Search NASA⌕ Search

Engineering topics

Luo, Zhong-Zhen

Publications and source records attributed to Luo, Zhong-Zhen.

9 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2023

GaSb doping facilitates conduction band convergence and improves thermoelectric performance in n-type PbS

P-type lead chalcogenides have superior thermoelectric performance because they exhibit the energy convergence of several valence bands. However, despite the existence of two conduction bands, there has been no report about conduction band (CB) convergence for n-type counterparts because of the large energy difference between them. Therefore, new strategies are required to manipulate the CBs if enhancing the electrical transport performance of n-type lead chalcogenides is to be achieved. PbS is a highly attractive member of the lead chalcogenides because of its high earth-abundance and low cost. Here, we report that the introduction of GaSb can successfully dope the PbS matrix with Ga and Sb atoms occupying the Pb site in its rock salt structure. GaSb doping leads to conduction band convergence and enlarged effective density of state mass for n-type PbS. This effect results in superior power factor and decreased lattice thermal conductivity caused by the soft phonon modes and point defect scattering of phonons. Consequently, a record-high average power factor PF avg of ~20.4 μW cm –1 K –2 and figure of merit ZT avg of ~0.84 in the temperature range of 400 K to 923 K were obtained, higher than any n- and p-type PbS-based thermoelectric materials.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Dynamic crystallography reveals spontaneous anisotropy in cubic GeTe

Cubic energy materials such as thermoelectrics or hybrid perovskite materials are often understood to be highly disordered. In GeTe and related IV–VI compounds, this is thought to provide the low thermal conductivities needed for thermoelectric applications. Since conventional crystallography cannot distinguish between static disorder and atomic motions, we develop the energy-resolved variable-shutter pair distribution function technique. This collects structural snapshots with varying exposure times, on timescales relevant for atomic motions. In disagreement with previous interpretations, we find the time-averaged structure of GeTe to be crystalline at all temperatures, but with anisotropic anharmonic dynamics at higher temperatures that resemble static disorder at fast shutter speeds, with correlated ferroelectric fluctuations along the <100> c direction. We show that this anisotropy naturally emerges from a Ginzburg–Landau model that couples polarization fluctuations through long-range elastic interactions. By accessing time-dependent atomic correlations in energy materials, we resolve the long-standing disagreement between local and average structure probes and show that spontaneous anisotropy is ubiquitous in cubic IV–VI materials.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗
DOE OSTI2022

Valence Disproportionation of GeS in the PbS Matrix Forms Pb 5 Ge 5 S 12 Inclusions with Conduction Band Alignment Leading to High n-Type Thermoelectric Performance

Converting waste heat into useful electricity using solid-state thermoelectrics has a potential for enormous global energy savings. Lead chalcogenides are among the most prominent thermoelectric materials, whose performance decreases with an increase in chalcogen amounts (e.g., PbTe>PbSe>PbS). Herein, we demonstrate the simultaneous optimization of the electrical and thermal transport properties of PbS-based compounds by alloying with GeS. The addition of GeS triggers a complex cascade of beneficial events as follows: Ge 2+ substitution in Pb 2+ and discordant off-center behavior; formation of Pb 5 Ge 5 S 12 as stable second phase inclusions through valence disproportionation of Ge 2+ to Ge0 and Ge 4+ . PbS and Pb 5 Ge 5 S 12 exhibit good conduction band energy alignment that preserves the high electron mobility; the formation of Pb 5 Ge 5 S 12 increases the electron carrier concentration by introducing S vacancies. Sb doping as the electron donor produces a large power factor and low lattice thermal conductivity (κ lat ) of ~0.61 Wm -1 K -1 . The highest performance was obtained for the 14% GeS-alloyed samples, which exhibited an increased room temperature electron mobility of ~121 cm 2 V -1 s -1 for 3 × 10 19 cm -3 carrier density, and a ZT, of 1.32 at 923 K. This is ~ 55% greater that the corresponding Sb-doped PbS sample and is one of the highest reported for the n-type PbS system. Moreover, the average ZT (ZT avg ) of ~0.76 from 400 to 923 K is the highest for PbS-based systems.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2022

Thermoelectric Performance of the 2D Bi 2 Si 2 Te 6 Semiconductor

Bi 2 Si 2 Te 6 , a 2D compound, is a direct band gap semiconductor with an optical band gap of 0.25 eV, and is a promising thermoelectric material. Single-phase Bi 2 Si 2 Te 6 is prepared by a scalable ball-milling and annealing process and the highly densified polycrystalline samples are prepared by spark plasma sintering. Bi 2 Si 2 Te 6 shows a p-type semiconductor transport behavior and exhibits an intrinsically low lattice thermal conductivity of ~0.48 Wm -1 K -1 (cross-plane) at 573 K. The first-principles density functional theory calculations indicate that such low lattice thermal conductivity is derived from the interactions between acoustic phonons and low-lying optical phonons, local vibrations of Bi, the low Debye temperature and strong anharmonicity result from the unique 2D crystal structure and metavalent bonding of Bi 2 Si 2 Te 6 . The Bi 2 Si 2 Te 6 exhibits an optimal figure of merit ZT of ~0.51 at 623 K, which can be further enhanced by the substitution of Bi with Pb. Pb doping leads to a large increase in power factor S 2 σ, from ~4.0 μWcm -1 K- 2 of Bi 2 Si 2 Te 6 to ~8.0 μWcm -1 K -2 of Bi 1.98 Pb 0.02 Si 2 Te 6 at 775 K, owing to the increase in carrier concentration. Moreover, Pb doping induces a further reduction in the lattice thermal conductivity to ~0.38 Wm -1 K -1 (cross-plane) at 623 K in Bi 1.98 Pb 0.02 Si 2 Te 6 ,. The simultaneous optimization of the power factor and lattice thermal conductivity achieves a peak ZT of ~0.90 at 723 K and a high average ZT of ~0.66 at 400–773 K in Bi 1.98 Pb 0.02 Si 2 Te 6 .

36 MATERIALS SCIENCE↗
DOE OSTI2021

Extraordinary role of Zn in enhancing thermoelectric performance of Ga-doped n-type PbTe

Although Ga doping can weaken the electron phonon coupling in n-type PbTe, Ga-doped PbTe has a relatively low carrier concentration (n) and high lattice thermal conductivity (κ lat ), resulting in a lower figure of merit (ZT) compared with those of other top-performing n-type PbTe-based thermoelectric materials. Herein, we report the extraordinary role of Zn in enhancing the thermoelectric performance of Ga-doped PbTe. It is discovered that Zn can simultaneously improve the electronic transport properties and decrease the κlat of Ga-doped PbTe, thereby affording a record high ZT avg ~ 1.26 at 400–873 K, with a maximum ZT value of 1.55 at 723 K. The isoelectronic substitution of Zn for Pb in Ga-doped PbTe increases the electrical conductivity and n by inducing the nucleation and growth of Ga 2 Te 3 in the second phase. The formation of Ga 2 Te 3 results in nonstoichiometry and Te deficiency in the PbTe matrix, which increases the number of electron carriers. Additionally, discordant Zn and Ga atoms with displacing off-center from the ideal octahedral positions, as well as Ga 2 Te 3 nanocrystals ranging from 30 to 200 nm coherently embedded into the PbTe matrix effectively weaken the phonon modes and scatter heat-carrying phonons, resulting in a significant reduction in κ lat .

36 MATERIALS SCIENCE↗
DOE OSTI2021

Polycrystalline SnSe with a thermoelectric figure of merit greater than the single crystal

Abstract Thermoelectric materials generate electric energy from waste heat, with conversion efficiency governed by the dimensionless figure of merit, ZT. Single-crystal tin selenide (SnSe) was discovered to exhibit a high ZT of roughly 2.2–2.6 at 913 K, but more practical and deployable polycrystal versions of the same compound suffer from much poorer overall ZT, thereby thwarting prospects for cost-effective lead-free thermoelectrics. The poor polycrystal bulk performance is attributed to traces of tin oxides covering the surface of SnSe powders, which increases thermal conductivity, reduces electrical conductivity and thereby reduces ZT. Here, we report that hole-doped SnSe polycrystalline samples with reagents carefully purified and tin oxides removed exhibit an ZT of roughly 3.1 at 783 K. Its lattice thermal conductivity is ultralow at roughly 0.07 W m –1 K –1 at 783 K, lower than the single crystals. The path to ultrahigh thermoelectric performance in polycrystalline samples is the proper removal of the deleterious thermally conductive oxides from the surface of SnSe grains. These results could open an era of high-performance practical thermoelectrics from this high-performance material.

36 MATERIALS SCIENCE↗
DOE OSTI2020

Ultralow Thermal Conductivity and Thermoelectric Properties of Rb 2 Bi 8 Se 13

Complex bismuth chalcogenides are narrow band gap semiconductors with intrinsic low thermal conductivity, which exhibit high potential as highly efficient thermoelectric materials. Here, we assess the basic thermoelectric properties of polycrystalline Rb 2 Bi 8 Se 13 in the temperature range 300-823 K as well as performance-optimizing strategies. We find that the as-made bulk samples are single phase with the monoclinic crystal structure (P2 1 /m) and crystallize in layer morphology. The pristine sample exhibits an exceedingly low lattice thermal conductivity of 0.6- 0.46 W·m -1 ·K -1 at 300-823 K, which derives from strong lattice anharmonicity, large Grüneisen parameters, and low phonon velocities induced by the complex crystal structure with heavy atom Bi and a large unit cell. Here, the Cl doping successfully enhances the carrier concentration in Rb 2 Bi 8 Se 13 with a negligible impact on the electronic band structure, displaying common doping behaviors. Se vacancy, on the contrary, leads to n-type doping and enhances the effective mass and power factors more significantly. Consequently, a maximum ZT of ~0.75 at 823 K for the 0.3% Se-vacancy-doped sample is obtained.

36 MATERIALS SCIENCE↗