Search NASA⌕ Search

Engineering topics

Mack, L. M.

Publications and source records attributed to Mack, L. M..

13 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

The wave pattern produced by a point source on a rotating disk

It is pointed out that the boundary layer on a rotating disk is important in stability theory because it provides a particularly simple way to study the important phenomenon of crossflow instability. This type of instability is responsible for early transition on sweptback wings. Mack and Kendall (1983) have studied the wave patterns formed by harmonic point sources in a Blasius boundary layer on the basis that the source uniformly excites all oblique normal modes of the source frequency. The calculation procedure for planar boundary layers was modified to fit the different geometry of the rotating disk and the lack of an axis of symmetry. Calculations were performed of the wave pattern produced by a zero-frequency point source located at the Reynolds number of the artificial roughness element in an experiment conducted by Wilkinson and Malik (1983). The results provided in the present investigation confirm that the experimental wave pattern is a superposition of the complete azimuthal wavenumber spectrum of zero-frequency normal modes with uniform initial amplitude and phase.

Mack, L. M.↗
NASA NTRS1984

Remarks on disputed numerical results in compressible boundary-layer stability theory

Past work on the influence of Mach number on the viscous and inviscid instability of flat-plate boundary layers is reviewed, and new spatial calculations are presented. These calculations support the previous view that viscosity is only stabilizing for both two- and three-dimensional first-mode waves above M1 = 3.0, and for second-mode waves at all Mach numbers. It is concluded that the calculations of Wazzan, Taghavi, and Keltner that show viscous instability at M1 = 6.0 for first-mode 50 deg waves, and at M1 = 3.0 for two-dimensional second-mode waves, are not correct.

Mack, L. M.↗
NASA NTRS1984

Line sources of instability waves in a Blasius boundary layer

Numerical solutions of the instability wave pattern behind a harmonic point source in a Blasius boundary layer are used to form line sources by superposition. For infinite-length spanwise line sources of constant amplitude and phase, the result is just the two-dimensional normal mode of the same frequency; for a sinusoidal amplitude or linear phase distribution, the result is an oblique normal mode of the same spanwise wavenumber. A finite-length spanwise source simulates a vibrating ribbon. In a study of the influence of the source length on the downstream amplitude, the effective field of view is found to have a half-angle of about 16 deg. If the source tips are within this field, the amplitude may be either greater than or less than the comparable normal-mode amplitude, depending on the distance from the source and the spanwise location. For an oblique line source, the downstream wave development at each spanwise location is found to be close to, but not identical with, that of an oblique normal mode which originates at the source with the initial wave angle of the source and satisfies the irrotationality condition on the wavenumber vector.

Mack, L. M.↗
NASA NTRS1981

Compressible boundary-layer stability calculations for sweptback wings with suction

The stability of the laminar boundary layers on two transonic wings of infinite span with distributed suction is investigated with the compressible, parallel-flow stability theory. Both wings have supercritical airfoil sections; one has a sweep angle of 23 deg, the other of 35 deg. Zero-frequency disturbances are used to represent cross-flow instability, and disturbances with the wavenumber vector aligned with the local flow direction represent traveling-wave instability. In both cases, the maximum spatial amplification rate is used as a measure of the instability. For the suction, distributions with constant mass flux downstream of the starting point are used. The main objective is to determine how the maximum amplification rate varies with the magnitude and starting point of the suction. It is found for both types of disturbances that the maximum amplification rate varies almost linearly with the suction magnitude up to at least the point where the amplification rate is halved. Different starting locations for the suction in the first 4% of the chord were found to affect cross-flow instability, but to have little influence on traveling-wave instability.

Mack, L. M.↗
NASA NTRS1980

On the stabilization of three-dimensional boundary layers by suction and cooling

A significant reduction in the drag of transonic aircraft can be achieved by using an active method of boundary-layer control to maintain laminar flow on the aerodynamic surfaces. The stabilizing influence of suction for both favorable and adverse pressure gradients is demonstrated by means of the self-similar incompressible three-dimensional boundary layers on yawed wedges. Profile instability is measured by the maximum amplification rate of fixed-frequency disturbances computed according to linearized, locally parallel, spatial stability theory. Suction is found to be more effective in controlling Tollmien-Schlichting instability than stationary cross-flow disturbances. The effectiveness of surface cooling as a method of stabilization is compared with suction for the boundary layers on a transonic 35 deg swept wing of infinite span. It is found from compressible stability theory that when the surface is cooled to a uniform temperature such that the maximum cross-flow velocity is reduced by the same amount as with a uniform suction distribution, the stabilizing effect of cooling on cross-flow disturbances is less than with suction.

Mack, L. M.↗
NASA NTRS1979

On the stability of the boundary layer on a transonic swept wing

Both incompressible and compressible linear stability theory are applied to the three-dimensional compressible boundary layer on a particular transonic sweptback wing of infinite span. A spatial stability theory is used which identifies the growth direction with the real part of the complex angle of the group velocity. It is found that in the forward, but not the rear, crossflow instability region, the maximum amplification rates of the steady disturbances may be calculated to within about 10% by the incompressible stability theory. There is little difference between the sixth and eighth-order compressible theories. The maximum amplification rate of the steady disturbances at any chordwise station is closely related to the maximum crossflow at that station independent of the Reynolds number. For other than crossflow instability, there can be large differences between the incompressible and compressible theories, both as to the amplification rate and the angle of the wavenumber vector for maximum instability. Amplitude ratios of individual wave components are obtained by integrating the spatial amplification rate along the growth direction subject to the constraint that the wavenumber vector is irrotational. This procedure yields steady disturbances aligned with the local potential flow direction whose wavelengths are nearly independent of downstream distance.

Mack, L. M.↗
NASA NTRS1977

Transition and laminar instability

The linear stability theory was applied to the problem of boundary layer transition in incompressible flow. The theory was put into a form suitable for three-dimensional boundary layers; both the temporal and spatial theories were examined; and a generalized Gaster relation for three-dimensional boundary layers was derived. Numerical examples include the stability characteristics of Falkner-Skan boundary layers, the accuracy of the two-dimensional Gaster relation for these boundary layers, and the magnitude and direction of the group velocity for oblique waves in the Blasius boundary layer. Available experiments which bear on the validity of stability theory and its relation to transition are reviewed and the stability theory is applied to transition prediction. The amplitude method is described in which the wide band disturbance amplitude in the boundary layer is estimated from stability theory and an interaction relation for the initial amplitude density of the most unstable frequency.

Mack, L. M.↗
NASA NTRS1976

A numerical study of the temporal eigenvalue spectrum of the Blasius boundary layer

A numerical study is made of the temporal eigenvalue spectrum of the Orr-Sommerfeld equation for the Blasius boundary layer. Unlike channel flows, there is no mathematical proof that this flow has an infinite spectrum of discrete eigenvalues. The Orr-Sommerfeld equation is integrated numerically, and the eigenvalues located by tracing out the contour lines in the complex wave velocity plane on which the real and imaginary parts of the secular determinant are zero. The spectrum of plane Poiseuille flow is used as a guide to study the spectrum of an artificial two-wall flow which consists of two Blasius boundary layers. As the upper boundary of this flow moves to infinity, it is found that the portion of the spectrum with an infinite number of eigenvalues moves towards phase velocity equal to unity and the spacing between eigenvalues goes to zero. The original few eigenvalues found are the only discrete eigenvalues that exist for Blasius flow.

Mack, L. M.↗
NASA NTRS1975

A numerical method for the prediction of high-speed boundary-layer transition using linear theory

A method is described of estimating the location of transition in an arbitrary laminar boundary layer on the basis of linear stability theory. After an examination of experimental evidence for the relation between linear stability theory and transition, a discussion is given of the three essential elements of a transition calculation: (1) the interaction of the external disturbances with the boundary layer; (2) the growth of the disturbances in the boundary layer; and (3) a transition criterion. The computer program which carried out these three calculations is described. The program is first tested by calculating the effect of free-stream turbulence on the transition of the Blasius boundary layer, and is then applied to the problem of transition in a supersonic wind tunnel. The effects of unit Reynolds number and Mach number on the transition of an insulated flat-plate boundary layer are calculated on the basis of experimental data on the intensity and spectrum of free-stream disturbances. Reasonable agreement with experiment is obtained in the Mach number range from 2 to 4.5.

Mack, L. M.↗
NASA NTRS1974

On the application of linear stability theory to the problem of supersonic boundary-layer transition

Linear stability theory is used to calculate the amplitude ratio of constant-frequency disturbances as a function of Reynolds number for insulated and cooled-wall flat-plate boundary layers between Mach numbers 1.3 and 5.8. The growth curves are used to examine the consequences of using a fixed amplitude of the most unstable frequency as a transition criterion. The effect of free-stream Mach number on insulated-wall boundary layers is calculated, assuming that the initial disturbance level is constant, is proportional to the square of the free-stream Mach number and to the square root of the energy density of the one-dimensional power spectra of free-stream disturbances measured in supersonic wind tunnels.

Mack, L. M.↗
NASA NTRS1967

Mechanics of Boundary Layer Transition. Part 5: Boundary Layer Stability theory in incompressible and compressible flow

The fundamentals of stability theory, its chief results, and the physical mechanisms at work are presented. The stability theory of the laminar boundary determines whether a small disturbance introduced into the boundary layer will amplify or damp. If the disturbance damps, the boundary layer remains laminar. If the disturbance amplifies, and by a sufficient amount, then transition to turbulence eventually takes place. The stability theory establishes those states of the boundary layer which are most likely to lead to transition, identifys those frequencies which are the most dangerous, and indicates how the external parameters can best be changed to avoid transition.

Mack, L. M.↗