Search NASA⌕ Search

Engineering topics

Lyzenga, D. R.

Publications and source records attributed to Lyzenga, D. R..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Numerical simulation of synthetic aperture radar image spectra for ocean waves

A numerical model for predicting the synthetic aperture radar (SAR) image of a moving ocean surface is described, and results are presented for two SIR-B data sets collected off the coast of Chile. Wave height spectra measured by the NASA radar ocean wave spectrometer (ROWS) were used as inputs to this model, and results are compared with actual SIR-B image spectra from orbits 91 and 106. Additional parametric variations are presented to illustrate the effects of nonlinearities in the imaging process.

Lyzenga, D. R.↗
NASA NTRS1986

Calibration of dual-frequency SAR ocean imagery

A calibration procedure for digital aircraft SAR imagery is presented. Techniques to utilize internal and external calibration references are discussed. Examples of calibrated intensity scans from an oceanographic test site are presented. The relationship of the aircraft SAR calibration procedure to future spaceborne SAR systems is discussed.

Kasischke, E. S.↗
NASA NTRS1985

SAR imaging of waves in water and ice - Evidence for velocity bunching

Synthetic aperture radar (SAR) images collected over the Arctic marginal ice zone show gravity wave patterns in both the open water and the ice. Diffuse wave patterns are visible in the water at near range (small incidence angles), while most distinct wave patterns are visible in the ice across the entire swath. The wave patterns in the ice appear as bright lines rather than sinusoidal intensity variations. Additionally, the images show a periodic displacement of the ice/water boundary, apparently due to Doppler shift effects associated with the gravity wave orbital motions. These observations are interpreted as evidence for the velocity bunching effect and also illustrate the effects of random scatterer motions in the open water.

Lyzenga, D. R.↗
NASA NTRS1985

Inversion problems in SAR imaging

Attention is given to two classes of SAR imaging inversion problems: fine resolution imagery of stationary scenes, and the imaging of a moving surface. Absolute scattering coefficient values are obtained from the output image by means of reference reflectors. The inversion of SAR data obtained from a moving surface requires consideration of motion effects in addition to those for the fixed scatterer; systematic displacements on a scale greater than the resolution result in azimuth shifts in the mapping of the scene onto the SAR image.

Larson, R. W.↗
NASA NTRS1984

SAR imagery of ocean-wave swell traveling in an arbitrary direction

The intensity wave like patterns observed in Synthetic Aperture Radar (SAR) are known to be caused by two mechanisms: the microwave radar cross sectional amplitude modulation due to tilt and hydrodynamic interaction of the long ocean waves, and intensity modulation due to the motion of the long ocean waves. Two dimensional closed form expressions of intensity wave patterns based on ocean wave swell are developed. They illustrate the relative importance of the amplitude and motion modulations; they also show that velocity bunching and a distortion due to the phase velocity of the ocean wave field are independent of the focus adjustment, provided that the second order temporal effects are neglected. Second order effects are small only over a limited range of ocean/radar parameters.

Rufenach, C. L.↗
NASA NTRS1984

Modeling of SAR signatures of shallow water ocean topography

A hydrodynamic/electromagnetic model was developed to explain and quantify the relationship between the SEASAT synthetic aperture radar (SAR) observed signatures and the bottom topography of the ocean in the English Channel region of the North Sea. The model uses environmental data and radar system parameters as inputs and predicts SAR-observed backscatter changes over topographic changes in the ocean floor. The model results compare favorably with the actual SEASAT SAR observed backscatter values. The developed model is valid for only relatively shallow water areas (i.e., less than 50 meters in depth) and suggests that for bottom features to be visible on SAR imagery, a moderate to high velocity current and a moderate wind must be present.

Shuchman, R. A.↗
NASA NTRS1983

Interpretation of synthetic aperture radar measurements of ocean currents

Synthetic Aperture Radar (SAR) experiments have been performed over the last few years to measure ocean currents inferred from shifts in the Doppler spectral peak. Interpretations of aircraft SAR measurements, when compared with limited surface values, tend to underestimate the currents by about 25%. A theory is developed that modifies the classical Doppler expression showing that the radar measurements are dependent on the radar processor (system) bandwidth and the received signal bandwidth. Measured bandwidths give a correction that increases the inferred current values by about 25%, bringing the measurements into good agreement. This new correction lends credence to the theory and increases the potential for application of SAR systems to future ocean current measurements. SAR measurements should include the determination of processor and signal bandwidths such that this correction can be applied.

Rufenach, C. L.↗
NASA NTRS1983

Remote sensing of oceanographic parameters pertinent to hydrocarbon resource development

Information obtained from remotely sensed imagery which is potentially useful to hydrocarbon resource development is discussed in this paper. Oceanic phenomena presented include surface gravity waves, detection of bathymetric features, and deep ocean internal waves. Techniques used to extract data are presented along with pertinent examples.

Kasischke, E. S.↗
NASA NTRS1983

Modeling of bottom-related surface patterns imaged by synthetic aperture radar

A hydrodynamic electromagnetic model is developed in order to provide a qualitative and quantitative description of the relationship between Seasat synthetic aperture radar (SAR) signatures and the bottom topography of the ocean in the English Channel region of the North Sea. The model is based on environmental data for winds, currents, and depth changes, and the SAR parameters of frequency polarization, incidence angle, and resolution cell size. The data are used as inputs and SAR backscatter changes are predicted for individual topographic changes on the ocean floor. It is found that the model estimates of backscatter values are in good agreement with actual Seasat SAR-observed backscatter values. A comparison of the model and actual data shows agreement to be within 1.5 dB. The model is considered to be valid for only shallow water areas (less than 50 meters in depth). It is suggested that for bottom features to be visible on SAR imagery at greater depths, a moderate-to-high velocity current of at least 0.4 m/s and a moderate wind no more than 7.5 m/sec must be present.

Lyzenga, D. R.↗
NASA NTRS1982

Evaluation of ERIM optically processed SEASAT SAR data

The results of three studies on the radiometric and geometric properties of optically processed SEASAT SAR imagery are summarized. The accuracy with which the image scale can be predicted based upon a knowledge of the SAR platform and recording system parameters and the processor characteristics was evaluated. The considerations involved in making radiometric measurements from image films, the use of point targets for calibrating the effects of Doppler spectrum shifts on the radiometric calibration of the SAR image data over extended swath lengths was evaluated

Shuchman, R. A.↗
NASA NTRS1982

Measurement of ocean surface currents by synthetic aperture radar

Synthetic aperture radar (SAR) is a coherent imaging device which uses the Doppler-induced phase changes of the received signals to locate scatterers in the along-track direction. In principle, the recorded data can be analyzed to obtain the radial velocity of moving objects in the scene relative to the flight path of the SAR platform. The application of this concept for measuring ocean surface currents has been evaluated using data from SAR systems mounted in aircraft and spacecraft platforms. This paper describes the results of these experiments and summarizes the limitations of the technique using existing SAR systems. Considerations involved in the design of optimum systems for this application are also discussed.

Lyzenga, D. R.↗
NASA NTRS1981

Exploitation of SAR data for measurement of ocean currents and wave velocities

Methods of extracting information on ocean currents and wave orbital velocities from SAR data by an analysis of the Doppler frequency content of the data are discussed. The theory and data analysis methods are discussed, and results are presented for both aircraft and satellite (SEASAT) data sets. A method of measuring the phase velocity of a gravity wave field is also described. This method uses the shift in position of the wave crests on two images generated from the same data set using two separate Doppler bands. Results of the current measurements are pesented for 11 aircraft data sets and 4 SEASAT data sets.

Shuchman, R. A.↗
NASA NTRS1981

Development of Great Lakes algorithms for the Nimbus-G coastal zone color scanner

A series of experiments in the Great Lakes designed to evaluate the application of the Nimbus G satellite Coastal Zone Color Scanner (CZCS) were conducted. Absorption and scattering measurement data were reduced to obtain a preliminary optical model for the Great Lakes. Available optical models were used in turn to calculate subsurface reflectances for expected concentrations of chlorophyll-a pigment and suspended minerals. Multiple nonlinear regression techniques were used to derive CZCS water quality prediction equations from Great Lakes simulation data. An existing atmospheric model was combined with a water model to provide the necessary simulation data for evaluation of the preliminary CZCS algorithms. A CZCS scanner model was developed which accounts for image distorting scanner and satellite motions. This model was used in turn to generate mapping polynomials that define the transformation from the original image to one configured in a polyconic projection. Four computer programs (FORTRAN IV) for image transformation are presented.

Tanis, F. J.↗
NASA NTRS1981

Verification of reflectance models in turbid waters

Inherent optical parameters of very turbid waters were used to evaluate existing water reflectance models. Measured upwelling radiance spectra and Monte Carlo simulations of the radiative transfer equations were compared with results from models based upon two flow, quasi-single scattering, augmented isotropic scattering, and power series approximation. Each model was evaluated for three separate components of upwelling radiance: (1) direct sunlight; (2) diffuse skylight; and (3) internally reflected light. Limitations of existing water reflectance models as applied to turbid waters and possible applications to the extraction of water constituent information are discussed.

Tanis, F. J.↗
NASA NTRS1976

Spectral reflectance and radiance characteristics of water pollutants

Spectral reflectance characteristics of water pollutants and water bodies were compiled using the existing literature. Radiance calculations were performed at satellite altitude for selected illumination angles and atmospheric conditions. The work described in this report was limited to the reflective portion of the spectrum between 0.40 micrometer to 1.0 micrometer.

Wezernak, C. T.↗
NASA NTRS1975

Nearshore coastal mapping

Two test sites of different water quality and bottom topography were used to test for maximum water depth penetration using the Skylab S-192 MSS for measurement of nearshore coastal bathymetry. Sites under investigation lie along the Lake Michigan coastline where littoral transport acts to erode sand bluffs and endangers developments along 1,200 miles of shore, and on the west coast of Puerto Rico where unreliable shoal location and depth information constitutes a safety hazard to navigation. The S-192 and S-190A and B provide data on underwater features because of water transparency in the blue/green portion of the spectrum. Depth of 20 meters were measured with the S-192 in the Puerto Rico test site. The S-190B photography with its improved spatial resolution clearly delineates the triple sand bar topography in the Lake Michigan test site. Several processing techniques were employed to test for maximum depth measurement with least error. The results are useful for helping to determine an optimum spectral bandwidth for future space sensors that will increase depth measurements for different water attenuation conditions where a bottom reflection is detectable.

Polcyn, F. C.↗