Space Shuttle solid rocket motor aft-end internal flows
Explore the source record for details and available documents.
Waesche, R. H. Woodward↗
Engineering topics
Marchman, J. F., III
Publications and source records attributed to Marchman, J. F., III.
Space Shuttle SRM internal flows
Flow-visualization techniques were employed in a 1/8-scale model of the Shuttle SRM to investigate the dominant SRM internal flow patterns. The mode included the two aft segments, the aft dome, and the convergent portion of the gimballed nozzle. The effects of 'blowing', resulting from gases produced by the burning propellant, were simulated through the introduction, of a uniform distribution of water along simulated burn-back patterns representing the surface at three different times in a firing. It was found that the effects of vortices shed from protruding inhibitor sections were greatly diminished by the effects of wall injection. It was also found that the extent of circumferential flow resulting from the removal of a portion of protruding inhibitor was limited in scope. Strong circumferential flow in the aft dome was observed when no grain surface was present in the dome. This flow included nozzle-entrance vortices, the occurrence of which probably resulted from interactions between the submerged-nozzle flow and the boundary-layer flow in the aft dome of the case.
Waesche, R. H. Woodward↗
Wing loading on a 60 degree delta wing with vortex flaps
Wind tunnel tests were conducted on a 60 deg delta wing with three vortex flap designs to determine pressure distributions over the wing and flap. The results showed that an optimum vortex flap design depends on proper definition of the vortex flap deflection angle. They also revealed that flap thickness plays an important role in the behavior of the vortex flow over the flap and wing and can have a substantial effect on wing and flap pressure loading. Design codes which fail to account for thickness may result in a much less than optimum flap and deprive the designer of an important tool in designing an effective flap with optimum loading.
Marchman, J. F., III↗
An experimental study of pressures on 60 deg Delta wings with leading edge vortex flaps
An experimental study was conducted in the Virginia Tech Stability Wind Tunnel to determine surface pressures over a 60 deg sweep delta wing with three vortex flap designs. Extensive pressure data was collected to provide a base data set for comparison with computational design codes and to allow a better understanding of the flow over vortex flaps. The results indicated that vortex flaps can be designed which will contain the leading edge vortex with no spillage onto the wing upper surface. However, the tests also showed that flaps designed without accounting for flap thickness will not be optimum and the result can be oversized flaps, early flap vortex reattachment and a second separation and vortex at the wing/flap hinge line.
Marchman, J. F., III↗
Pressure investigation of NASA leading edge vortex flaps on a 60 deg Delta wing
Pressure distributions on a 60 deg Delta Wing with NASA designed leading edge vortex flaps (LEVF) were found in order to provide more pressure data for LEVF and to help verify NASA computer codes used in designing these flaps. These flaps were intended to be optimized designs based on these computer codes. However, the pressure distributions show that the flaps wre not optimum for the size and deflection specified. A second drag-producing vortex forming over the wing indicated that the flap was too large for the specified deflection. Also, it became apparent that flap thickness has a possible effect on the reattachment location of the vortex. Research is continuing to determine proper flap size and deflection relationships that provide well-behaved flowfields and acceptable hinge-moment characteristics.
Marchman, J. F., III↗
Effectiveness of leading-edge vortex flaps on 60 and 75 degree delta wings
A series of wind tunnel tests were run on 60 and 75 deg sweep delta wings to examine the effectiveness of leading-edge vortex flaps. Tests results showed that leading-edge vortex flaps are effective in giving large increases in lift-to-drag ratio and decreases in drag over a wide range of angle of attack. Tests on inverted flaps on the 60 deg delta wing showed substantial increases in lift and drag and may indicate a possibility of using inverted flaps on delta wings in the landing portion of flight. The 60 deg data were compared with that for a 75 deg sweep delta wing confirming that leading-edge vortex flap effectiveness is stronger as sweep is increased. Pitching moment effects due to vortex flaps use were also examined.
Marchman, J. F., III↗
Performance improvement of delta wings at subsonic speeds due to vortex flaps
Subsonic wind tunnel tests were conducted to determine performance improvements possible from the use of leading edge vortex flaps (LEVF) on delta wings. Various flap sizes and deflection angles were examined and lift-to-drag ratio improvements of up to 40% were found at moderate angles of attack on 60 deg and 75 deg swept wings. The LEVF is concluded to be effective in moving the wing's leading edge vortex onto the flaps, tilting the vortex-induced force vector forward to produce a thrust or reduce the wing's drag while maintaining attached flow and lift on the wing's upper surface.
Marchman, J. F., III↗
Vortex age as a wake turbulence scaling parameter
Tests were conducted in the Virginia Tech Stability Wind Tunnel to determine the significance of vortex age as a scaling parameter in wake turbulence development and dissipation. Vortex structure was measured over a range of three angles of attack, three free-stream speeds, and seven downstream positions from 2 to 30 chordlengths using an NACA 0012 wing and a five hole yawhead probe. The resulting data indicates that vortex age is not a self-sufficient scaling parameter but a free-stream velocity influence also exists at higher angles of attack which cannot be explained in terms of Re or M.
Marchman, J. F., III↗
Vortex age as a wake turbulence scaling parameter
Research which was conducted to determine the significance of vortex age as a scaling parameter in wake turbulence development and dissipation is reported. Tests were conducted at three angles of attack, three free stream speeds, and seven downstream positions from 2 to 30 chordlengths using an NACA 0012 wing and a five hole yawhead pitot probe. The end surface of the wing tip was flat. Speeds were selected to give a predetermined range of vortex ages. The complete velocity structure of the vortex was measured at each station and speed. The resulting plots of maximum tangential velocity and vortex core diameter versus downstream distance and vortex age indicate that vortex age is not a self sufficient scaling parameter. In addition to the expected effect of lift coefficient there is also a definite free stream speed influence at high wing angles of attack. The exact cause and nature of this effect is not fully understood, but it does not appear to be explainable in terms of Mach number or Reynolds number; however, the influence of tip edge shape on spanwise flow separation appears to be an important factor.
Marshall, J. R.↗
Farfield structure of an aircraft trailing vortex, including effects of mass injection
Wind tunnel tests to predict the aircraft wake turbulence due to the tip trailing vortex are discussed. A yawhead pressure probe was used in a subsonic wind tunnel to obtain detailed mean flow measurements at stations up to 30 chordlengths downstream in an aircraft trailing vortex. Mass injection at the wingtip was shown to hasten the decay of the trailing vortex. A theoretical method is presented to show the effect which the circulation distribution on the wing has on the structure of the outer portion of the vortex.
Mason, W. H.↗
The farfield structure of aircraft wake turbulence.
Detailed mean flow measurements were obtained at stations up to thirty chordlengths downstream in an airfoil trailing vortex using a yawhead pressure probe in the Virginia Tech Six-Foot Subsonic Tunnel. Mass injection at the wingtip was shown to hasten the vortex decay. A theoretical method has been developed to show the effect of wing circulation distribution on the structure of the outer portion of the vortex and excellent agreement with the experimental data is demonstrated. Experimental results indicate a much slower decay and higher tangential velocities than previously expected.
Mason, W. H.↗
Investigation of an aircraft trailing vortex using a tuft grid
With the increasing capacity of airport terminal areas, and the use of the new large jet transports, it has become important to understand the turbulent wake created by these aircraft. A study of the trailing vortex of a wing has been made using a tuft grid in a 6 foot wind tunnel. The study included an investigation of the use of mass injection at the wing tip as a means of destroying the vortex. Test results show that a fully developed, stable, vortex exists at least a distance of thirty chord lengths downstream of the wing, and that the swirl of the vortex can be reduced or eliminated by mass injection at the wing tip.
Mason, W. H.↗