Engineering topics

Marner, Wilbur J.

Publications and source records attributed to Marner, Wilbur J..

4 records

NASA NTRS1990

Probe Measures Fouling As In Heat Exchangers

Combustion deposits reduce transfer of heat. Instrument measures fouling like that on gas side of heat exchanger in direct-fired boiler or heat-recovery system. Heat-flux probe includes tube with embedded meter in outer shell. Combustion gases flow over probe, and fouling accumulates on it, just as fouling would on heat exchanger. Embedded heat-flow meter is sandwich structure in which thin Chromel layers and middle alloy form thermopile. Users determine when fouling approaches unacceptable levels so they schedule cleaning and avoid decreased transfer of heat and increased drop in pressure fouling causes. Avoids cost of premature, unnecessary maintenance.

Marner, Wilbur J.↗

NASA NTRS1989

Apparatus in the form of a disk for the separation of oxygen from other gases and/or for the pumping of oxygen and the method of removing the oxygen

An apparatus in the form of a disk for the separation of oxygen from gases, or for the pumping of oxygen, uses a substantially circular disk geometry for the solid electrolyte with radial flow of gas from the outside edge of the disk to the center of the disk. The reduction in available surface area as the gas flows toward the center of the disk reduces the oxygen removal area proportionally to provide for a more uniform removal of oxygen.

Suitor, Jerry W.↗

NASA NTRS1989

Vortex generator for flow control

Fluidics flow control of a multiphase supply using a cylindrical chamber is achieved by introducing the supply flow radially into the chamber. The supply flow exits through a port in the center at the chamber. A control fluid is then introduced tangentially about 90.degree. upstream from the supply port. A second control fluid port may be added about 90.degree. upstream from the first control fluid port, but preferably two sets of supply and control ports are added with like ports diametrically opposite each other. The control fluid flows against the circular wall of the control chamber, which introduces a vortex in the flow of the supply flow that decays into a spiral path to the exit port in the center of the chamber. The control flow rate may thus be used to control the spiral path, and therefore the supply flow rate through the exit port.

Collins, Jr., Earl R.↗

NASA NTRS1989

Improved Flow-Controlling Vortex Generator

Symmetrical tangential streams control flow of radial primary streams. Vortex generator uses small secondary stream of fluid to control normally-larger primary stream. Improved version of vortex generator described in "Variable Control Port for Fluidic Control Device," (NPO-16603). Secondary, or control, flows entering tangentially through diametrically opposite ports set up swirling motion restraining primary flow. Pressure of secondary fluid in relation to primary fluid controlling factor. Like valve, vortex generator varies rate of flow of primary fluid from maximum value down to zero. When properly designed, requires low pressure differential between primary and secondary streams and expends relatively small amount of secondary fluid.

Collins, Earl R., Jr.↗