS 2 monolayers in the chemical vapor deposition growth. The iron atoms substitute molybdenum sites in MoS 2 crystals, as confirmed by transmission electron microscopy and Raman signatures. We uncover an Fe-related spectral transition of Fe:MoS 2 monolayers that appears at 2.28 eV above the pristine bandgap and displays pronounced ferromagnetic hysteresis. The microscopic origin is further corroborated by density functional theory calculations of dipole-allowed transitions in Fe:MoS 2 . Using spatially integrating magnetization measurements and spatially resolving nitrogen-vacancy center magnetometry, we show that Fe:MoS 2 monolayers remain magnetized even at ambient conditions, manifesting ferromagnetism at room temperature.

36 MATERIALS SCIENCE↗