Lucy Zuo | Search NASA

NASA NTRSDate not supplied

PPE Electric Propulsion Advancing to CDR: 12kW String

String level testing is a vital part of electric propulsion development. With the Power and Propulsion Element (PPE) spacecraft flying two new models of Hall Thrusters, this work is even more critical. PPE will have both 6kW and 12kW thruster strings onboard, all powered by Maxar power processing units (PPU). Both strings have recently undergone end-to-end string level hot fire testing to verify the ability of all components to work together. This entails operating the thruster with the Xenon Flow Controller (XFC) and PPUs under both nominal and off-nominal conditions to stress the system and determine weak points. Such testing has long been a standard Maxar practice since our first 1.5kW electric propulsion system in 2004. This paper will focus on Phase 1 of the 12kW testing recently completed at NASA Glenn. The primary conclusion of the test effort was that the 12kW string operated nominally and that the PPU and XFC could operate the thruster within specifications.

Electric propulsion↗

NASA NTRSDate not supplied

A Facility Effect Characterization Test of the BHT-6000 Hall Thruster

During the development of the BHT-6000 Hall thruster for flight on NASA’s Power and Propulsion Element, a facility effect test campaign was performed on an engineering unit of the thruster. Testing occurred in Vacuum Facility 5 at NASA Glenn Research Center. The goal of the test campaign was to characterize the behavior of the BHT-6000 Hall thruster as functions of facility effects such that the thruster’s in-flight behavior can be reasonably bounded. In particular, the behavior of the thruster with regard to the background pressure and electrical environment was tested. The background pressure was controlled by injecting supplemental propellant flow into the environment, while the electrical environment was controlled by biasing the facility beam dump. Thrust was found to remain constant over the tested range of pressures while specific impulse was found to increase slightly (1 to 1.5% over a range of up to 20 μTorr, depending on operating point). Plasma plume properties, particularly of ions exiting the side of the thruster, were found to be highly sensitive to pressure and may require pressures of less than a few μTorr for accurate measurements. The thruster was found to operate identically with changing beam dump bias voltage to within measurement uncertainties.

Electric propulsion↗

NASA NTRSDate not supplied

A Facility Effect Characterization Test of the BHT6000 Hall Thruster

During the development of the BHT-6000 Hall thruster for flight on NASA’s Power and Propulsion Element, a facility effect test campaign was performed on an engineering unit of the thruster. Testing occurred in Vacuum Facility 5 at NASA Glenn Research Center. The goal of the test campaign was to characterize the behavior of the BHT-6000 Hall thruster as functions of facility effects such that the thruster’s in-flight behavior can be reasonably bounded. In particular, the behavior of the thruster with regard to the background pressure and electrical environment was tested. The background pressure was controlled by injecting supplemental propellant flow into the environment, while the electrical environment was controlled by biasing the facility beam dump. Thrust was found to remain constant over the tested range of pressures while specific impulse was found to increase slightly (1 to 1.5% over a range of up to 20 μTorr, depending on operating point). Plasma plume properties, particularly of ions exiting the side of the thruster, were found to be highly sensitive to pressure and may require pressures of less than a few μTorr for accurate measurements. The thruster was found to operate identically with changing beam dump bias voltage to within measurement uncertainties.

Electric propulsion↗