The on-orbit performance of SIRTF - an initial assessment
Explore the source record for details and available documents.
SIRTF infrared cryogenics optics↗
Engineering topics
Low, F.
Publications and source records attributed to Low, F..
Design concept for an IR mapping spectrometer for the Pluto fast flyby mission
The design of an IR mapping spectrometer that exceeds all the criteria of the Pluto Fast Flyby Mission will be presented. The instrument has a mass of approximately 1700 g and uses less than 4 W of power. The design concept is based on an f/3 spectrograph using an aberration-corrected concave holographic grating. Up to four spectral regions can be covered simultaneously by dividing the grating into two to four sections, each imaging the entrance slit on a different area of the array. The spectrography will be fed by a lightweight 5 in. f/3 telescope based on SDIO precepts. In order to provide spectroscopic access to the fundamental molecule frequencies, an extended-range NICMOS array to approximately 3.5 microns and an InSb array going to 5.8 microns will be considered.
Fink, U.↗
The discovery of dust trails in the orbits of periodic comets
Analysis of data from the Infrared Astronomical Satellite has yielded evidence for narrow trails of dust coincident with the orbits of periodic comets Tempel 2, Encke, and Gunn. Dust was found both ahead of and behind the orbital positions of these comets. This dust was produced by the low-velocity ejection of large particles during perihelion passage. More than 100 additional dust trails are suggested by the data, almost all near the detection limits of the satellite. Many of these dust trails may be derived from previously unobserved comets.
Sykes, M. V.↗
MIPS - The Multiband Imaging Photometer for SIRTF
The Multiband Imaging Photometer for SIRTF (MIPS) is to be designed to reach as closely as possible the fundamental sensitivity and angular resolution limits for SIRTF over the 3 to 700 micron spectral region. It will use high performance photoconductive detectors from 3 to 200 micron with integrating JFET amplifiers. From 200 to 700 microns, the MIPS will use a bolometer cooled by an adiabatic demagnetization refrigerator. Over much of its operating range, the MIPS will make possible observations at and beyond the conventional Rayleigh diffraction limit of angular resolution.
Rieke, G. H.↗
MIPS - The Multiband Imaging Photometer for SIRTF
The Multiband Imaging Photometer System (MIPS) for SIRTF is to be designed to reach as closely as possible the fundamental sensitivity and angular resolution limits for SIRTF over the 3 to 700 microns spectral region. It will use high performance photoconductive detectors from 3 to 200 microns with integrating JFET amplifiers. From 200 to 700 microns, the MIPS will use a bolometer cooled by an adiabatic demagnetization refrigerator. Over much of its operating range, the MIPS will make possible observations at and beyond the conventional Rayleigh diffraction limit of angular resolution.
Rieke, G. H.↗