Search NASA⌕ Search

Engineering topics

Marsh, S. E.

Publications and source records attributed to Marsh, S. E..

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Comparison of multi-temporal NOAA-AVHRR and SPOT-XS satellite data for mapping land-cover dynamics in the West African Sahel

Multi-resolution and multi-temporal remote sensing data (SPOT-XS and AVHRR) were evaluated for mapping local land-cover dynamics in the Sahel of West Africa. The aim of this research was to evaluate the agricultural information that could be derived from both high and low spatial resolution data in areas where there is very often limited ground information. A combination of raster-based image processing and vector-based geographical information system mapping was found to be effective for understanding both spatial and spectral land-cover dynamics. The SPOT data proved useful for mapping local land-cover classes in a dominantly recessive agricultural region. The AVHRR-LAC data could be used to map the dynamics of riparian vegetation, but not the changes associated with recession agriculture. In areas where there was a complex mixture of recession and irrigated agriculture, as well as riparian vegetation, the AVHRR data did not provide an accurate temporal assessment of vegetation dynamics.

Marsh, S. E.↗
NASA NTRS1983

Field Measurement of Thermal Inertia

Radiometric measurements determine thermal inertia for geologic materials. Measurements are correlated with data obtained by remote sensing, for discriminating varieties of rock encountered when exploring for minerals by aircraft or by satellites equipped with infrared scanners.

Kahle, A. B.↗
NASA NTRS1983

Imaging systems for the delineation of spectral properties of geologic materials in the visible and near-infrared

The current status of imaging systems for the identification of the spectral properties of geologic minerals in the visible and near infrared ranges is reviewed. The technical characteristics of the most important instruments are given, including the MSS and TM, the Airborne Imaging Spectrometer, (AIS) the Airborne Visible/Infrared Imaging Spectrometer (AVIRIS), and the Shuttle Imaging Spectrometer Experiment (SISEX). It is pointed out that none of the current systems have sufficient spectral resolution to identify mineralogy on the basis of absorption characteristics in the visible, near-infrared or shortwave-infrared bands. The development of new systems with higher spectral resolution is discussed.

Marsh, S. E.↗
NASA NTRS1982

An instrument for measuring thermal inertia in the field

Features and test results of a thermal inertial meter (TIM) for cataloging the thermal inertial of surface material in situ as a basis for satellite remote sensing of geologic materials are described. The instrument is employed to determine the temperature rise of the materials in the field, with the assumptions that the sample and a standard are homogeneous in composition, the heat flux density is constant at the surface of each material, and the specimens are thick enough to be treated as semi-infinite bodies. A formula for calculating thermal inertia is presented, and the components of the TIM are detailed. A box with three compartments, two holding standards, is placed on the sample surface with the third compartment open to the specimen. Dolomite and quartz are used as references when all samples are measured after heating. Tests with rocks and sand in Nevada and California revealed that chert has a higher thermal inertia than barite.

Marsh, S. E.↗
NASA NTRS1980

Resolving the percentage of component terrains within single resolution elements

An approximate maximum likelihood technique employing a widely available discriminant analysis program is discussed that has been developed for resolving the percentage of component terrains within single resolution elements. The method uses all four channels of Landsat data simultaneously and does not require prior knowledge of the percentage of components in mixed pixels. It was tested in five cases that were chosen to represent mixtures of outcrop, soil and vegetation which would typically be encountered in geologic studies with Landsat data. For all five cases, the method proved to be superior to single band weighted average and linear regression techniques and permitted an estimate of the total area occupied by component terrains to within plus or minus 6% of the true area covered. Its major drawback is a consistent overestimation of the pixel component percent of the darker materials (vegetation) and an underestimation of the pixel component percent of the brighter materials (sand).

Marsh, S. E.↗
NASA NTRS1979

Geologic applications of thermal inertia image using HCMM data

The author has identified the following significant results. Comparison of a simulated HCMM image of the Pisgah Crater, California test site obtained from aircraft data with an image generated from the preliminary satellite data tape of the area indicates that the HCMM satellite data appears much as predicted by the simulation.

Kahle, A. B.↗