Engineering topics

Liu, Sandy R.

Publications and source records attributed to Liu, Sandy R..

5 records

NASA NTRS1991

Acoustic predictions using measured pressures from a model rotor in the DNW

A contemporary design, 4-bladed United Technologies model rotor with pressure-instrumented blades was tested in the Duits-Nederslandse Windtunnel. Simultaneous acoustic and pressure measurements were made for a wide range of operating conditions. Microphones were optimally positioned at a number of locations in the flow forward of the rotor to measure rotor thickness noise, high-speed impulsive noise (both in the rotor plane), and blade-vortex interaction noise (forward and 25 deg below the rotor plane). The blade surface pressure data are used as aerodynamic input to WOPWOP, which is a state-of-the-art rotor noise prediction program that predicts rotor thickness and loading noise. The predicted results using WOPWOP are compared to the measured noise levels for cases where either thickness noise, blade-vortex interaction noise, or high-speed impulsive noise is the dominant noise mechanism. The comparisons show regions of good agreement, as well as areas where further improvement is necessary.

Visintainer, Joseph A.↗

NASA NTRS1990

The acoustic results of a United Techologies scale model helicopter rotor tested at DNW

An initial summary is presented of the acoustic measurements acquired for some of the different configurations of a 1/6 geometrically and aeroelastically scaled UTC model helicopter rotor which was tested in the open-jet anechoic test section of the Duits-Nederlandse Windtunnel in the Netherlands. Of particular interest are high-speed impulsive noise and blade-vortex interaction. An analysis is provided of baseline swept tip rotor acoustic characteristics in the regimes of high-speed forward flight, where high-speed impulsive noise dominates, and low-speed descent, where severe blade vortex interaction noise occurs. Also discussed are more recent studies of data which involve the animation of the acoustic field upstream of the rotor to evaluate the detailed radiation patters caused by BVI and HSI noise sources. The trends of these primary noise sources are examined as the first step in validating the data for release and application.

Liu, Sandy R.↗

NASA NTRS1990

The acoustic results of a United Technologies scale model helicopter rotor tested at DNW

In a major cooperative program between U.S. Government agencies (represented by the U.S. Army Aeroflightdynamics Directorate and NASA Ames and Langley Research Centers) and United Technologies Corp., a 1/6 geometrically and aeroelastically scaled UTC model helicopter rotor was tested in the open-jet anechoic test section of the Duits-Nederlandse Windtunnel in the Netherlands. As the fourth entry under the Aerodynamic and Acoustic Testing of Model Rotors Program, several comprehensive acoustic and aerodynamic databases were obtained relating the important aerodynamic phenomena to both the near- and far-field acoustic radiation. In particular, high speed impulsive noise and blade-vortex interaction are of primary interest. This paper provides an initial summary of the acoustic measurements acquired for some of the different configurations tested. A review of the baseline swept tip rotor acoustic characteristics in the regimes of high speed forward flight, where high speed impulsive noise dominates, and low speed descent, where severe blade vortex interaction noise occurs, is presented. The trends of these primary noise sources are studied as the first step in validating the data for release and application.

Liu, Sandy R.↗

NASA NTRS1990

Aerodynamic and acoustic test of a United Technologies model scale rotor at DNW

The UTC model scale rotors, the DNW wind tunnel, the AFDD rotary wing test stand, the UTRC and AFDD aerodynamic and acoustic data acquisition systems, and the scope of test matrices are discussed and an introduction to the test results is provided. It is pointed out that a comprehensive aero/acoustic database of several configurations of the UTC scaled model rotor has been created. The data is expected to improve understanding of rotor aerodynamics, acoustics, and dynamics, and lead to enhanced analytical methodology and design capabilities for the next generation of rotorcraft.

Yu, Yung H.↗

NASA NTRS1987

Prediction of blade-vortex interaction noise using measured blade pressures

In the study reported here, blade-vortex interaction noise was predicted using a simplified model of blade pressures measured on a one-seventh scale model AH-1/OLS main rotor. The methods used for the acoustic prediction are based on the acoustic analogy and have been developed by Nakamura (1981) and by Brentner, Nystrom, and Farassat (referred to as the WOPWOP method). The waveforms predicted by the two methods are in good agreement with each other and with the measurements in terms of the number of pulses, the pulse widths, and the separation times between the pulses. The peak amplitude of the dominant pulse may, however, be underpredicted by up to 40 percent, depending on flight conditions. Ways of improving the accuracy of the prediction methods are suggested.

Joshi, Mahendra C.↗