Lunar Flashlight Power Subsystem Architecture and Implementation
No abstract provided
Engineering topics
Publications and source records attributed to Loveland, Jessica.
No abstract provided
As the demand for high-performance power conversion in spacecraft continues to grow and spacecraft mass and volume budgets become increasingly tight, it is essential to design DC-DC converters with higher efficiency and power density. Although photovoltaic (PV) efficiency has increased over time, solar irradiance and temperatures can fluctuate dramatically in deep space. This causes significant variations in the maximum power point (MPP) of the PV array, which can decrease the overall system efficiency unless accounted for. Thus, it is imperative to track the MPP of the PV panels to maintain optimal efficiency. This paper presents the experimental development of a four-switch, GaN-based buck-boost converter with an implementation of the Ripple Correlation Control (RCC) MPPT algorithm for dynamic deep space environments. Due to the use of GaN HEMTs, the experimental system achieves better efficiency and power density compared to the previous state of the art implementations. A simulation of the prototype buck-boost converter was implemented in SaberRD (Synopsis), and a digital design of the RCC-based MPPT controller utilizing the StateAMS tool is presented. The simulation results show that this controller swiftly and precisely converged to the MPP of the source PV panels in a dynamic solar irradiance condition.
No abstract provided
The Lunar Flashlight (LF) mission will send a CubeSat to lunar orbit via NASA’s Space Launch System (SLS) test flight. The LF spacecraft will carry a novel instrument to quantify and map water ice harbored in the permanently shadowed craters of the lunar South Pole. The LF instrument, an active multi-band reflectometer which employs four high power diode lasers in the 1-2 μm infrared band, will measure the reflectance of the lunar surface near water ice absorption peaks. We present the detailed instrument design and system engineering required to deploy this instrument within very demanding CubeSat resource allocations.
The Arcsecond Space Telescope Enabling Research in Astrophysics (ASTERIA) was deployed from the International Space Station (ISS) on 20 November 2017, beginning a technology demonstration and opportunistic science mission to advance the state of the art in nanosatellite performance for astrophysical observations. The goal of ASTERIA is to achieve arcsecond-level line-of-sight pointing error and highly stable focal plane temperature control. These capabilities enable precision photometry—i.e. the careful measurement of stellar brightness over time—which in turn allows investigation of astrophysical phenomena such as transiting exoplanets. By the end of the 90-day prime mission, ASTERIA had achieved line-of-sight pointing stability of approximately 0.5 arcseconds root mean square (RMS) over 20-minute observations, pointing repeatability of 1 milliarcsecond RMS from one observation to the next, and focal plane temperature stability better than ±0.01 K over 20-minute observations. This paper presents an overview of the ASTERIA flight and ground system, summarizes the pre-delivery test campaign, and discusses the on-orbit performance obtained by the pointing and thermal control subsystems. We also describe the process for planning opportunistic science observations and present lessons learned from development and operations. Having successfully operated for over 200 days as of this writing, ASTERIA is currently in an extended mission to observe nearby bright stars for transiting exoplanets.