Malamis, Sotirios A. | Search NASA

DOE OSTI2021

Coupled uptake and conversion of C 12 H 26 and NO on Pd/SSZ-13: Experiments and modeling

The uptake of NO in the presence of C 12 H 26 (dodecane) and H 2 O over a Pd/SSZ-13 washcoated Passive NOx Adsorber (PNA) monolith is reported. When a co-feed containing C 12 H 26 and NO is supplied to an unsaturated (with C 12 H 26 ) sample, the NO uptake is unaffected but during the subsequent temperature ramp the release of trapped NO is delayed from 175°C to over 220°C. The release delay is beneficial for PNA performance as the primary NO x aftertreatment technology, Selective Catalytic Reduction (SCR), is not operated below 200°C. However, pre-saturation of C 12 H 26 followed by the same NO and C 12 H 26 co-feed results in a decrease in the NO uptake compared to the NO-only feed. We conjecture that C 12 H 26 pre-adsorbed on the exterior surface of the sample blocks NO access to the pores, decreasing the number of available sites for NO uptake. Oxidation of C 12 H 26 leads to the generation of partial oxidation product CO at lower temperatures (<250°C) and deep oxidation product CO 2 at higher temperatures. Carbon monoxide binds strongly to Pd sites with NO and can delay NO release. A Pd/SSZ-13 washcoated monolith model developed in an earlier study [Ambast et al., Appl. Catal. B. Environmental (2021)] is upgraded to include C 12 H 26 storage, release, and conversion. Through a systematic combination of judicious experiments, model tuning, and validation, we provide evidence for the underlying NO uptake and release mechanisms in the presence of C 12 H 26 .

42 ENGINEERING↗

DOE OSTI2021

Optimizing the lean hydrocarbon NO x trap: Sequential and dual-layer configurations

Vehicular emission control catalysts are ineffective in eliminating CO, hydrocarbons, and NO x during engine cold-start when exhaust temperatures are below 200 °C. In this study the performance of coupled low temperature NO x , n-C 12 H 26 (C 12 ), and C 3 H 6 trapping, release and conversion for a series of model Lean Hydrocarbon NO x Trap (LHCNT) catalysts are examined. Pd and Pt supported on small-pore (SSZ-13) and large-pore (BEA) zeolites are selected based on the performance during transient NO and C 12 uptake, release and conversion experiments. These catalysts are combined into sequential (Pt + Pd/BEA → Pd/SSZ-13; Pd/SSZ-13 → Pt + Pd/BEA) and dual-layer (Pt + Pd/BEA top, Pd/SSZ-13 bottom) configurations in an attempt to improve the trapping and conversion performance. While all three configurations trap between 75 and 100 μmolNO x /g-cat, the Pd/SSZ-13 → Pt + Pd/BEA sequential configuration is most effective in simultaneously trapping C 12 and NO in the presence of H 2 O, resulting in excellent NO and C 12 storage below 100 °C with release and/or conversion at or above 200 °C. For each configuration, C 12 oxidation lights-off below 300 °C and NO oxidation achieves ~35 % conversion in the absence of C 12 . Neither the presence of C 12 nor the order of the sequential configuration has a significant impact on NO uptake. C 12 significantly delays NO and NO 2 desorption to temperatures exceeding 300 °C. The more compact dual-layer catalyst is most effective in forming NO 2 as the release temperature lines up with the maximum NO conversion temperature but traps less C 12 than the sequential configurations. The addition of C 3 H 6 in the feed on the dual-layer catalyst leads to further delay in the NO x desorption as well as increased NO and C 12 conversion at high temperatures. Here, the overall findings provide guidance in the optimizing LHCNT configuration for realistic feeds.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗