Engineering topics

Luntz, Alan C.

Publications and source records attributed to Luntz, Alan C..

4 records

DOE OSTI2024

Factors Affecting the Electron Conductivity in Single Crystal Li 7 La 3 Zr 2 O 12 and Li 7 P 3 S 11

One of the serious challenges in all solid-state Li ion batteries is neutral Li intrusion into the solid-state electrolyte that can ultimately cause catastrophic failure. One possibility for this is due to n-type electron conductivity that induces the reaction Li + + e – → Li 0 at sites where the potential is less than the Li + /Li potential. This paper reports hybrid density functional theory calculations of the electronic conductivity in two prototype single crystalline solid-state electrolytes, cubic Li 7 La 3 Zr 2 O 12 (c-LLZO) and Li 7 P 3 S 11 (LPS). The formation energies of important point defects that can affect electron conductivity are determined, and we find that the mechanism of n-type electron conductivity for both solid-state electrolytes is via “small” electron polaron hopping, where the quotes signify that substantial Li ion rearrangement is associated with the polaron formation and its migration. In both electrolytes, the formation energies for the small polarons at the Fermi energy are too high to generate measurable electron conductivity at room temperature. For c-LLZO, the concentration of electron polarons necessary to ensure charge neutrality from positively charged oxygen vacancies formed in synthesis can be significantly higher. Hence, the electron conductivity could be significant when measured with ion-blocking metal electrodes, and we discuss how the synthesis conditions could affect this magnitude. However, in the solid-state battery, these polarons are replaced by negatively charged Li vacancies so that the electron conductivity should remain minimal. For LPS single crystals, the inherent minimal electron conductivity is independent of synthesis conditions. Here we also show that the cost of forming Li 0 in bulk c-LLZO is enormous due to strain effects so that it could only potentially form at voids, grain boundaries, or around vacancy defects which relax the lattice strain.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

DOE OSTI2022

Atom-Specific Probing of Electron Dynamics in an Atomic Adsorbate by Time-Resolved X-Ray Spectroscopy

The electronic excitation occurring on adsorbates at ultrafast timescales from optical lasers that initiate surface chemical reactions is still an open question. Here, in this work, we report the ultrafast temporal evolution of x-ray absorption spectroscopy (XAS) and x-ray emission spectroscopy (XES) of a simple well-known adsorbate prototype system, namely carbon (C) atoms adsorbed on a nickel [Ni(100)] surface, following intense laser optical pumping at 400 nm. We observe ultrafast (~100 fs) changes in both XAS and XES showing clear signatures of the formation of a hot electron-hole pair distribution on the adsorbate. This is followed by slower changes on a few picoseconds timescale, shown to be consistent with thermalization of the complete C/Ni system. Density functional theory spectrum simulations support this interpretation.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2021

Ultrafast Adsorbate Excitation Probed with Subpicosecond-Resolution X-Ray Absorption Spectroscopy

We use a pump-probe scheme to measure the time evolution of the C K-edge x-ray absorption spectrum from CO/Ru(0001) after excitation by an ultrashort high-intensity optical laser pulse. Because of the short duration of the x-ray probe pulse and precise control of the pulse delay, the excitation-induced dynamics during the first picosecond after the pump can be resolved with unprecedented time resolution. By comparing with density functional theory spectrum calculations, we find high excitation of the internal stretch and frustrated rotation modes occurring within 200 fs of laser excitation, as well as thermalization of the system in the picosecond regime. The ~100 fs initial excitation of these CO vibrational modes is not readily rationalized by traditional theories of nonadiabatic coupling of adsorbates to metal surfaces, e.g., electronic frictions based on first order electron-phonon coupling or transient population of adsorbate resonances. Finally, we suggest that coupling of the adsorbate to nonthermalized electron-hole pairs is responsible for the ultrafast initial excitation of the modes.

47 OTHER INSTRUMENTATION↗

DOE OSTI2020

Accuracy of XAS theory for unraveling structural changes of adsorbates: CO on Ni(100)

Studying surface reactions using ultrafast optical pump and X-ray probe experiments relies on accurate calculations of X-ray spectra of adsorbates for correct identification of the spectral signatures and their dynamical evolution. We show that experimental XAS can be well reproduced for the different binding sites in a static prototype system CO/Ni(100) at a standard DFT (GGA) level of theory, using a plane-wave basis and pseudopotentials. This validates its utility in analyzing ultrafast X-ray probe experiments. The accuracy of computed relative core level binding energies is about 0.2 eV, representing a lower limit for which spectral features can be resolved with this method. We also show that the commonly used Z +1 approximation gives very good core binding energy shifts overall. However, we find a discrepancy for CO adsorbed in the hollow site, which we assign to the significantly stronger hybridization in hollow bonding than in on-top.

74 ATOMIC AND MOLECULAR PHYSICS↗