Search NASA⌕ Search

Engineering topics

Lukashev, Pavel V.

Publications and source records attributed to Lukashev, Pavel V..

12 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Natural formation of linear defect structures in MoS 2

Near surface defects can significantly impact the quality of metallic interconnects and other interfaces necessary to create device structures incorporating two-dimensional materials. Furthermore, the impact of such defects can strongly depend on their organization. In this study, we present scanning tunneling microscopy images and tunneling spectroscopy of point and linear defects near the surface of natural MoS 2 . The point defects share similar structural and electronic characteristics and occur with comparable frequency as subsurface sulfur vacancies observed previously on natural MoS 2 . The linear defects observed here occur less frequently than the point defects but share the same depth profile and electronic structure. These data indicate that the linear defects are actually a one-dimensional organization of subsurface sulfur vacancies. Our density functional calculations agree with this assessment in that, for sufficient local defect concentrations, it is energetically more favorable for the defects to be organized in a linear fashion rather than as clusters or even isolated single point defects. Given these measurements were taken from naturally formed MoS 2 , this organization likely occurs during crystal formation. Considering the impact of one-dimensional organization on the local properties of layered materials, and the potential for them to be introduced purposefully during crystal formation, research into the formation mechanism and properties of these defects could enable new paths for defect engineering in MoS 2 -based systems.

2D materials↗
DOE OSTI2023

Structural, electronic, and magnetic properties of CoFeVGe-based compounds: Experiment and theory

We have carried out a combined theoretical and experimental investigation of both stoichiometric and nonstoichiometric CoFeVGe alloys. In particular, we have investigated CoFeVGe, Co 1.25 Fe 0.75 VGe, Co 0.75 Fe 1.25 VGe, and CoFe 0.75 VGe bulk alloys. Our first principles calculations suggest that all four alloys show ferromagnetic order, where CoFeVGe, Co 1.25 Fe 0.75 VGe, and Co 0.75 Fe 1.25 VGe are highly spin polarized with spin polarization values of over 80%. However, the spin polarization value of CoFe 0.75 VGe is only about 60%. We have synthesized all four samples using arc melting and high-vacuum annealing at 600 °C for 48 hours. The room temperature x-ray diffraction of these samples exhibits a cubic crystal structure with disorder. All the samples show single magnetic transitions at their Curie temperatures, where the Curie temperature and high field (3T) magnetization are 288 K and 42 emu/g; 305 K and 1.5 emu/g; 238 K and 39 emu/g; and 306 K and 35 emu/g for CoFeVGe, Co 1.25 Fe 0.75 VGe, Co 0.75 Fe 1.25 VGe, and CoFe 0.75 VGe, respectively.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Criteria for electronic growth of Au on layered semiconductors

An electronic growth mode has been reported to occur in several noble metals on MoS2 but has not been observed on other layered semiconductors. In this work, the experiments show that Au(111) islands initially follow an electronic growth mode on WS2, matching the quantization seen in Au/MoS2. However, while epitaxial nanostructures with similar features are observed on WSe2, there is no sign of electronic growth. Binding energy calculations show that multiple bonding sites have nearly the same energy on both WS2 and MoS2, while Au strongly prefers a single bonding site on WSe2. Having multiple sites with the same energy gives flexibility in interfacial bonding that can alleviate strain from the 9+% lattice mismatch in these systems, which would, otherwise, easily suppress quantum size effects from electronic growth modes. These results should be useful in predicting which systems undergo quantized electronic growth on layered semiconductors.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2022

Electronic, magnetic, and structural properties of CrMnSb 0.5 Si 0.5

Half-metallic Heusler compounds are among the most actively studied materials for applications in spin-based devices. Largely, this is due to their higher Curie temperature compared with the other half-metallic compounds, and relative ease of fabrication. Here we theoretically study one such Heusler alloy CrMnSb 0.5 Si 0.5 . In particular, we demonstrate a potential stability of this compound by estimating its formation energy, its half-metallic electronic structure (stable under a considered range of biaxial strain), and ferrimagnetic alignment. The calculated Curie temperature of this material is 787 K, much higher than room temperature. At the same time, we have shown that in thin-film geometry the spin-polarization of this material is strongly reduced due to the emergence of surface states in the minority-spin energy gap. In addition, one of the considered termination surfaces is thermodynamically unstable, while the other is stable. Here, the presented results may be useful for researchers working on practical applications in the field of spintronics.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Large-field magnetoresistance of nanometer scale nickel films grown on molybdenum disulfide

The magnetoresistance of thin nickel films grown on molybdenum disulfide was measured in perpendicular magnetic fields as high as 90 kOe. Films with thicknesses of 20 nm provided continuous surfaces for measurement. The magnetoresistance was found to be linear with respect to the applied magnetic field with no sign of saturation. There was also no evidence of hysteresis or temperature dependence between 100 to 300 K. STM measurement showed the deposited Ni forms a continuous film of extremely small nanoclusters. However, the field dependence of magnetoresistance was found to be significantly larger than bulk Ni, which is in turn larger than Ni with nanoscale grains. We expect the unusual magnetoresistance behavior to arise from some property of the Ni-MoS 2 interface.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2022

Electronic band structure and magnetism of CoFeV 0.5 Mn 0.5 Si

Half-metallic Heusler alloys have attracted significant attention due to their potential application in spin-transport-based devices. We have synthesized one such alloy, CoFeV 0.5 Mn 0.5 Si, using arc melting and high-vacuum annealing at 600 °C for 24 hours. First principles calculation indicates that CoFeV 0.5 Mn 0.5 Si shows a nearly half-metallic band structure with a degree of spin polarization of about 93%. In addition, this value can be enhanced by the application of tensile strain. The room temperature x-ray diffraction patterns are indexed with the cubic crystal structure without secondary phases. The annealed sample shows ferromagnetic order with the Curie temperature well above room temperature ( T c = 657 K) and a saturation magnetization of about 92 emu/g. Our results indicate that CoFeV 0.5 Mn 0.5 Si has a potential for room temperature spin-transport-based devices.

36 MATERIALS SCIENCE↗
DOE OSTI2021

First principles study of nearly strain-free Ni/WSe 2 and Ni/MoS 2 interfaces

Metal/transition metal dichalcogenide interfaces are the subject of active research, in part because they provide various possibilities for interplay of electronic and magnetic properties with potential device applications. Here, we present results of our first principles calculations of nearly strain-free Ni/WSe 2 and Ni/MoS 2 interfaces in thin-film geometry. It is shown that while both the WSe 2 and MoS 2 layers adjacent to Ni undergo metallic transition, the layers farther from the interface remain semiconducting. In addition, a moderate value of spin-polarization is induced on interfacial WSe 2 and MoS 2 layers. At the same time, the electronic and magnetic properties of Ni are nearly unaffected by the presence of WSe 2 and MoS 2 , except a small reduction of magnetic moment at the interfacial Ni atoms. Furthermore, these results can be used as a reference for experimental efforts on epitaxial metal/transition metal dichalcogenide heterostructures, with potential application in modern magnetic storage devices.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2021

Electronic, structural and magnetic properties of Mn (1+x) Pt (1-x) Sb

Electronic and magnetic properties of half-metallic Heusler alloys can be modified by tuning their chemical compositions. We have carried out a combined theoretical and experimental investigation of Mn (1+x) Pt (1-x) Sb (0 ≤ x ≤ 0.5) alloys. Our first-principles calculations indicate that the stoichiometric MnPtSb exhibits nearly half-metallic band structure, but a robust half-metallicity can be achieved in Mn-rich compositions Mn (1+x) Pt (1-x) Sb (0 ≤ x ≤ 0.5) with x = 0.25 and higher in their cubic structures. In addition, while MnPtSb exhibits ferromagnetic alignment, Mn (1+x) Pt (1-x) Sb are ferrimagnetic for all non-zero values of x. We have also synthesized cubic MnPtSb and Mn 1.25 Pt 0.75 Sb alloys using arc melting and annealing. The magnetic properties of these alloys are consistent with our theoretical predictions. Furthermore, these results indicate that the Mn-rich Mn (1+x) Pt (1-x) Sb alloys have potential for spin-transport-based devices.

36 MATERIALS SCIENCE↗
DOE OSTI2021

Electronic growth of Pd(111) nanostructures on MoS 2

Quantum confinement effects can induce the formation of discrete nanostructures with well-defined preferred heights in thin metallic films. In most systems, such electronic growth modes are weak and limited to cryogenic conditions. Recently, however, we have discovered that metals grown upon van der Waals surfaces can exhibit electronic growth at, or even above, room temperature to spontaneously form well-defined and highly stable nanostructures. Here, we explore the initial stages of room temperature deposition of Pd onto MoS 2 . We found that, even for minimal thicknesses, Pd spontaneously formed discrete islands with three atomic layers. The islands maintained this preferred height for nominal coverages below three atomic layers. At higher coverages, the preferred height switched abruptly to six atomic layers. Unlike previous studies using Au or Ag, the islands did not increase laterally with coverage but rather increased in number with lateral size remaining about the same. The preferred heights in Pd/MoS 2 correlate to the Pd Fermi surface topography and are also consistent with thicknesses showing minima in the density of states at the Fermi level, which suggest that the electronic growth modes are the driving factors in these self-assembled Pd nanostructures. The Pd system shows a preference for island nucleation compared to Au and Ag which grow laterally with increasing coverage. Furthermore, this is likely related to differences in bonding at the interface as Pd is typically much more reactive than Ag or Au.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Perpendicular magnetic anisotropy in half-metallic thin-film Co 2 CrAl

Magnetocrystalline anisotropy (MCA) is one of the key parameters investigated in spin-based electronics (spintronics), e.g. for memory applications. Here, we employ first-principles calculations to study MCA in thin film full Heusler alloy Co 2 CrAl. This material was studied in the past, and has been reported to exhibit half-metallic electronic structure in bulk geometry. In our recent work, we showed that it retains a 100% spin-polarization in thin-film geometry, at CrAl atomic surface termination. Here, we show that the same termination results in a perpendicular magnetic anisotropy, while Co surface termination not only destroys the half-metallicity, but also results in in-plane magnetization orientation. In addition, for films thicker than around 20 nm the contribution from magnetic shape anisotropy may become decisive, resulting in in-plane magnetization orientation. To the best of our knowledge, this is one of the first reports of half-metallic thin-film surfaces with perpendicular magnetic anisotropy. Furthermore, this result may be of interest for potential nano-device applications, and may stimulate a further experimental study of this and similar materials.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Chemical substitution induced half-metallicity in CrMnSb (1– x ) P x

Half-metallic Heusler alloys have been intensively studied in recent years due to their potential applications in spin-based devices, e.g., in magnetic tunnel junctions. Yet, their properties may be very sensitive to the choice of the substrates, i.e., to the epitaxial strain and interface properties. Here, we report the results of our computational work on the half-Heusler compound CrMnSb (1–x) P x . In particular, we demonstrate that the parent compound CrMnSb is close to a half-metallic material at the optimized lattice parameter, with the onset of the half-metallic bandgap a few meV above the Fermi energy. Moreover, although it undergoes a half-metallic transition under a uniform compression of ~1.5%, such a transition is absent under epitaxial strain. At the same time, we show that a half-metallic transition could be induced by a chemical substitution of Sb with P, which results in a volume reduction of the unit cell. In particular, 50% substitution of Sb with P leads to a robust half-metallicity in CrMnSb (1–x) P x , with 100% spin polarization being retained at a large range of epitaxial strain. Furthermore, our results indicate that CrMnSb0.5P0.5 could be grown on different types of substrates, e.g., GaAs, without its electronic properties being detrimentally affected by biaxial strain. In addition, CrMnSb 0.5 P 0.5 exhibits a fully compensated ferrimagnetic alignment, which could be potentially useful in applications where stray magnetic fields are undesirable.

36 MATERIALS SCIENCE↗