Search NASA⌕ Search

Engineering topics

Ma, Hengjie

Publications and source records attributed to Ma, Hengjie.

AN INTERNET RACK MONITOR-CONTROLLER FOR APS LINAC RF ELECTRONICS UPGRADE

To support the research and development in APS LINAC area, the existing LINAC rf control performance needs to be much improved, and thus an upgrade of the legacy LINAC rf electronics becomes necessary. The proposed upgrade plan centers on the concept of using a modern, network-attached, rackmount digital electronics platform –Internet Rack Monitor-Controller (or IRMC) to achieve the goal of modernizing the rf electronics at a lower cost. The system model of the envisioned IRMC is basically a 3-tier stack with a high-performance DSP in the mid-layer to perform the core tasks of real-time rf data processing and controls. The Digital Front-End (DFE) attachment layer at bottom bridges the applicationspecific rf front-ends to the DSP. A network communication gateway, together with an embedded event receiver (EVR) in the top layer merges the Internet Rack MonitorController node into the networks of the accelerator controls infrastructure. Although the concept is very much in trend with today’s Internet-of-Things (IoT), this implementation has actually been used in the accelerators for over two decades.

Ma, Hengjie↗

SIMULATION STUDY AND INITIAL TEST OF THESNS RING RF SYSTEM

The rfsimulator code was developed for the study of the Spallation Neutron Source (SNS) dual-harmonic ring RF control. It uses time-domain solvers to compute beam-cavity interactions and FFT methods to simulate the time responses of the linear RF system. The important elements of the system considered in the model include beam loading, dynamic cavity detuning, circuit bandwidth, loop delay, proportional-integral controller for feedback and adaptive feed forward, stochastic noise, width-in-turn loop parameter change, beam current fluctuation, and bunch leakage. As the beam power increases, beam loss in the ring goes up and thus precise control of the bunching RF phase and amplitude is required to limit beam loss. The code will help in the development of a functional RF control and in achieving the goal of minimizing beam loss in the accumulator ring.

43 PARTICLE ACCELERATORS↗

TRANSIENT BEAM-LOADING DETECTION IN AN SNS CAVITY—SIMULATIONS AND INITIAL MEASUREMENTS

Beam phase measurement based on the detection of a transient beam-loading signal in an SC cavity has the potential to become a very fast linac tune-up technique, especially for an electron linac, as it may precisely set up the cavity s synchronous phase. A large signal-to-noise ratio is critical in the development of a transient detector technique. The paper discusses the study of a transient detector in the Spallation Neutron Source proton linac and the major challenge for this method: stochastic noise in the RF system, which reduces the precision and increases the time needed for accurate phase measurement. Using simulation studies with a beam-cavity model, signal measurement with the Low-Level RF system, and the experiment with prototype detectors, we analyzed the influence of noise on phase measurement.

43 PARTICLE ACCELERATORS↗