Search NASA⌕ Search

Engineering topics

Maksimchuk, A

Publications and source records attributed to Maksimchuk, A.

Investigation of relativistic intensity laser generated hot electron dynamics via copper K{sub α} imaging and proton acceleration

Simultaneous experimental measurements of copper K{sub α} imaging and the maximum target normal sheath acceleration proton energies from the rear target surface are compared for various target thicknesses. For the T-cubed laser (≈4 J, 400 fs) at an intensity of ≈2 × 10{sup 19} W cm{sup −2}, the hot electron divergence is determined to be θ{sub HWHM}≈22{sup °} using a K{sub α} imaging diagnostic. The maximum proton energies are measured to follow the expected reduction with increasing target thickness. Numerical modeling produces copper K{sub α} trends for both signal level and electron beam divergence that are in good agreement with the experiment. A geometric model describing the electron beam divergence reproduces the maximum proton energy trends observed from the experiment and the fast electron density and the peak electric field observed in the numerical modeling.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Experimental laser wakefield acceleration scalings exceeding 100 TW

Understanding the scaling of laser wakefield acceleration (LWFA) is crucial to the design of potential future systems. A number of computational and theoretical studies have predicted scalings with laser power for various parameters, but experimental studies have typically been limited to small parameter ranges. Here, we detail extensive measurements of LWFA experiments conducted over a considerable range in power from 20 to 110 TW, which allows for a greater plasma density range and for a large number of data points. These measurements include scalings of the electron beam charge and maximum energy as functions of density as well as injection threshold density, beam charge, and total beam energy as functions of laser power. The observed scalings are consistent with theoretical understandings of operation in the bubble regime.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

X-ray phase contrast imaging of biological specimens with femtosecond pulses of betatron radiation from a compact laser plasma wakefield accelerator

We show that x-rays from a recently demonstrated table top source of bright, ultrafast, coherent synchrotron radiation [Kneip et al., Nat. Phys. 6, 980 (2010)] can be applied to phase contrast imaging of biological specimens. Our scheme is based on focusing a high power short pulse laser in a tenuous gas jet, setting up a plasma wakefield accelerator that accelerates and wiggles electrons analogously to a conventional synchrotron, but on the centimeter rather than tens of meter scale. We use the scheme to record absorption and phase contrast images of a tetra fish, damselfly and yellow jacket, in particular highlighting the contrast enhancement achievable with the simple propagation technique of phase contrast imaging. Coherence and ultrafast pulse duration will allow for the study of various aspects of biomechanics.

43 PARTICLE ACCELERATORS↗

Comparison of bulk and pitcher-catcher targets for laser-driven neutron production

Laser-driven d(d, n)-{sup 3}He beam-target fusion neutron production from bulk deuterated plastic (CD) targets is compared with a pitcher-catcher target scheme using an identical laser and detector arrangement. For laser intensities in the range of (1-3) x 10{sup 19} W cm{sup -2}, it was found that the bulk targets produced a high yield (5 x 10{sup 4} neutrons per steradian) beamed preferentially in the laser propagation direction. Numerical modeling shows the importance of considering the temperature adjusted stopping powers to correctly model the neutron production. The bulk CD targets have a high background target temperature leading to a reduced stopping power for the deuterons, which increases the probability of generating neutrons by fusion. Neutron production from the pitcher-catcher targets was not as efficient since it does not benefit from the reduced stopping power in the cold catcher target. Also, the inhibition of the deuteron acceleration by a proton rich contamination layer significantly reduces the pitcher-catcher neutron production.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

High-power, kilojoule laser interactions with near-critical density plasma

Experiments were performed using the Omega EP laser, which provided pulses containing 1kJ of energy in 9ps and was used to investigate high-power, relativistic intensity laser interactions with near-critical density plasmas, created from foam targets with densities of 3-100 mg/cm{sup 3}. The effect of changing the plasma density on both the laser light transmitted through the targets and the proton beam accelerated from the interaction was investigated. Two-dimensional particle-in-cell simulations enabled the interaction dynamics and laser propagation to be studied in detail. The effect of the laser polarization and intensity in the two-dimensional simulations on the channel formation and electron heating are discussed. In this regime, where the plasma density is above the critical density, but below the relativistic critical density, the channel formation speed and therefore length are inversely proportional to the plasma density, which is faster than the hole boring model prediction. A general model is developed to describe the channel length in this regime.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Current Filamentation Instability in Laser Wakefield Accelerators

Experiments using an electron beam produced by laser-wakefield acceleration have shown that varying the overall beam-plasma interaction length results in current filamentation at lengths that exceed the laser depletion length in the plasma. Three-dimensional simulations show this to be a combination of hosing, beam erosion, and filamentation of the decelerated beam. This work suggests the ability to perform scaled experiments of astrophysical instabilities. Additionally, understanding the processes involved with electron beam propagation is essential to the development of wakefield accelerator applications.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

High-Power, Kilojoule Class Laser Channeling in Millimeter-Scale Underdense Plasma

Experiments were performed using the Omega EP laser, operating at 740 J of energy in 8 ps (90 TW), which provides extreme conditions relevant to fast ignition studies. A carbon and hydrogen plasma plume was used as the underdense target and the interaction of the laser pulse propagating and channeling through the plasma was imaged using proton radiography. The early time expansion, channel evolution, filamentation, and self-correction of the channel was measured on a single shot via this method. A channel wall modulation was observed and attributed to surface waves. After around 50 ps, the channel had evolved to show bubblelike structures, which may be due to postsoliton remnants.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Effects of Ionization in a Laser Wakefield Accelerator

Experimental results are presented from studies of the ionization injection process in laser wakefield acceleration using the Hercules laser with laser power up to 100 TW. Gas jet targets consisting of gas mixtures reduced the density threshold required for electron injection and increased the maximum beam charge. Gas mixture targets produced smooth beams even at densities which would produce severe beam breakup in pure He targets and the divergence was found to increase with gas mixture pressure.

43 PARTICLE ACCELERATORS↗

Formation of Optical Bullets in Laser-Driven Plasma Bubble Accelerators

Electron density bubbles generated in plasma of density n{sub e{approx}10{sup 19}/cm{sup 3}} are shown to reshape copropagating probe pulses into optical 'bullets'. The bullets, reconstructed by frequency-domain interferometric techniques, are used to visualize bubble formation independently of relativistic electron generation.

43 PARTICLE ACCELERATORS↗

The impact of contaminants on laser-driven light ion acceleration

The impact of contaminants on laser-driven ion acceleration is investigated using particle-in-cell simulations. The conventional ion acceleration mechanism, target normal sheath acceleration, has been revisited for targets with proton-rich contaminants in the form of water vapor. The targets considered have a deuterated plastic layer on the rear surface of an aluminum target, and the influence of the contaminant layer on the deuteron acceleration is investigated. In the early stage of ion acceleration, the space-charge electrostatic field on the rear target surface accelerates only the outermost, proton-rich layer of ions, which inhibits the deuteron acceleration by shielding it from the field. When the proton layer is depleted, the deuterons become exposed to the space-charge field and are promptly accelerated. This scenario was tested with a two-dimensional particle-in-cell simulation model by varying the contaminant layer thickness and laser fluence (laser energy per unit area). For laser fluences F{sub laser}<1 J/{mu}m{sup 2}, the contamination layer over the surface inhibits the deuteron acceleration from the rear surface, while in the opposite case of laser fluences F{sub laser}>1 J/{mu}m{sup 2} deuterons and heavier ions can be successfully accelerated with conversion efficiency of laser energy into ions of more than 1%. Experimental data from a 6 {mu}m thick aluminum foil coated with a 1 {mu}m deuterated plastic layer on the back surface are suggestive of the detrimental role of contaminants on deuteron acceleration.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Stimulated Raman Side Scattering in Laser Wakefield Acceleration

Stimulated Raman side scattering of an ultrashort high power laser pulse is studied in experiments on laser wakefield acceleration. Experiments and simulations reveal that stimulated Raman side scattering occurs at the beginning of the interaction, that it contributes to the evolution of the pulse prior to wakefield formation, and also that it affects the quality of electron beams generated. The relativistic shift of the plasma frequency is measured.

43 PARTICLE ACCELERATORS↗

Formation of Optical Bullets in Laser-Driven Plasma Bubble Accelerators

Electron density bubbles--wake structures generated in plasma of density n{sub e{approx}}10{sup 19} cm{sup -3} by the light pressure of intense ultrashort laser pulses--are shown to reshape weak copropagating probe pulses into optical 'bullets'. The bullets are reconstructed using frequency-domain interferometric techniques in order to visualize bubble formation. Bullets are confined in three dimensions to plasma-wavelength size, and exhibit higher intensity, broader spectrum and flatter temporal phase than surrounding probe light, evidence of their compression by the bubble. Bullets observed at 0.8 < or approx. n{sub e} < or approx. 1.2x10{sup 19} cm{sup -3} provide the first observation of bubble formation below the electron capture threshold. At higher n{sub e}, bullets appear with high shot-to-shot stability together with relativistic electrons that vary widely in spectrum, and help relate bubble formation to fast electron generation.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Ionization Induced Trapping in a Laser Wakefield Accelerator

Experimental studies of electrons produced in a laser wakefield accelerator indicate trapping initiated by ionization of target gas atoms. Targets composed of helium and controlled amounts of various gases were found to increase the beam charge by as much as an order of magnitude compared to pure helium at the same electron density and decrease the beam divergence from 5.1+-1.0 to 2.9+-0.8 mrad. The measurements are supported by particle-in-cell modeling including ionization. This mechanism should allow generation of electron beams with lower emittance and higher charge than in preionized gas.

43 PARTICLE ACCELERATORS↗

Guiding of 35 TW laser pulses in ablative capillary discharge waveguides

An ablatively driven capillary discharge plasma waveguide has been used to demonstrate guiding of 30 fs, 35 TW laser pulses over distances up to 3 cm with incident intensity in excess of 4x10{sup 18} W/cm{sup 2}. The plasma density range over which good guiding was observed was 1-3x10{sup 18} cm{sup -3}. The quality of the laser spot at the exit mode was observed to be similar to that at the entrance and the transmitted energy was {approx}25% at input powers of 35 TW. The transmitted laser spectrum typically showed blueshifting due to ionization of carbon and hydrogen atoms in the capillary plasma by the high intensity laser pulse. The low plasma density regime in which these capillaries operate makes these devices attractive for use in single stage electron accelerators to multi-GeV energies driven by petawatt class laser systems.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Laser Wakefield Acceleration Experiments Using HERCULES Laser

Laser wakefield acceleration (LWFA) in a supersonic gas-jet using a self-guided laser pulse was studied by changing laser power and plasma electron density. The recently upgraded HERCULES laser facility equipped with wavefront correction enables a peak intensity of 6.1x10{sup 19} W/cm{sup 2} at laser power of 80 TW to be delivered to the gas-jet using F/10 focusing optics. We found that electron beam charge was increased significantly with an increase of laser power from 30 TW to 80 TW and showed density threshold behavior at a fixed laser power. We also studied the influence of laser focusing conditions by changing the f-number of the optics to F/15 and found an increase in density threshold for electron production compared to the F/10 configuration. The analysis of different phenomena such as betatron motion of electrons, side scattering of the laser pulse for different focusing conditions, the influence of plasma density down ramp on LWFA are shown.

43 PARTICLE ACCELERATORS↗