Search NASA⌕ Search

Engineering topics

Maloy, S.

Publications and source records attributed to Maloy, S..

VTR Fuel Design

VTR fuel design presentation for the May 25, 2021 VTR quarterly integration meeting

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Future Nuclear Energy Factual Status Document: Resource Document for the Workshop on Basic Research Needs for Future Nuclear Energy, July 2017

Since commercialization in the mid-1950s, nuclear power has been widely deployed and provides an important clean source of energy, primarily through the generation of electricity. There are currently 449 commercial nuclear power reactors operating in 31 countries with over 390 GWe total capacity, with 99 operating units in the United States with a total generating capacity of about 100 GWe. Nuclear power plants provide over 11% of the world’s electricity production and, as of 2016, thirteen countries rely on nuclear energy to supply at least one-quarter of their total electricity. Virtually all of that power is generated with water-cooled reactor systems. A number of advanced nuclear energy system concepts have been developed to provide improved efficiency, greater fissile fuel utilization, reduced high level waste generation, and increased margins of safety over today’s water-cooled systems. However, there are a number of technical challenges that must be addressed to enable the broad deployment of these systems from concept to the electrical grid. This Technical Document is written to provide workshop participants with an overview of the current status of a number of advanced reactor systems: Key issues for advanced nuclear energy, including coolants, materials in extremes (irradiation, coolant, and/or high temperature) and interfaces; Nuclear fuel technologies for key reactor types and limitations in testing and design; State of science and understanding for nuclear systems, including characterization, testing, and modeling and simulation tools. For each of these technical areas, this document describes the technological challenge, current state of the art for the technology, and barriers to advanced nuclear concepts.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Decommissioning and PIE of the MEGAPIE spallation target

A key experiment in the Accelerated Driven Systems roadmap, the MEGAwatt PIlot Experiment (MEGAPIE) (1 MW) was initiated in 1999 in order to design and build a liquid lead-bismuth spallation target, then to operate it into the Swiss spallation neutron facility SINQ at Paul Scherrer Institute. The target has been designed, manufactured, and tested during integral tests, before irradiation carried out end of 2006. During irradiation, neutron and thermo hydraulic measurements were performed allowing deep interpretation of the experiment and validation of the models used during design phase. The decommissioning, Post Irradiation Examinations and waste management phases were defined properly. The phases dedicated to cutting, sampling, cleaning, waste management, samples preparation and shipping to various laboratories were performed by PSI teams: all these phases constitute a huge work, which allows now to perform post-irradiation examination (PIE) of structural material, irradiated in relevant conditions. Preliminary results are presented in the paper, they concern chemical characterization. The following radio-nuclides have been identified by γ-spectrometry: {sup 60}Co, {sup 101}Rh, {sup 102}Rh, {sup 108m}Ag, {sup 110m}Ag, {sup 133}Ba, {sup 172}Hf/Lu, {sup 173}Lu, {sup 194}Hg/Au, {sup 195}Au, {sup 207}Bi. For some of these nuclides the activities can be easily evaluated from γ-spectrometry results ({sup 207}Bi, {sup 194}Hg/Au), while other nuclides can only be determined after chemical separations ({sup 108m}Ag, {sup 110m}Ag, {sup 195}Au, {sup 129}I, {sup 36}Cl and α-emitting {sup 208-210}Po). The concentration of {sup 129}I is lower than expected. The chemical analysis already performed on spallation and corrosion products in the lead-bismuth eutectic (LBE) are very relevant for further applications of LBE as a spallation media and more generally as a coolant.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗

Phylogenetic placement of the Spirosomaceae

Comparative analysis of 16S rRNA sequences shows that the family Spirosomaceae belongs within the eubacterial phylum defined by the flavobacteria and bacteriodes. Its constituent genera, Spirosoma, Flectobacillus, and Runella form a monophyletic grouping therein. The phylogenetic assignment is based not only upon evolutionary distance analysis, but also upon sequence signatures and higher order structural synapomorphies in 16S rRNA. Another genus peripherally associated with the Spirosomaceae, Ancylobacter ("Microcyclus"), does not cluster with the flavobacteria and their relatives, but rather belongs to the alpha subdivision of the purple bacteria.

NASA Discipline Number 52-30↗