Engineering topics

Long, Lyle N.

Publications and source records attributed to Long, Lyle N..

14 records

NASA NTRS2002

Numerical Simulations for Landing Gear Noise Generation and Radiation

Aerodynamic noise from a landing gear in a uniform flow is computed using the Ffowcs Williams -Hawkings (FW-H) equation. The time accurate flow data on the surface is obtained using a finite volume flow solver on an unstructured and. The Ffowcs Williams-Hawkings equation is solved using surface integrals over the landing gear surface and over a permeable surface away from the landing gear. Two geometric configurations are tested in order to assess the impact of two lateral struts on the sound level and directivity in the far-field. Predictions from the Ffowcs Williams-Hawkings code are compared with direct calculations by the flow solver at several observer locations inside the computational domain. The permeable Ffowcs Williams-Hawkings surface predictions match those of the flow solver in the near-field. Far-field noise calculations coincide for both integration surfaces. The increase in drag observed between the two landing gear configurations is reflected in the sound pressure level and directivity mainly in the streamwise direction.

Morris, Philip J.↗

NASA NTRS2002

Computational Analysis of a Prototype Martian Rotorcraft Experiment

This paper presents Reynolds-averaged Navier-Stokes calculations for a prototype Martian rotorcraft. The computations are intended for comparison with an ongoing Mars rotor hover test at NASA Ames Research Center. These computational simulations present a new and challenging problem, since rotors that operate on Mars will experience a unique low Reynolds number and high Mach number environment. Computed results for the 3-D rotor differ substantially from 2-D sectional computations in that the 3-D results exhibit a stall delay phenomenon caused by rotational forces along the blade span. Computational results have yet to be compared to experimental data, but computed performance predictions match the experimental design goals fairly well. In addition, the computed results provide a high level of detail in the rotor wake and blade surface aerodynamics. These details provide an important supplement to the expected experimental performance data.

Corfeld, Kelly J.↗

NASA NTRS2001

Computational Analysis of a Prototype Martian Rotorcraft Experiment

Corfeld, Kelly J.↗

NASA NTRS2000

Self-Scheduling Parallel Methods for Multiple Serial Codes with Application to WOPWOP

This paper presents a scheme for efficiently running a large number of serial jobs on parallel computers. Two examples are given of computer programs that run relatively quickly, but often they must be run numerous times to obtain all the results needed. It is very common in science and engineering to have codes that are not massive computing challenges in themselves, but due to the number of instances that must be run, they do become large-scale computing problems. The two examples given here represent common problems in aerospace engineering: aerodynamic panel methods and aeroacoustic integral methods. The first example simply solves many systems of linear equations. This is representative of an aerodynamic panel code where someone would like to solve for numerous angles of attack. The complete code for this first example is included in the appendix so that it can be readily used by others as a template. The second example is an aeroacoustics code (WOPWOP) that solves the Ffowcs Williams Hawkings equation to predict the far-field sound due to rotating blades. In this example, one quite often needs to compute the sound at numerous observer locations, hence parallelization is utilized to automate the noise computation for a large number of observers.

Long, Lyle N.↗

NASA NTRS1999

Summary of Research Report

This report describes a project to predict ducted fan noise using massively parallel computers. The investigators are part of a larger team of researchers, most of whom are working at NASA Langley Research Center. The portion of the project described below not only stands alone as an individual research project, it also compliments the NASA Langley work. The write-up included in this report is relatively brief, since the details are described in technical papers.

Long, Lyle N.↗

NASA NTRS1997

Solution of Aeroacoustic Problems by a Nonlinear, Hybrid Method

Category 1, problem 3 (scattering of sound by a sphere) and category 2, problem 1 (spherical source in a cylindrical duct subject to uniform flow) are solved in generalized coordinates using the nonlinear Euler equations together with nonreflecting boundary conditions. A temporally and spatially fourth-order accurate finite-difference, Runge-Kutta time-marching technique is employed for the near-field calculations and a Kirchhoff method is employed for the prediction of far-field sound. Computations are all performed on parallel processors using the data-parallel paradigm.

Oezyoeruek, Yusuf↗

NASA NTRS1996

Computational aeroacoustics and numerical simulation of supersonic jets

The research project has been a computational study of computational aeroacoustics algorithms and numerical simulations of the flow and noise of supersonic jets. During this study a new method for the implementation of solid wall boundary conditions for complex geometries in three dimensions has been developed. In addition, a detailed study of the simulation of the flow in and noise from supersonic circular and rectangular jets has been conducted. Extensive comparisons have been made with experimental measurements. A summary of the results of the research program are attached as the main body of this report in the form of two publications. Also, the report lists the names of the students who were supported by this grant, their degrees, and the titles of their dissertations. In addition, a list of presentations and publications made by the Principal Investigators and the research students is also included.

Morris, Philip J.↗

NASA NTRS1995

Application of traditional CFD methods to nonlinear computational aeroacoustics problems

This paper describes an implementation of a high order finite difference technique and its application to the category 2 problems of the ICASE/LaRC Workshop on Computational Aeroacoustics (CAA). Essentially, a popular Computational Fluid Dynamics (CFD) approach (central differencing, Runge-Kutta time integration and artificial dissipation) is modified to handle aeroacoustic problems. The changes include increasing the order of the spatial differencing to sixth order and modifying the artificial dissipation so that it does not significantly contaminate the wave solution. All of the results were obtained from the CM5 located at the Numerical Aerodynamic Simulation Laboratory. lt was coded in CMFortran (very similar to HPF), using programming techniques developed for communication intensive large stencils, and ran very efficiently.

Chyczewski, Thomas S.↗

NASA NTRS1995

Time accurate application of the MacCormack 2-4 scheme on massively parallel computers

Many recent computational efforts in turbulence and acoustics research have used higher order numerical algorithms. One popular method has been the explicit MacCormack 2-4 scheme. The MacCormack 2-4 scheme is second order accurate in time and fourth order accurate in space, and is stable for CFL's below 2/3. Current research has shown that the method can give accurate results but does exhibit significant Gibbs phenomena at sharp discontinuities. The impact of adding Jameson type second, third, and fourth order artificial viscosity was examined here. Category 2 problems, the nonlinear traveling wave and the Riemann problem, were computed using a CFL number of 0.25. This research has found that dispersion errors can be significantly reduced or nearly eliminated by using a combination of second and third order terms in the damping. Use of second and fourth order terms reduced the magnitude of dispersion errors but not as effectively as the second and third order combination. The program was coded using Thinking Machine's CM Fortran, a variant of Fortran 90/High Performance Fortran, and was executed on a 2K CM-200. Simple extrapolation boundary conditions were used for both problems.

Hudson, Dale A.↗

NASA NTRS1995

Computational aeroacoustics on massively parallel computers

A computational fluid dynamics (CFD) technique is employed to solve aeroacoustics problems on massively parallel computers. The algorithm is based on a 4th order accurate central finite difference and 4th order accurate 4-stage Runge-Kutta time integration method that solves the 3-D full Navier-Stokes/Euler equations on a curvilinear coordinate system. The code has been developed to predict noise radiation from ducted fans. A specific application of this code is made here to the oscillating circular piston problem (Workshop Category 4, Problem 2) by solving the full Euler equations with nonreflecting boundary conditions in the axisymmetric mode. The features of the code that apply to this particular problem are described in this paper.

Oezyoeruek, Yusuf↗

NASA NTRS1993

Prediction of forces and moments for hypersonic flight vehicle control effectors

This research project includes three distinct phases. For completeness, all three phases of the work are briefly described in this report. The goal was to develop methods of predicting flight control forces and moments for hypersonic vehicles which could be used in a preliminary design environment. The first phase included a preliminary assessment of subsonic/supersonic panel methods and hypersonic local flow inclination methods for such predictions. While these findings clearly indicated the usefulness of such methods for conceptual design activities, deficiencies exist in some areas. Thus, a second phase of research was conducted in which a better understanding was sought for the reasons behind the successes and failures of the methods considered, particularly for the cases at hypersonic Mach numbers. This second phase involved using computational fluid dynamics methods to examine the flow fields in detail. Through these detailed predictions, the deficiencies in the simple surface inclination methods were determined. In the third phase of this work, an improvement to the surface inclination methods was developed. This used a novel method for including viscous effects by modifying the geometry to include the viscous/shock layer.

Maughmer, Mark D.↗

NASA NTRS1991

Prediction of forces and moments for hypersonic flight vehicle control effectors

Developing methods of predicting flight control forces and moments for hypersonic vehicles, included a preliminary assessment of subsonic/supersonic panel methods and hypersonic local flow inclination methods for such predictions. While these findings clearly indicate the usefulness of such methods for conceptual design activities, deficiencies exist in some areas. Thus, a second phase of research was proposed in which a better understanding is sought for the reasons of the successes and failures of the methods considered, particularly for the cases at hypersonic Mach numbers. To obtain this additional understanding, a more careful study of the results obtained relative to the methods used was undertaken. In addition, where appropriate and necessary, a more complete modeling of the flow was performed using well proven methods of computational fluid dynamics. As a result, assessments will be made which are more quantitative than those of phase 1 regarding the uncertainty involved in the prediction of the aerodynamic derivatives. In addition, with improved understanding, it is anticipated that improvements resulting in better accuracy will be made to the simple force and moment prediction.

Maughmer, Mark D.↗

NASA NTRS1987

Cellular automatons applied to gas dynamic problems

This paper compares the results of a relatively new computational fluid dynamics method, cellular automatons, with experimental data and analytical results. This technique has been shown to qualitatively predict fluidlike behavior; however, there have been few published comparisons with experiment or other theories. Comparisons are made for a one-dimensional supersonic piston problem, Stokes first problem, and the flow past a normal flat plate. These comparisons are used to assess the ability of the method to accurately model fluid dynamic behavior and to point out its limitations. Reasonable results were obtained for all three test cases, but the fundamental limitations of cellular automatons are numerous. It may be misleading, at this time, to say that cellular automatons are a computationally efficient technique. Other methods, based on continuum or kinetic theory, would also be very efficient if as little of the physics were included.

Long, Lyle N.↗

NASA NTRS1987

Uniformly-valid asymptotic solutions to the Orr-Sommerfeld equation using multiple scales

The Orr-Sommerfeld equation is studied using the method of multiple scales. The leading-order uniformly-valid asymptotic solutions are obtained without recourse to heuristic methods for two different types of velocity profiles. Solutions were obtained for arbitrary velocity profiles without inflection or critical points and for profiles with simultaneous inflection and critical points. These are shown to reproduce previously obtained solutions in the inner and outer regions.

Long, Lyle N.↗