Engineering topics
Publications and source records attributed to Mandell, Avi.
Transmission spectroscopy is one of our primary tools for measuring the structure and composition of exoplanet atmospheres, especially for close-in exoplanets. During an exoplanet transit part of the host stars' light passes through the planet's atmosphere imparting atomic and molecular absorption features on top of the stellar spectrum.
Exoplanet Transmission Spectroscopy with LUVOIR
Future mission concepts such as LUVOIR and HabEx have baselined integral field spectrographs (IFS) for their coronagraph instruments. Exoplanet detection with an IFS has strong heritage at ground observatories, but to support future missions the WFIRST coronagraph instrument (CGI) must demonstrate the ability to measure exoplanet spectra with an IFS approaching contrast levels sufficient for future missions. The spectral resolution of the CGI IFS is R50 over a 20% bandpass within 600 and 970 nm. The bands and spectral resolution optimize signal-to-noise against sufficient sampling of methane absorption features expected in the exoplanet atmosphere. In addition to demonstrating on-orbit high contrast with the IFS, showing sufficient stability over very long observing periods with time resolved data in simultaneous spatial and spectral dimensions is key to the IFS demonstration. We present the impact of long durations and tight tolerances, how they drive the IFS design and performance.
We propose a high precision calibration scheme for a Mid-IR Exoplanet Spectrometer. This new technology will enable high-precision transmission, emission, and phase curve spectroscopy for the characterization of exoplanets in and near the habitable zone, enabling the detection of biosignatures in rocky planets around the nearest M dwarfs.
One important aspect of the WFIRST coronagraphic instrument (CGI) technology demonstration is its ability to take high contrast spectra with an integral field spectrograph (IFS). Future missions such as LUVOIR and HabEx rely on IFS technologies for the spectral characterization of any objects they discover; spectral characterization is the core science of their exoplanet imaging instruments. The CGI IFS, being designed and built and Goddard Space Flight Center, has a spectral resolution of R50 and is designed to accommodate a 20% bandpass spanning 600-970nm. The bands and spectral resolution were chosen by the science investigation teams to target key methane absorption features, with the aim of constraining abundances. For CGI as a technology demonstration, these are the minimum set of defining features to demonstrate on-orbit wavefront control with an IFS capable of producing science. The ability to close a wavefront control loop around an IFS, maintain a stable dark hole, and provide time resolved data that simultaneously spans spatial and spectral dimensions are crucial demonstrations for future observatories. We highlight the IFS requirements and how the on-orbit calibration is handled. We also provide further detail on the optomechanical design, its stability based on thermal and structural predictions, anticipated performance, and operations concept of the CGI IFS.
Future NASA concept missions that are currently under study, like the Habitable Exoplanet Imaging Mission (HabEx) and the Large Ultra-violet Optical Infra Red Surveyor (UVOIR), could discover a large diversity of exoplanets. We propose here a classification scheme that distinguishes exoplanets into different categories based on their size and incident stellar flux, for the purpose of providing the expected number of exoplanets observed (yield) with direct imaging missions. The boundaries of this classification can be computed using the known chemical behavior of gases and condensates at different pressures and temperatures in a planetary atmosphere. In this study, we initially focus on condensation curves for sphalerite ZnS, H2O, CO2, and CH4. The order in which these species condense in a planetary atmosphere define the boundaries between different classes of planets. Broadly, the planets are divided into rocky planets (0.5-1.0 solar radius), super-Earths (1.0-1.75 solar radius), sub-Neptunes (1.75-3.5 solar radius), sub-Jovians (3.5-6.0 solar radius), and Jovians (6-14.3 solar radius) based on their planet sizes, and "hot," "warm," and "cold" based on the incident stellar flux. We then calculate planet occurrence rates within these boundaries for different kinds of exoplanets, eta (sub planet) [i.e. exoplanet], using the community coordinated results of NASA's Exoplanet Program Analysis Group's Science Analysis Group-13 (SAG-13). These occurrence rate estimates are in turn used to estimate the expected exoplanet yields for direct imaging missions of different telescope diameters.
Aims: Previous secondary eclipse observations of the hot Jupiter Qatar-1B in the Ks band suggest that it may have an unusually high day-side temperature, indicative of minimal heat redistribution. There have also been indications that the orbit may be slightly eccentric, possibly forced by another planet in the system. We investigate the day-side temperature and orbital eccentricity using secondary eclipse observations with Spitzer. Methods: We observed the secondary eclipse with Spitzer/IRAC (Infrared Array Camera) in subarray mode, in both 3.6 and 4.5 micron wavelengths. We used pixel-level de-correlation to correct for Spitzer's intra-pixel sensitivity variations and thereby obtain accurate eclipse depths and central phases. Results: Our 3.6 micron eclipse depth is 0.149 plus or minus 0.051 percent and the 4.5 micron depth is 0.273 plus or minus 0.049 percent. Fitting a blackbody planet to our data and two recent Ks band eclipse depths indicates a brightness temperature of 1506 plus or minus 71 degrees Kelvin. Comparison to model atmospheres for the planet indicates that its degree of longitudinal heat redistribution is intermediate between fully uniform and day-side only. The day-side temperature of the planet is unlikely to be as high (1885 degrees Kelvin) as indicated by the ground-based eclipses in the Ks band, unless the planet's emergent spectrum deviates strongly from model atmosphere predictions. The average central phase for our Spitzer eclipses is 0.4984 plus or minus 0.0017, yielding [a model parameter] e cos omega equal to minus 0.0028 plus or minus 0.0027. Our results are consistent with a circular orbit, and we constrain e cos omega much more strongly than has been possible with previous observations.
Direct Imaging of exoplanets using a coronagraph has become a major field of research both on the ground and in space. Key to the science of direct imaging is the spectroscopic capabilities of the instrument, our ability to extract spectra, and measure the abundance of molecular species such as Methane. To take these spectra, the WFIRST coronagraph instrument (CGI) uses an integral field spectrograph (IFS), which encodes the spectrum into a two-dimensional image on the detector. This results in more efficient detection and characterization of targets, and the spectral information is critical to achieving detection limits below the speckle floor of the imager. The CGI IFS operates in two18% bands spanning 600nm to 840nm at a nominal spectral resolution of R50. We present the current science and engineering requirements for the IFS design, the instrument design, anticipated performance, and how the calibration is integrated into the focal plane wavefront control algorithms. We also highlight the role of the Prototype Imaging Spectrograph for Coronagraphic Exoplanet Studies (PISCES) at the JPL High Contrast Imaging Testbed to demonstrate performance and validate calibration methodologies for the flight instrument.
We create the first quantitative model for the early lunar atmosphere, coupled with a magma ocean crystallization model. Immediately after formation, the moon's surface was subject to a radiative environment that included contributions from the early Sun, a post-impact Earth that radiated like a mid-type M dwarf star, and a cooling global magma ocean. This radiative environment resulted in a largely Earth-side atmosphere on the Moon, ranging from approximately 10(exp 4) to approximately 10(exp 2) pascals, composed of heavy volatiles (Na and SiO). This atmosphere persisted through lid formation and was additionally characterized by supersonic winds that transported significant quantities of moderate volatiles and likely generated magma ocean waves. The existence of this atmosphere may have influenced the distribution of some moderate volatiles and created temperature asymmetries which influenced ocean flow and cooling. Such asymmetries may characterize young, tidally locked rocky bodies with global magma oceans and subject to intense irradiation.
Based on the experience from Prototype Imaging Spectrograph for Coronagraphic Exoplanet Studies (PISCES) for WFIRST, we have moved to the flight instrument design phase. The specifications for flight IFS have similarities and differences from the prototype. This paper starts with the science and system requirement, discusses a number of critical trade-offs: such as IFS type selection, lenslet array shape and layout versus detector pixel accuracy, how to accommodate the larger Field Of View (FOV) and wider wavelength band for a potential add-on StarShade occulter. Finally, the traditional geometric optical design is also investigated and traded: reflective versus refractive, telecentric versus non-telecentric relay. The relay before the lenslet array controls the chief angle distribution on the lenslet array. Our previous paper has addressed how the relay design combined with lenslet arraypinhole mask can further compress the residual star light and increase the contrast. Finally, a complete phase A IFS optical design is presented.
Since the beginning of modern astronomical science in the early 1900s, astronomers have yearned to escape the turbulence and absorption of Earth's atmosphere by placing observatories in space. One of the first papers to lay out the advantages of space astronomy was by Lyman Spitzer in 1946, "Astronomical Advantages of an Extra-Terrestrial Observatory," though later in life he minimized the influence of this work. Since that time, and especially gaining momentum in the 1960s after the launch of Sputnik, astronomers, technologists, and engineers continued to advance, organizing scientific conferences, advocating for necessary technologies, and assessing sophisticated designs for increasingly ambitious space observations at ultraviolet, visual, and infrared (UVOIR) wavelengths. These community-wide endeavors, combined with the explosion in technological capability enabled by the Apollo era, led to rapid advancement in space observatory performance that culminated in the spectacularly successful Hubble Space Telescope (HST), launched in 1990 and still returning surpassing scientific results.
We present nine "tech notes" prepared by the Large UV/Optical/Infrared (LUVOIR) Science and Technology Definition Team (STDT), Study Office, and Technology Working Group. These tech notes are intended to highlight technical challenges that represent boundaries in the trade space for developing the LUVOIR architecture that may impact the science objectives being developed by the STDT. These tech notes are intended to be high-level discussions of the technical challenges and will serve as starting points for more in-depth analysis as the LUVOIR study progresses.
Engineering analysis has been carried out on orbit dynamics that drive the delta-v budget for repointing a free-flying starshade occulter for viewing exoplanets with a space telescope. This analysis has application to the design of starshade spacecraft and yield calculations of observations of exoplanets using a space telescope and a starshade. Analysis was carried out to determine if there may be some advantage for the global delta-v budget if the telescope performs orbit changing delta-v maneuvers as part of the telescope-starshade alignment for observing exoplanets. Analysis of the orbit environmental forces at play found no significant advantage in having the telescope participate in delta-v maneuvers for exoplanet observation repointing. A separate analysis of starshade delta-v for repointing found that the orbit dynamics of the starshade is driven by multiple simultaneous variables that need to be considered together in order to create an effective estimate of delta-v over an exoplanet observation campaign. These include area of the starshade, dry mass of the starshade spacecraft, and propellant mass of the starshade spacecraft. Solar radiation pressure has the potential to play a dominant role in the orbit dynamics and delta-v budget. SRP effects are driven by the differences in the mass, area, and coefficients of reflectivity of the observing telescope and the starshade. The propellant budget cannot be effectively estimated without a conceptual design of a starshade spacecraft including the propulsion system. The varying propellant mass over the mission is a complexity that makes calculating the propellant budget less straightforward.
The yield of Earth-like planets will likely be a primary science metric for future space-based missions that will drive telescope aperture size. Maximizing the exoEarth candidate yield is therefore critical to minimizing the required aperture. Here we describe a method for exoEarth candidate yield maximization that simultaneously optimizes, for the first time, the targets chosen for observation, the number of visits to each target, the delay time between visits, and the exposure time of every observation. This code calculates both the detection time and multiwavelength spectral characterization time required for planets. We also refine the astrophysical assumptions used as inputs to these calculations, relying on published estimates of planetary occurrence rates as well as theoretical and observational constraints on terrestrial planet sizes and classical habitable zones. Given these astrophysical assumptions, optimistic telescope and instrument assumptions, and our new completeness code that produces the highest yields to date, we suggest lower limits on the aperture size required to detect and characterize a statistically motivated sample of exoEarths.
The National Aeronautics and Space Administration (NASA), along with the rest of government and the nation have become increasing cost conscious in recent years. This has resulted in renewed efforts at finding ways to do more with less. Planetary science is no exception. The 2013 Decadal Survey for Planetary Science made great efforts to understand the costs of proposed missions. The community has been asked to develop more affordable versions of mission concepts, especially in the flagship category. Many in the community continue to encourage NASA to prioritize lower cost missions at a more frequent cadence over fewer but larger missions. This presentation discusses a new tool in the planetary science arsenal to achieve a broad set of planetary science questions at costs that are lower, and in some cases dramatically lower, than other options in the past. Technology advances in pointing systems and the growing capabilities of stratospheric balloons, such as the ultra-long duration flights, have caught the attention of many in the planetary science community. A workshop was held in January 2012 to help planetary scientists and NASA better understand the capabilities of balloon borne platforms, along with their strengths and limitations. Perhaps most importantly, the workshop focused on the potential science that could be achieved. The science and engineering participants discussed what, if any, science can be achieved and why or how balloon platforms would offer an advantage. Since that first workshop, not only have further discussions and studies occurred within the community, but demonstration missions have been flown with compelling results. These balloon missions have shown that the science envisioned can indeed be achievable, that balloon platforms do offer some unique advantages; and that repeated flights can be implemented at relatively low cost. The presentation briefly summarizes the potential science and the characteristics of a balloon based observatory that make it desirable for some science investigations. The recent missions are described along with some of their challenges and achievements. Finally, a brief summary of options moving forward are considered.
We present a new and innovative near-infrared multi-band ultraprecise spectroimager (NIMBUS) for SOFIA. This instrument will enable many exciting observations in the new age of precision astronomy. This optical design splits the beam into 8 separate spectral bandpasses, centered around key molecular bands from 1 to 4 microns. Each spectral channel has a wide field of view for simultaneous observations of a reference star that can decorrelate time-variable atmospheric and optical assembly effects, allowing the instrument to achieve ultraprecise photometry for a wide variety of astrophysical sources
"High-resolution NIR spectroscopic observations of warm molecular gas emission from young circumstellar disks allow us to constrain the temperature and composition of material in the inner planet-forming region. By combining advanced data reduction algorithms with accurate modeling of the terrestrial atmospheric spectrum and a novel double-differencing data analysis technique, we have achieved very high-contrast measurements (S/N approx. 500-1000) of molecular emission at 3 microns. In disks around low-mass stars, we have achieved the first detections of emission from HCN and C2H2 at near-infrared wavelengths from several bright T Tauri stars using the CRIRES spectrograph on the Very Large Telescope and NIRSPEC spectrograph on the Keck Telescope. We spectrally resolve the line shape, showing that the emission has both a Keplerian and non-Keplerian component as observed previously for CO emission. We used a simplified single-temperature local thermal equilibrium (LTE) slab model with a Gaussian line profile to make line identifications and determine a best-fit temperature and initial abundance ratios, and we then compared these values with constraints derived from a detailed disk radiative transfer model assuming LTE excitation but utilizing a realistic temperature and density structure. Abundance ratios from both sets of models are consistent with each other and consistent with expected values from theoretical chemical models, and analysis of the line shapes suggests that the molecular emission originates from within a narrow region in the inner disk (R < 1 AU)."