Engineering topics

Mangalam, S. M.

Publications and source records attributed to Mangalam, S. M..

18 records

NASA NTRS1992

A new approach to high-speed flow measurements using constant voltage anemometry

The paper addresses the basic features of conventional instrumentation, such as the constant temperature (CTA) and the constant current (CCA) anemometers, their limitations, and describes a totally new approach to high-speed dynamic measurements using a constant voltage anemometer (CVA). The paper describes the design features of a newly developed CVA and compares preliminary results obtained with CVA and conventional anemometry in low- and high-speed flows.

Mangalam, S. M.↗

NASA NTRS1992

In-flight detection of flow separation, stagnation, and transition

Flight tests were conducted to demonstrate the feasibility of simultaneous determination of: (1) boundary-layer instability and transition characteristics; (2) flow separation region; and (3) the location of the leading-edge stagnation point. Surface mounted, multi-element, micro-thin, hot-film sensors were used in conjunction with a bank of constant-temperature anemometers and a PC-based 8-channel simultaneous data acquisition system. Conventional techniques were used to determine the boundary-layer instability and transition characteristics while the flow separation and the stagnation points were determined through the presence of phase reversal signatures.

Mangalam, S. M.↗

NASA NTRS1990

Measurement of crossflow vortices, attachment-line flow, and transition using microthin hot films

A flow diagnostic experiment was conducted on a 45-deg swept-wing model using surface-mounted, multielement, microthin, hot-film sensors. The cross-flow vortex spacing, the attachment-line flow characteristics, and the transition region were all determined using an advanced data acquisition and instrumentation system. In addition to the frequencies of traveling waves predicted by linear stability theory, amplified disturbances at much higher frequencies were observed. Simultaneous measurements from sensors located at a number of chord and span locations highlighted the strong three-dimensionality of the boundary-layer flow in the presence of cross-flow vortices. The state of the attachment-line boundary layer was determined using a multielement sensor wrapped around the wing leading edge. The transition region flow characteristics were also identified.

Mangalam, S. M.↗

NASA NTRS1990

Experimental observations on the relationship between stagnation region flow oscillations and eddy shedding for circular cylinder

Measurements indicate a direct coupling between the dominant frequencies of flow oscillations at the leading-edge stagnation region, laminar-separation unsteadiness, and the vortex shedding. An array of surface mounted, micro-thin hot-films were used to simultaneously determine the state of the boundary layer along the surfaced of a circular cylinder, and vortex shedding was monitored by a hot wire placed in its wake.

Mangalam, S. M.↗

NASA NTRS1988

A new multipoint thin-film diagnostic technique for fluid dynamic studies

A multielement hot-film sensor has been developed with closely-spaced elements (2.5 mm) in the streamwise direction. In addition to boundary-layer transition detection, the output of these sensors can reveal the locations of boundary-layer separation and reattachment by a 180 deg phase difference in the 0-200-Hz frequency bandwidth between sensor elements on each side of either the separation or reattachment point. This paper describes the features of multielement hot-film sensor arrays and discusses results from their application to a number of low-speed and transonic airfoil tests.

Sewall, W. G.↗

NASA NTRS1988

The phase reversal phenomenon at flow separation and reattachment

Tests were conducted on two different airfoils, one of them in a low-turbulence tunnel, to detect laminar separation and turbulent reattachment locations. A 'nonintrusive' multielement sensor consisting of a large number of closely spaced individual nickel films was vacuum deposited on a thin substrate and bonded to the airfoil model surface. Each sensor element was a part of an independent constant temperature anemometer system. Time history as well as spectral analysis of signals from surface film gauges were used to determine the surface shear flow characteristics. A major breakthrough was achieved with the discovery of phase reversal in low-frequency dynamic shear stress signals across regions of flow separation and reattachment.

Stack, J. Pete↗

NASA NTRS1987

Development of wing and tail configurations for low altitude unmanned research aircraft (LAURA)

The Low Altitude/Airspeed Unmanned Research Aircraft (LAURA) is being developed by the U.S. Navy for flight test research using low-Reynolds number airfoils. This vehicle consists of a standard modular fuselage designed to accept the installation of several wings/tails having low Reynolds number airfoils, and various planform shapes. Design constraints include shipboard storage, long flight endurance at very low airspeeds and sea-skimming cruise altitude. The stringent design constraints require the development of high-performance low Reynolds number (LRN) airfoils, suitable lifting surface configuration, and advanced airframe-propulsion systems. The present paper describes ongoing efforts to develop wing and tail configurations for LAURA using airfoils designed at NASA Langley Research Center.

Mangalam, S. M.↗

NASA NTRS1987

Effect of acoustic excitation on the flow over a low-Re airfoil

Wind-tunnel measurements of lift, drag, and wake velocity spectra were carried out under (tonal) acoustic excitation for a smooth airfoil in the chord-Reynolds-number Re(c) range of 40,000-140,000. The data were supported by smoke-wire flow-visualization pictures. Small-amplitude excitation in a wide, low-frequency range is found to eliminate laminar separation that otherwise degrades the airfoil performance at low Re(c) near the design angle of attack. Excitation at high frequencies eliminates a prestall, periodic shedding of large-scale vortices. Significant improvement in lift is also achieved during poststall, but with large-amplitude excitation. Wind-tunnel resonances strongly influence the results, especially in cases requiring large amplitudes.

Zaman, K. B. M. Q.↗

NASA NTRS1987

A unique measurement technique to study laminar-separation bubble characteristics on an airfoil

A 'nonintrusive', multielement heat-transfer sensor was designed to study laminar-separation bubble characteristics on a NASA LRN (1)-1010 low-Reynolds number airfoil. The sensor consists of 30 individual nickel films, vacuum-deposited on a thin substrate (0.05 mm) that was bonded to the airfoil model with the sensor array placed streamwise on the airfoil upper surface. Experiments were conducted on a 15-cm chord model in the 50,000-300,000 chord Reynolds number range. Time history as well as spectral analysis of signals from surface film gauges were simultaneously obtained to determine the location of laminar separation and the subsequent behavior of the separated shear layer. In addition to the successful determination of laminar separation, a new phenomenon involving a large phase shift in dynamic shear stresses across the separation and reattachment points was observed.

Stack, J. P.↗

NASA NTRS1987

Influence of suction and curvature on the growth of Goertler vortices on an airfoil

Laser velocimetry (LV) was used to study the development of Goertler vortices in a laminar boundary layer on a 1.83 m chord airfoil model. The vortex pattern was visualized using a sublimating chemical technique. A fixed, essentially uniform vortex spacing was observed throughout the test region for any given freestream velocity but the vortex wavelength varied significantly with change in freestream velocity. An appreciable, abrupt decrease in streak contrast indicated vortex damping in the convex region and was confirmed by disturbance functions determined from LV measurements. Moderate variation in suction levels did not alter the vortex spacing but appreciably modified the vortex strength. The experimental results on the growth of Goertler vortices along the concave surface and the effect of suction are compared with results from linear stability theory.

Mangalam, S. M.↗

NASA NTRS1986

Boundary layer transition

The boundary layer stability, its active control by sound and surface heating and the effect of curvature are studied numerically and experimentally for subsonic flow. In addition, the experimental and flight test data are correlated using the stability theory for supersonic Mach numbers. Active transition fixing and feedback control of boundary layer by sound interactions are experimentally investigated at low speed over an airfoil. Numerical simulation of active control by surface heating and cooling in air shows that by appropriate phase adjustment a reduction in the level of perturbation can be obtained. This simulation is based on the solution of two-dimensional compressible Navier-Stokes equations for a flat plate. Goertler vortices are studied experimentally on an airfoil in the Low Turbulence Pressure Tunnel (LTPT). The flow pattern was visualized using the sublimating chemical technique and data were obtained using a three component laser velocimeter. The effect of curvature on swept leading-edge stability on a cylinder was numerically studied. The results suggest that transition is dominated by traveling disturbance waves and that the waves with the greatest total amplification has an amplitude ratio of e sup 11. Experimental data from the quiet supersonic tunnel and flight tests are analyzed using linear compressible stability theory.

Maestrello, L.↗

NASA NTRS1986

Disturbance functions of the Goertler instability on an airfoil

Goertler vortices arise in boundary layers along concave surfaces due to centrifugal effects. This paper presents some results of an experiment conducted to study the development of these vortices on an airfoil with a pressure gradient in the concave region where an attached laminar boundary layer was insured with suction through a perforated panel. A sublimating chemical technique was used to visualize Goertler vortices and the velocity field was measured by laser velocimetry. Experimental disturbance functions are compared with those predicted by the linear stability theory. The trend of vortex amplification in the concave zone and damping in the following convex region is shown to essentially follow the theoretical predictions.

Dagenhart, J. R.↗

NASA NTRS1986

Transition and separation control on a low-Reynolds number airfoil

The major problem associated with the aerodynamic performance of airfoils at low Reynolds numbers is the presence of extensive laminar boundary-layer separation resulting in a large increase in presssure drag and a decrease in lift. The rapid deterioration in airfoil characteristics can be largely eliminated by artificially controlling the flow through the introduction of suitable disturbances in the boundary layer such that transition occurs ahead of the anticipated laminar separation. This paper presents the results of wind-tunnel tests conducted on a 10-cm model of LRN (1)-1007 airfoil with passive (roughness trips) and active (acoustic excitation) controls to trigger transition and suppress separation. Significant improvements in the aerodynamic characteristics of the airfoil were observed. Results of this study for a chord Reynolds number range of 40,000 to 250,000 are presented in this paper.

Mangalam, S. M.↗

NASA NTRS1985

A study of laminar separation bubble in the concave region of an airfoil using laser velocimetry

Laser velocimetry (LV) was used to study the nature of laminar separation bubbles in the concave region of a 1.83-meter airfoil model which was tested in the NASA Langley Low Turbulence Pressure Tunnel. Three component, coincident data from LV measurements including histograms of particle velocity, mean velocity profiles, turbulence intensity, and Reynolds stresses within the shear layer were used to determine the locations of laminar separation, transition, and turbulent reattachment. boundary-layer parameters determined from velocity profiles were used to compare the results with existing empirical relations for describing the laminar separation bubble.

Mangalam, S. M.↗

NASA NTRS1985

Retractable End Plates for Aircraft Lifting Surfaces

End plates and winglets improve aerodynamic characteristics of aircraft wings and other fixed lifting surfaces. Retractable end plates automatically actuated by same shaft that deflects lifting surface and require little or no extra power and absolutely no control input from cockpit. Besides being modular in construction, easily fitted to any existing aircraft design with only minor modifications.

Harvey, W. D.↗

NASA NTRS1985

Experimental studies on Taylor-Goertler vortices

Taylor-Goertler vortices arise in boundary layer along concave surfaces due to centrifugal effects. These counter-rotating streamwise vortices are one of three known flow instabilities which lead to boundary layer transition. Coupled with Tollmien-Schlichting waves and cross flow vortices, Taylor-Goertler vortices can triggerr early transition to turbulence. The flow field patterns were studied by flow visualization using a sublimating chemical technique and a three component laser velocimeter was used to study the flow field in the test region. Results from these studies are given and briefly discussed.

Goglia, G. L.↗

NASA NTRS1985

The Goertler instability on an airfoil

Goertler vortices arise in boundary layers along concave surfaces due to centrifugal effects. This paper presents some results of an experiment conducted to study the development of these vortices on an airfoil with a pressure gradient in the concave region where an attached laminar boundary layer was insured with suction through a perforated panel. The sublimating chemical technique was used to visualize Goertler vortices and the velocity field was measured by laser velocimetry. The vortex wavelength clearly varied with Goertler number as predicted by linear theory. Both flow visualization and velocity measurements indicated vortex damping in the convex zone. Secondary instability was observed at the higher Goertler numbers.

Mangalam, S. M.↗

NASA NTRS1985

The Goertler Instability on an Airfoil

Goertler vortices arise in boundary layers along concave surfaces due to centrifugal effects. This paper presents some results of an experiment conducted to study the development of these vortices on an airfoil with a pressure gradient in the concave region where an attached laminar boundary layer was insured with suction through a perforated panel. The sublimating chemical technique was used to visualize Goertler vortices and the velocity field was measured by laser velocimetry. The vortex wavelength clearly varied with Goertler number as predicted by linear theory. Both flow visualization and velocity measurements indicated vortex damping in the convex zone. Secondary instability was observed at the higher Goertler numbers.

Mangalam, S. M.↗