Search NASA⌕ Search

Engineering topics

Lu, Juanjuan (ORCID:0000000319389119)

Publications and source records attributed to Lu, Juanjuan (ORCID:0000000319389119).

6 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2022

Monolithic Kerr and electro-optic hybrid microcombs

Microresonator-based soliton generation promises chip-scale integration of optical frequency combs for applications spanning from time keeping to frequency synthesis. Access to the soliton repetition rate is a prerequisite for those applications. While miniaturized cavities harness Kerr nonlinearity and enable terahertz soliton repetition rates, such high rates are not amenable to direct electronic detection. Here, we demonstrate hybrid Kerr and electro-optic microcombs using a lithium niobate thin film that exhibits both Kerr and Pockels nonlinearities. By interleaving the high-repetition-rate Kerr soliton comb with the low-repetition-rate electro-optic comb on the same waveguide, wide Kerr soliton mode spacing is divided within a single chip, allowing for direct electronic detection and feedback control of the soliton repetition rate. Our work establishes an integrated approach to electronically access terahertz solitons, paving the way for building chip-scale referenced comb sources.

42 ENGINEERING↗
DOE OSTI2022

Quadratic strong coupling in AlN Kerr cavity solitons

Photonic platforms with χ (2) nonlinearity offer new degrees of freedom for Kerr frequency comb development. Here, we demonstrate Kerr soliton generation at 1550 nm with phase-matched quadratic coupling to the 775 nm harmonic band in a single AlN microring and thus the formation of dual-band mode-locked combs. In the strong quadratic coupling regime where the χ (2) phase-matching window overlaps the pump mode, the pump-to-harmonic-comb conversion efficiency is optimized. However, the strong quadratic coupling also drastically modifies the Kerr comb generation dynamics and decreases the probability of soliton generation. By engineering the χ (2) phase-matching wavelength, we are able to achieve a balance between high conversion efficiency and high soliton formation rate under the available pump power and microring quality factors. Our numerical simulations confirm the experimental observations. These findings provide guidance on tailoring single-cavity dual-band coherent comb sources.

Gong, Zheng (ORCID:0000000301704870)↗
DOE OSTI2021

Ultralow-threshold thin-film lithium niobate optical parametric oscillator

Materials with strong second-order ( χ <#comment/> ( 2 ) ) optical nonlinearity, especially lithium niobate, play a critical role in building optical parametric oscillators (OPOs). However, chip-scale integration of low-loss χ <#comment/> ( 2 ) materials remains challenging and limits the threshold power of on-chip χ <#comment/> ( 2 ) OPO. Here we report an on-chip lithium niobate optical parametric oscillator at the telecom wavelengths using a quasi-phase-matched, high-quality microring resonator, whose threshold power ( ∼ <#comment/> 30 µ <#comment/> W ) is 400 times lower than that in previous χ <#comment/> ( 2 ) integrated photonics platforms. An on-chip power conversion efficiency of 11% is obtained from pump to signal and idler fields at a pump power of 93 µW. The OPO wavelength tuning is achieved by varying the pump frequency and chip temperature. With the lowest power threshold among all on-chip OPOs demonstrated so far, as well as advantages including high conversion efficiency, flexibility in quasi-phase-matching, and device scalability, the thin-film lithium niobate OPO opens new opportunities for chip-based tunable classical and quantum light sources and provides a potential platform for realizing photonic neural networks.

Lu, Juanjuan (ORCID:0000000319389119)↗
DOE OSTI2021

Mitigating photorefractive effect in thin-film lithium niobate microring resonators

Thin-film lithium niobate is an attractive integrated photonics platform due to its low optical loss and favorable optical nonlinear and electro-optic properties. However, in applications such as second harmonic generation, frequency comb generation, and microwave-to-optics conversion, the device performance is strongly impeded by the photorefractive effect inherent in thin-film lithium niobate. In this paper, we show that the dielectric cladding on a lithium niobate microring resonator has a significant influence on the photorefractive effect. By removing the dielectric cladding layer, the photorefractive effect in lithium niobate ring resonators can be effectively mitigated. Our work presents a reliable approach to control the photorefractive effect on thin-film lithium niobate and will further advance the performance of integrated classical and quantum photonic devices based on thin-film lithium niobate.

42 ENGINEERING↗
DOE OSTI2020

Toward 1% single-photon anharmonicity with periodically poled lithium niobate microring resonators

The absence of the single-photon nonlinearity has been a major roadblock in developing quantum photonic circuits at optical frequencies. In this paper, we demonstrate a periodically poled thin film lithium niobate microring resonator (PPLNMR) that reaches 5,000,000%/W second-harmonic conversion efficiency—almost 20-fold enhancement over the state-of-the-art—by accessing its largest χ <#comment/> ( 2 ) tensor component d 33 via quasi-phase matching. The corresponding single-photon coupling rate g / 2 π <#comment/> is estimated to be 1.2 MHz, which is an important milestone as it approaches the dissipation rate κ <#comment/> / 2 π <#comment/> of best-available lithium niobate microresonators developed in the community. Using a figure of merit defined as g / κ <#comment/> , our device reaches a single-photon nonlinear anharmonicity approaching 1%. We show that, by further scaling of the device, it is possible to improve the single-photon anharmonicity to a regime where photon blockade effect can be manifested.

Lu, Juanjuan (ORCID:0000000319389119)↗