Search NASA⌕ Search

Engineering topics

Margason, R. J.

Publications and source records attributed to Margason, R. J..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Separated flow

A brief overview of flow separation phenomena is provided. Langley has many active research programs in flow separation related areas. Three cases are presented which describe specific examples of flow separation research. In each example, a description of the fundamental fluid physics and the complexity of the flow field is presented along with a method of either reducing or controlling the extent of separation. The following examples are discussed: flow over a smooth surface with an adverse pressure gradient; flow over a surface with a geometric discontinuity; and flow with shock-boundary layer interactions. These results will show that improvements are being made in the understanding of flow separation and its control.

Sellers, W. L., III↗
NASA NTRS1986

Euler equation analysis of the initial roll-up of aircraft wakes

A new approach has been developed to study the initial roll-up of aircraft wakes. This approach is based on the solution of the three-dimensional Euler equations subject to inflow and initial conditions predicted by a vortex-lattice method. This procedure allows for the solution of this complex problem without any empirical inputs. However, valid solutions are limited to those flowfields generated by wings which are free of flow separation. Results are presented for four configurations: a rectangular wing with part span flap, a rectangular wing, a typical transport-type configuration and a fighter configuration. In addition, an assessment of an 'unsteady 2-D analogy' was undertaken using the 2-D time accurate Euler equation solutions in crossflow planes. In general, predictions from the 2-D unsteady analogy coincided with the 3-D results which were found to be in good agreement with available experimental data.

Mitcheltree, R. A.↗
NASA NTRS1982

Jet V/STOL wind-tunnel simulation and groundplane effects

The pretest preparation necessary to define the objectives of an appropriate investigation into the jet V/STOL wind tunnel simulation and ground plane effects were examined. Low speed wind tunnel testing of V/STOL aircraft concepts to determine the aerodynamic propulsion interaction effects during the transition between hover and wingborne flight is a necessary step in the development cycle of this type of aircraft. Powered models are normally used to determine the aerodynamic performance characteristics. Several factors which influence the selection of the model concept and the engine simulator are discussed. Some of the test techniques important for this class of aircraft model are examined. Wind tunnel wall effects important to this aircraft testing with special emphasis on groundplane effects are reviewed.

Margason, R. J.↗
NASA NTRS1981

Jet V/STOL wind-tunnel simulation and groundplane effects

Low-speed wind-tunnel testing of V/STOL aircraft concepts to determine the aerodynamic-propulsion interaction effects during the transition between hover and wingborne flight is a necessary step in the development cycle of this type of aircraft. Powered models are normally used to determine the aerodynamic performance characteristics. This paper examines some of the pretest preparation necessary to define the objectives of an appropriate investigation. Several factors which influence the selection of the model concept and the engine simulator are discussed. In addition, some of the test techniques important for this class of aircraft model are examined. Finally, the paper reviews some of the wind-tunnel wall effects important to this type of aircraft testing with special emphasis on groundplane effects.

Margason, R. J.↗
NASA NTRS1981

High lift technology

The NASA Langley high lift technology program is reviewed and elements of the program which are considered Reynolds number sensitive are discussed. The Energy Efficient Transport (EET) and Supersonic Cruise Research (SCR) models proposed for high lift studies in the National Transonic Facility (NTF) are described. Recommendations regarding the NTF facility and test techniques are presented.

Coe, P. L., Jr.↗
NASA NTRS1979

Powered low-aspect-ratio Wing In Ground effect (WIG) aerodynamic characteristics

A wing-in-ground effect configuration was investigated. The configuration used large diameter, low pressure ratio fans mounted about 0.76 wing chord ahead of the wing leading edge to achieve a power augmented ram wing during operation in ground effect. Tests of both in and out of ground effect aerodynamic transition characteristics from very low speeds to cruise speeds are described. The investigation provided a number of conclusions concerning the aerodynamic/propulsive performance interaction. While power augmented lift is required for low speed flight, there is a thrust loss when the efflux is trapped under the wing which reduced the effective thrust to weight available for acceleration by about a third of the installed thrust to weight ratio.

Thomas, J. L.↗
NASA NTRS1979

Critical considerations for wind-tunnel testing V/STOL aircraft models

Low-speed wind-tunnel testing of V/STOL aircraft concepts to determine the aerodynamic-propulsion interaction effects during the transition between hover and wingborne flight is a necessary step in the development cycle of this type of aircraft. The paper examines factors which must be dealt with to assure that the information obtained in experiments is accurate and representative of the full-scale aircraft modeled. Areas of discussion include: (1) Proper engine simulation selection and model size constraints as a result of the selection; (2) selection of reference power-off condition for determining propulsion interaction effects; (3) modeling of realistic flight conditions to obtain a comprehensive evaluation of the entire transition performance; and (4) wind-tunnel boundary interferences and how these are highly configuration dependent.

Margason, R. J.↗
NASA NTRS1976

Effects of jets, wakes, and vortices on lifting surfaces

The interaction of jets, wakes, and vortices on lifting bodies represents a broad spectrum of aerodynamic flow phenomena. A literature survey is presented of 79 research activities in related aerodynamic situations.

Margason, R. J.↗
NASA NTRS1976

Prediction methods for jet V/STOL propulsion aerodynamics

The current status of prediction methods for propulsive flows and propulsion-induced effects which occur on jet V/STOL aircraft is reviewed. Among the major topics studied are flows in propulsive ducts, propulsion-induced ground and thermal effects, aerodynamic loads induced during V/STOL and transition flight, flow vectoring devices, and thrust augmented ejector and lift-fan studies. The current predictive capability in jet V/STOL propulsion aerodynamics is assessed. Future research needs are identified, with particular reference to activities that can improve the usefulness of prediction methods for jet V/STOL aircraft.

Platzer, M. F.↗
NASA NTRS1976

Aircraft aerodynamic design and evaluation methods

This paper presents some practical methods for the aerodynamic design and evaluation of conventional aircraft. High-lift methodology which provides improved takeoff and landing and transonic maneuvering performance is discussed. Also, new techniques for estimating and minimizing cruise pressure drag are presented. These include a far-field theory to minimize trimmed induced drag, theories to estimate the spanwise variation of drag due to thickness and lift, and a far-field theory to estimate total pressure drag. In addition to the description of methods, aerodynamic design procedures are outlined and results from both the design and evaluation methods are presented.

Tulinius, J. R.↗
NASA NTRS1976

Summary of low-speed aerodynamic characteristics of upper-surface-blown jet-flap configurations

The results of recent wind tunnel investigations to provide fundamental information on the upper surface blown (USB) jet flap concept demonstrated that the USB concept provides good high-lift performance. It is shown that the low speed performance is dependent upon the jet turning angle and turning efficiency and on the use of proper leading and trailing edge treatment to prevent premature flow separation. The best means of achieving good turning performance in any particular USB application must be determined from overall operational considerations in which high speed performance, structures and noise, as well as low speed performance, are evaluated. The large diving moments generated at high lift coefficients can be trimmed satisfactorily with a large, conventional horizontal tail; a high tail position is best from longitudinal stability considerations. Large rolling and yawing moments are introduced with the loss of an engine, but these moments can be trimmed satisfactorily through the use of asymmetrical boundary layer control and through the use of spoiler and rudder deflection as needed.

Phelps, A. E., III↗
NASA NTRS1975

High-lift aerodynamics: Trends, trades, and options

The trend toward the utilization of higher maximum lift coefficient with increased aircraft size and cruise velocities is discussed. The impact of this trend on the need for tradeoffs between cruise performance and takeoff, climb, and landing performance is examined. Theoretical methods for the analysis of the two-dimensional characteristics of flap systems are described and compared with experimental data. Four powered-lift concepts are described to outline some of the options currently being developed. Two jet-flap theories are described which provide analytical methods for estimation of the three-dimensional aerodynamic high-lift performance characteristics of powered lift systems.

Margason, R. J.↗
NASA NTRS1974

Pressure distribution on a vectored-thrust V/STOL fighter in the transition-speed range

A wind-tunnel investigation has been conducted in the Langley V/STOL tunnel with a vectored-thrust V/STOL fighter configuration to obtain detailed pressure measurements on the body and on the wing in the transition-speed range. The vectored-thrust jet exhaust induced a region of negative pressure coefficients on the lower surface of the wing and on the bottom of the fuselage. The location of the jet exhaust relative to the wing was a major factor in determining the extent of the region of negative pressure coefficients.

Mineck, R. E.↗
NASA NTRS1973

An experimental investigation of a highly underexpanded sonic jet ejecting from a flat plate into a subsonic crossflow

The induced static pressures due to a highly underexpanded sonic jet ejecting normally from a flat plate into a subsonic crosswind have been investigated. These pressure data have been recorded on the flat plate for a range of nominal jet-to-free-stream dynamic-pressure ratios from 0 to 1000 at free-stream Mach numbers of 0.1, 0.2, 0.4, and 0.6. The static pressure data measured on the flat plate are presented and correlated based upon the Riemann shock geometry in the jet plume. This data correlation improves with increasing free-stream Mach number.

Shaw, C. S.↗
NASA NTRS1972

Wind-tunnel investigation at low speeds of a model of the Kestrel (XV-6A) vectored-trust V/STOL airplane

Longitudinal and lateral stability data were obtained with the model out of and in ground effect over a moving ground plane for a range of model angles of attack and sideslip at various thrust coefficients. These data were taken primarily at thrust coefficients which simulate transition speeds on the airplane between hover and 200 knots. Some data, however, represent the effect of thrust deflection at speeds up to 350 knots. Also presented are the effects of control-surface deflections and interference between the jets and free stream.

Margason, R. J.↗