Search NASA⌕ Search

Engineering topics

Lowdermilk, W. H.

Publications and source records attributed to Lowdermilk, W. H..

Modeling the effect of laser heating on the strength and failure of 7075-T6 aluminum

The effect of rapid laser heating on the response of 7075-T6 aluminum has been characterized using 3-D digital image correlation and a series of thermocouples. The experimental results indicate that as the samples are held under a constant load, the heating from the laser profile causes non-uniform temperature and strain fields, and the strain-rate increases dramatically as the sample nears failure. Simulations have been conducted using the LLNL multi-physics code ALE3D, and compared to the experiments. The strength and failure of the material was modeled using the Johnson–Cook strength and damage models. Here, in order to capture the response, a dual-condition criterion was utilized which calibrated one set of parameters to low temperature quasi-static strain rate data, while the other parameter set is calibrated to high temperature high strain rate data. The thermal effects were captured using temperature dependent thermal constants and invoking thermal transport with conduction, convection, and thermal radiation.

36 MATERIALS SCIENCE↗

Deep Penetration in Aerospace Composite Materials Using Near-Infrared Laser Radiation

Previous work on lethality against composite material targets considered only surface deposition of laser energy, with lethality achieved via target penetration or material removal by ply separation, delamination, and blow-off in high-speed airflow. To produce lethal effect in a militarily relevant timescale, typically on the order of seconds, requires laser irradiance in the range of ten to a few hundred kilowatts per cm2. This Feasibility Study discovers that volume heating, either by direct in-depth absorption of laser energy, for example in near-infrared (IR) laser irradiation of translucent fiberglass composite, or by rapid conduction of surface-deposited energy as in the case of opaque carbon composite, can induce failure under load in seconds by softening the resin matrix at irradiance less than 100 W/cm2 – one to three orders of magnitude lower than the intensity required to produce lethal effect by target penetration or material removal.

42 ENGINEERING↗

The Nova Upgrade Facility

The Nova Upgrade Facility is being designed to achieve inertial confinement fusion (ICF) ignition and gain. A baseline design of the laser and experimental facilities has been completed, and a development plan, which includes a fully integrated laser demonstration, has been formulated. With adequate funding, the activities in this plan could be completed by late 1993. Construction of the Nova Upgrade beginning at that time would make possible the achievement of ICF ignition before the end of the decade.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Rotating magnetic poles used to pump mercury

Rotating magnetic pump with redesigned pump cell is used for pumping mercury. The modified pump has better electrical continuity, more efficient heat removal, and good wetting characteristics in the mercury flow channel.

Ebihara, B. T.↗