Protecting Perovskite Solar Cells against Moisture-Induced Degradation with Sputtered Inorganic Barrier Layers
Not Available
37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
Engineering topics
Liyanage, Geethika K.
Publications and source records attributed to Liyanage, Geethika K..
Back-Surface Passivation of CdTe Solar Cells Using Solution-Processed Oxidized Aluminum
Although back-surface passivation plays an important role in high-efficiency photovoltaics, it has not yet been definitively demonstrated for CdTe. Here, we present a solution-based process, which achieves passivation and improved electrical performance when very small amounts of oxidized Al 3+ species are deposited at the back surface of CdTe devices. The open circuit voltage (V oc ) is increased and the fill factor (FF) and photoconversion efficiency (PCE) are optimized when the total amount added corresponds to ~1 monolayer, suggesting that the passivation is surface specific. Addition of further Al 3+ species, present in a sparse alumina-like layer, causes the FF and PCE to drop as the interface layer becomes blocking to current flow. The optimized deposit increases the average baseline PCE for both Cu-free devices and devices where Cu is present as a dopant. The greatest improvement is found when the Al 3+ species are deposited prior to the CdCl 2 activation step and Cu is employed. In this case, the best-cell efficiency was improved from 12.6 to 14.4%. Furthermore, time-resolved photoluminescence measurements at the back surface and quantum efficiency measurements performed at the maximum power point indicate that the performance enhancement is due to a reduction in the interface recombination current at the back surface.
14 SOLAR ENERGY↗
Understanding and Advancing Bifacial Thin Film Solar Cells
Because bifacial solar cells increase the power generated per area, their market share is projected to increase over the next decade. While silicon technologies have implemented bifacial technology, little progress has occurred in bifacial thin film (BTF) solar cells. Understanding the factors that limit performance is critical to advancing BTF cells. We show that recombination at the back interface has limited device performance of fabricated BTF devices. Improved BTF performance will require decreasing recombination at the back interface, through passivation or by reducing downward band-bending at this interface. Increasing carrier lifetimes improves performance, but increasing hole density has little effect.
14 SOLAR ENERGY↗