Engineering topics
Ma, Cheng
Publications and source records attributed to Ma, Cheng.
Single-atom-layer traps in a solid electrolyte for lithium batteries
In order to fully understand the lithium-ion transport mechanism in solid electrolytes for batteries, not only the periodic lattice but also the non-periodic features that disrupt the ideal periodicity must be comprehensively studied. At present only a limited number of non-periodic features such as point defects and grain boundaries are considered in mechanistic studies. Here, we discover an additional type of non-periodic feature that significantly influences ionic transport; this feature is termed a “single-atom-layer trap” (SALT). In a prototype solid electrolyte Li 0.33 La 0.56 TiO 3 , the single-atom-layer defects that form closed loops, i.e., SALTs, are found ubiquitous by atomic-resolution electron microscopy. According to ab initio calculations, these defect loops prevent large volumes of materials from participating in ionic transport, and thus severely degrade the total conductivity. This discovery points out the urgency of thoroughly investigating different types of non-periodic features, and motivates similar studies for other solid electrolytes.
Structure and Reactivity of Low-Rank Coal Chars Prepared from Fluidized Bed and Moving Bed Pyrolyzers and the Potential for Using Them in Pulverized Coal Injection (PCI)
Utilizing pyrolysis chars as the injection fuel in a blast furnace can reduce the dependence on high-quality pulverized coal injection (PCI) coal. In this study, the physical properties and reaction characteristics of chars prepared from two different industrial-scale pyrolyzers (fluidized bed and moving bed) are investigated. The results reveal remarkable component segregation in the char particles with different particle sizes. The properties of large-size char particles are found to better satisfy the PCI fuel requirement in a blast furnace. Compared with PCI coal, the char particles exhibit a rough surface, well-developed pore structure, and less-ordered chemical structure of carbon. Results from isothermal combustion, isothermal gasification, and drop tube furnace experiments show that both types of chars exhibit a better reactivity than PCI coal. The excellent reactivity of chars is closely related to its high Brunauer–Emmett–Teller surface area and relatively poor chemical ordering during conversion. Based on these characteristics, both fluidized bed char (FBC) and moving bed char (MBC) have a great potential to be used as PCI fuels. The application method of chars for PCI in a blast furnace is proposed finally.
Atomically Intimate Contact between Solid Electrolytes and Electrodes for Li Batteries
Not Available
Migration of Cobalt Species within Mixed Platinum-Cobalt Oxide Bifunctional Electrocatalysts in Alkaline Electrolytes
Bifunctional oxygen electrocatalysts have significant potentials for energy storage and conversion applications. Here we report a facile strategy toward bifunctional electrocatalysts by supporting mixed platinum and cobalt oxide nanoparticles on carbon black. The composite electrocatalyst (denoted as Pt+CoO x /C) is found to exhibit higher oxygen evolution reaction (OER) activity than CoOx/C, but slightly lower oxygen reduction reaction (ORR) activity than Pt/C in alkaline electrolytes. The bifunctional catalytic performance is ascribed to the in situ formation of heterogenous platinum-cobalt (hydro)oxide (Pt-CoO x H y ) interfaces under the electrochemical reaction conditions. Calculated electrochemical phase (Pourbaix) diagrams suggest that the migration of Co species was driven by the relative stability of Pt-CoO x H y interfaces versus bulk (hydroxy)oxides or aqueous ions of cobalt.
Elucidating the mobility of H + and Li + ions in (Li 6.25−x H x Al 0.25 )La 3 Zr 2 O 12 via correlative neutron and electron spectroscopy
Neutron and electron spectroscopy reveal diffusion behavior of individual ions in lithium garnets, paving the way towards high-performance aqueous lithium batteries.
The development of methods for primary mast cells in vitro and ex vivo: An historical review
Highlights: • Mast cells form a first-line defense of immune system against various challenges. • Over the past few decades, technologies for acquiring mast cells have been continually optimized. • The advantages and applicability of diverse mast cell models evaluated. • It is important to choose a proper cell source for mast cell-related experiments. Mast cells (MCs) are tissue-based stationary effector cells that form the immune system's first-line defense against various challenges. They are developed from the bone marrow-derived progenitors to complete their differentiation and maturation in the tissues where they eventually establish residence. MCs have been implicated in many diseases, such as allergy, parasitic infection, and neoplastic disorders. Immortalized MC lines, such as RBL-2H3, HMC-1, and LAD-2, are useful for investigating the biological functions of MC only to some extents due to the restriction of degranulation evaluation, in vivo injection and other factors. Over the past few decades, technologies for acquiring primarily MCs have been continually optimized, and novel protocols have been proposed. However, no relevant publications have analyzed and summarized these techniques. In this review, the classical approaches for extracting MCs are generalized, and new methods with potential values are introduced. We also evaluate the advantages and applicability of diverse MC models. Since MCs exhibit substantial plasticity and functional diversity due to different origins, it is both necessary and urgent to select a reliable and suitable source of MCs for a particular study.
Stable cycling of high-voltage lithium metal batteries in ether electrolytes
The development of functional electrolytes that are stable with both the lithium (Li) anode and the 4-V cathode is of significant importance to enable long-term cycling stability of high-voltage Li metal batteries. Due to their limited oxidative stability (< 4 V), ethers have been excluded from being used in high-voltage batteries for a long time, in spite of their superior reductive stability against Li metal compared to the conventional organic carbonate electrolytes. Here we report a concentrated dual-salt/ether electrolyte design that can form stable interfacial layers on both the high-voltage LiNi1/3Mn1/3Co1/3O2 cathode and the Li metal anode, thus realizing an unprecedented capacity retention >90% over 300 cycles with a charge cut-off voltage of 4.3 V. This study offers a promising approach to enabling ether electrolytes for high-voltage applications, expanding a new spectrum of solvent choices for high-voltage Li metal batteries.
Natural Product Micheliolide (MCL) Irreversibly Activates Pyruvate Kinase M2 and Suppresses Leukemia
Metabolic reprogramming of cancer cells is essential for tumorigenesis in which pyruvate kinase M2 (PKM2), the low activity isoform of pyruvate kinase, plays a critical role. Herein, we describe the identification of a nature-product-derived micheliolide (MCL) that selectively activates PKM2 through the covalent binding at residue cysteine424 (C424), which is not contained in PKM1. This interaction promotes more tetramer formation, inhibits the lysine433 (K433) acetylation, and influences the translocation of PKM2 into the nucleus. In addition, the pro-drug dimethylaminomicheliolide (DMAMCL) with similar properties as MCL significantly suppresses the growth of leukemia cells and tumorigenesis in a zebrafish xenograft model. Cell-based assay with knock down PKM2 expression verifies that the effects of MCL are dependent on PKM2 expression. DMAMCL is currently in clinical trials in Australia. Our discovery may provide a valuable pharmacological mechanism for clinical treatment and benefit the development of new anticancer agents.
Integrating Novel Microscopy into Battery Research: From Atomic Resolution to In Situ and Functional Imaging
Regardless of their different configurations and chemistries, current energy-storage systems, e.g. Li-ion, Li-S, Li-air, and all-solid-state Li batteries, rely on the use of solid-state ion conducting materials as electrodes and/or electrolytes. Continuous ion hopping from one mobile ion site to adjacent vacancy sites in a crystalline lattice forms the basis for ion conduction in solids. Atomic-scale factors, such as lattice structure and the concentration and distribution of mobile carriers and vacancies, decide the ion conductivity in solids, and thus dictate the rate capability and capacity in batteries.
Dimensionality Effects in FeGe 2 Nanowires: Enhanced Anisotropic Magnetization and Anomalous Electrical Transport
Here, we report the synthesis of single-crystal iron germanium nanowires via chemical vapor deposition without the assistance of any catalysts. The assembly of single-crystal FeGe 2 nanowires with tetragonal C16 crystal structure shows anisotropic magnetic behavior along the radial direction or the growth axial direction, with both antiferromagnetic and ferromagnetic orders. Single FeGe 2 nanowire devices were fabricated using e-beam lithography. Electronic transport measurement in these devices show two resistivity anomalies near 250 K and 200 K which are likely signatures of the two spin density wave states in FeGe 2 .
Impact of air exposure and surface chemistry on Li-Li 7 La 3 Zr 2 O 12 interfacial resistance
Li 7 La 3 Zr 2 O 12 (LLZO) is a promising solid-state electrolyte that could enable solid-state-batteries (SSB) employing metallic Li anodes. For a SSB to be viable, the stability and charge transfer kinetics at the Li–LLZO interface should foster facile plating and stripping of Li. Contrary to these goals, recent studies have reported high Li–LLZO interfacial resistance which was attributed to a contamination layer that forms upon exposure of LLZO to air. This study clarifies the mechanisms and consequences associated with air exposure of LLZO; additionally, strategies to minimize these effects are described. First-principles calculations reveal that LLZO readily reacts with humid air; the most favorable reaction pathway involves protonation of LLZO and formation of Li2CO3. X-ray photoelectron spectroscopy, scanning electron microscopy, Raman spectroscopy, and transmission electron microscopy were used to characterize the surface and subsurface chemistry of LLZO as a function of relative humidity and exposure time. Additionally, electrochemical impedance spectroscopy was used to measure the Li–LLZO interfacial resistance as a function of surface contamination. These data indicate that air exposure-induced contamination impacts the interfacial resistance significantly, when exposure time exceeds 24 h. The results of this study provide valuable insight into the sensitivity of LLZO to air and how the effects of air contamination can be reversed.
Plating Precious Metals on Nonprecious Metal Nanoparticles for Sustainable Electrocatalysts
Precious metals have broad applications in modern industry and renewable energy technologies. The high cost and limited availability of these materials, however, have caused a grand challenge for sustainability. In this work, we report on the plating of a precious metal on nonprecious metal nanoparticles for the development of sustainable electrocatalysts. Cobalt/platinum core/shell (denoted as Co@Pt) nanoparticles were synthesized via seed-mediated growth. The Co seeds were first synthesized by thermal decomposition of cobalt carbonyl, and the Pt shell was overgrown in situ by adding platinum acetylacetonate (Pt(acac) 2 ). The galvanic replacement reaction between Co and the Pt precursor was successfully suppressed by taking advantage of CO (generated from the decomposition of cobalt carbonyl) as the stabilizing ligand and/or reducing agent. Moreover, the obtained Co@Pt nanoparticles were found to exhibit enhanced catalytic activity for the oxygen reduction reaction (ORR).
High-Selectivity Electrochemical Conversion of CO 2 to Ethanol using a Copper Nanoparticle/N-Doped Graphene Electrode
Carbon dioxide is a pollutant, but also a potential carbon source provided an efficient means to convert it to useful products. Herein we report a nanostructured catalyst for the direct electrochemical reduction of dissolved CO 2 to ethanol with high Faradaic efficiency (63%) and high selectivity (84%). The catalyst is comprised of Cu nanoparticle on a highly textured, N-doped graphene film. Detailed electrochemical analysis and complementary DFT calculations indicate a novel mechanism in which multiple active sites, working sequentially, control the coupling of carbon monoxide radicals and mediate the subsequent electrochemical reduction to alcohol.
Tertiary and Quaternary Ammonium-Phosphate Ionic Liquids as Lubricant Additives
In this work we investigated the feasibility of five quaternary (aprotic) and four tertiary (protic) ammonium ionic liquids (ILs) with an identical organophosphate anion as lubricant antiwear additives. Viscosity, oil solubility, thermal stability, and corrosivity of the candidate ILs were characterized and correlated to the molecular structure. The protic group exhibits higher oil solubility than the aprotic group, and longer alkyl chains seem to provide better oil solubility and higher thermal stability. Selected ILs were applied as oil additives in steel-cast iron tribological tests and demonstrated promising anti-scuffing and anti-wear functionality. The thickness, nanostructure, coverage and composition of the tribofilm formed by the besting performing IL were revealed by surface characterization for mechanistic understanding of the tribochemical interactions between the IL and metal surface. Results provide fundamental insights of the correlations among the molecular structure, physiochemical properties and lubricating performance for ammonium-phosphate ILs.
Novel Solid Electrolytes for Li-Ion Batteries: A Perspective from Electron Microscopy Studies
Solid electrolytes can simultaneously overcome two of the most formidable challenges of Li-ion batteries: the severe safety issues and insufficient energy densities. However, before they can be implemented in actual batteries, the ionic conductivity needs to be improved and the interface with electrodes must be optimized. The prerequisite for addressing these issues is a thorough understanding of the material’s behavior at the microscopic and/or the atomic level. (Scanning) transmission electron microscopy is a powerful tool for this purpose, as it can reach an ultrahigh spatial resolution. Here, we review recent electron microscopy investigations on the ion transport behavior in solid electrolytes and their interfaces. Specifically, three aspects will be highlighted: the influence of grain interior atomic configuration on ionic conductivity, the contribution of grain boundaries, and the behavior of solid electrolyte/electrode interfaces. In conclusion, based on this, the perspectives for future research will be discussed.
Two-dimensional GaSe/MoSe 2 misfit bilayer heterojunctions by van der Waals epitaxy
Two-dimensional (2D) heterostructures hold the promise for future atomically-thin electronics and optoelectronics due to their diverse functionalities. While heterostructures consisting of different transition metal dichacolgenide monolayers with well-matched lattices and novel physical properties have been successfully fabricated via van der Waals (vdW) or edge epitaxy, constructing heterostructures from monolayers of layered semiconductors with large lattice misfits still remains challenging. Here, we report the growth of monolayer GaSe/MoSe 2 heterostructures with large lattice misfit by two-step chemical vapor deposition (CVD). Both vertically stacked and lateral heterostructures are demonstrated. The vertically stacked GaSe/MoSe 2 heterostructures exhibit vdW epitaxy with well-aligned lattice orientation between the two layers, forming an incommensurate vdW heterostructure. However, the lateral heterostructures exhibit no lateral epitaxial alignment at the interface between GaSe and MoSe 2 crystalline domains. Instead of a direct lateral connection at the boundary region where the same lattice orientation is observed between GaSe and MoSe 2 monolayer domains in lateral GaSe/MoSe 2 heterostructures, GaSe monolayers are found to overgrow MoSe 2 during CVD, forming a stripe of vertically stacked vdW heterostructure at the crystal interface. Such vertically-stacked vdW GaSe/MoSe 2 heterostructures are shown to form p-n junctions with effective transport and separation of photo-generated charge carriers between layers, resulting in a gate-tunable photovoltaic response. In conclusion, these GaSe/MoSe 2 vdW heterostructures should have applications as gate-tunable field-effect transistors, photodetectors, and solar cells.