Search NASASearch

Engineering topics

Luke, Edward

Publications and source records attributed to Luke, Edward.

Wet-radome attenuation in ARM cloud radars and its utilization in radar calibration using disdrometer measurements

Abstract. A relative calibration technique has been developed for the US Department of Energy's (DOE's) Atmospheric Radiation Measurement (ARM) user facility Ka-band ARM Zenith Radars (KAZRs). This method uses the signal attenuation caused by water on the radome to estimate reflectivity factor (Ze) offsets. The wet-radome attenuation (WRA) is assumed to follow a log-linear relationship with rainfall rate during light and moderate rain, as measured by a collocated surface disdrometer. The technique has an uncertainty of approximately 3 dB, due to factors such as disdrometer measurement error, rain variability between radar and disdrometer sample volumes, and the fitting function's uncertainty for the WRA behavior. A practical advantage of this WRA-based approach to shorter-wavelength radar monitoring is that, while it requires a reference disdrometer, it proves feasible for a wider range of collocated disdrometer measurements compared to traditional direct disdrometer comparison at the onset of light rain. This technique thus offers a cost-effective monitoring tool for remote or long-term radar deployments. This calibration technique was applied during the ARM Tracking Aerosol Convection Interactions Experiment (TRACER) from October 2021 through September 2022. The estimated Ze offsets were compared against traditional radar calibration and monitoring methods using available datasets from this campaign. Results show that the WRA-based offsets align closely with mean offsets found between cloud radars and from direct disdrometer comparison near the onset of rain, while also reflecting similar offset and campaign-long trends when compared to collocated, independently calibrated radar wind profilers. Nevertheless, overall, the KAZR Ze offsets estimated during TRACER remained stable at approximately 2 dB lower than the disdrometer estimates from the campaign start until the end of June 2022; afterward, the offsets increased to around 7 dB by the campaign's end. This increase is linked to a drop of about 1 dB in transmitter power toward the end of the project.

54 ENVIRONMENTAL SCIENCES

Training the next generation of researchers in exploring cloud dynamics and microphysics using millimeter-wavelength radars

Millimeter-wavelength radars, with their ability to collect observations and high spatiotemporal resolution, have become cornerstone instruments for investigating cloud and precipitation microphysics and dynamics in the last two decades. Since the1990s the US Department of Energy Atmospheric Radiation Measurement (ARM) program has invested in mm-wavelength radar technology progressively adding scanning capability, additional frequencies and polarimetric capability. In addition, atmospheric observatories including those technologies have been operated overseas. Those technologies have enhanced our understanding of cloud and precipitation processes. Only a few universities operate those instruments and use them for educational purposes. The central role of mm- wavelength radars and their role will be further highlighted in the next decade. NASA and other international space agencies are planning to launch millimeter-wavelength (i.e., Ku, Ka, W, G- bands) Doppler radar in space to improve our understanding of cloud and precipitation formation, evolution and their impacts on global climate.

54 ENVIRONMENTAL SCIENCES

Peering into cloud physics using ultra-fine resolution radar and lidar systems

Cloud microphysical processes, such as droplet activation, condensational growth, and collisional growth, play a central role in the evolution of clouds and precipitation. Accurate representations of these processes in numerical models are challenging partially due to incomplete understanding of them at the process-level arising from limited systematic observations. Most surface-based active remote sensors, including today’s operational cloud radars and lidars, have a resolution on the order of tens of meters. This resolution is insufficient to resolve cloud microphysical processes that manifest at finer (meter and sub-meter) scales. A new set of ultra-high-resolution ground-based radar and lidar systems have been developed to address this observational gap. The newly developed 94-GHz cloud radar has a range resolution down to 2.8 m, or a factor of 10 finer than typical radars, using a large bandwidth and quadratic phase coding techniques. The lidar has a range resolution down to 10 cm, or a factor of 100 finer than typical lidars, using a time-gated time-correlated single photon counting technique. Such high-resolution observations were previously only achievable through in situ aircraft measurements. Even then, aircraft measurements do not permit continuous long-term cloud observation as is possible with ground-based remote sensing instruments. In this study, the first-light cloud observations from the new radar and lidar systems are shown to reveal detailed cloud structures that conventional sensors could only perceive in a bulk sense, thus providing new avenues to investigate cloud microphysical processes and their impact on weather and climate.

54 ENVIRONMENTAL SCIENCES

THz Radar Observations of Hydrometeors in a Spray Chamber

Abstract A THz radar, with its wide bandwidth, is capable of high‐resolution imaging down to the centimeter scale. In this study, a THz radar is applied to detect hydrometeors generated in a spray chamber. The observed backscattering signals show fluctuations at centimeter scales, indicating various hydrometeor distribution patterns along the radar beam. A co‐located High‐Speed Imaging (HSI) sensor is used to measure the Drop Size Distributions (DSD) in the spray chamber. The radar sampling beam is well aligned with the HSI probes, allowing an objective comparison between the remote sensing and in situ observations. In this study, the observed radar power is compared with the power estimated from the HSI measurements. Results show great consistency, with power difference smaller than 0.5 dB. This study demonstrates the feasibility and great potential of using a THz radar for ultra‐high‐resolution observations of clouds in a laboratory facility, and in the real atmosphere.

54 ENVIRONMENTAL SCIENCES

Discrete Surface Evolution and Mesh Deformation for Aircraft Icing Applications

Robust, automated mesh generation for problems with deforming geometries, such as ice accreting on aerodynamic surfaces, remains a challenging problem. Here we describe a technique to deform a discrete surface as it evolves due to the accretion of ice. The surface evolution algorithm is based on a smoothed, face-offsetting approach. We also describe a fast algebraic technique to propagate the computed surface deformations into the surrounding volume mesh while maintaining geometric mesh quality. Preliminary results presented here demonstrate the ecacy of the approach for a sphere with a prescribed accretion rate, a rime ice accretion, and a more complex glaze ice accretion.

ice accretion

Marine Boundary Layer Cloud Properties From AMF Point Reyes Satellite Observations

Cloud Diameter, C(sub D), offers a simple measure of Marine Boundary Layer (MBL) cloud organization. The diurnal cycle of cloud-physical properties and C(sub D) at Pt Reyes are consistent with previous work. The time series of C(sub D) can be used to identify distinct mesoscale organization regimes within the Pt. Reyes observation period.

Jensen, Michael

Computational Systems for Multidisciplinary Applications

In this paper, we briefly describe our efforts to develop complex simulation systems. We focus first on four key infrastructure items: enterprise computational services, simulation synthesis, geometry modeling and mesh generation, and a fluid flow solver for arbitrary meshes. We conclude by presenting three diverse applications developed using these technologies.

Soni, Bharat