Search NASA⌕ Search

Engineering topics

Martinez, Estevan Jose

Publications and source records attributed to Martinez, Estevan Jose.

At least 19 records

Unexpected Thermomechanical Behavior of Off-Stoichiometry Epoxy/Amine Materials

Recent studies on off-stoichiometric thermosets reveal unique viscoelastic behavior derived from increased free volume and physical interactions between chain ends. To understand structural characteristics arising from cure and its effect on properties, we developed a Monte Carlo model based on step-growth polymerization. Our model accurately predicted structure–property trends for a two-component system of EPON 828 (EPON) and ethylenediamine. A second epoxy monomer, D.E.R. 732 (DER), was investigated to modulate T g . Binary mixtures of EPON and DER in off-stoichiometric, amine-rich formulations resulted in nonlinear evolution of thermomechanical properties with respect to initial formulation stoichiometry. Modifying our model with kinetic parameters allowing for differential epoxide/amine reaction kinetics only partially accounted for trends in T g , suggesting that spatiotemporal contributions-not captured by our model-were significant determinants of material properties compared to polymer architecture for three-component systems. Here these findings underpin the importance of spatial awareness in modeling to inform the development of dynamic thermosets.

36 MATERIALS SCIENCE↗

Self Assembly-Assisted Additive Manufacturing: Direct Ink Write 3D Printing of Epoxy-Amine Thermosets

The use of self–assembling, pre–polymer materials in 3D printing is rare, due to difficulties of facilitating printing with low molecular weight species and preserving their reactivity and/or functions on the macroscale. Akin to 3D printing of small molecules, examples of extrusion–based printing of pre–polymer thermosets are uncommon, arising from their limited rheological tuneability and slow reactions kinetics. The direct ink write (DIW) 3D printing of a two–part resin, Epon 828 and Jeffamine D230, using a self–assembly approach is reported. Through the addition of self–assembling, ureidopyrimidinone–modified Jeffamine D230 and nanoclay filler, suitable viscoelastic properties are obtained, enabling 3D printing of the epoxy–amine pre–polymer resin. A significant increase in viscosity is observed, with an infinite shear rate viscosity of approximately two orders of magnitude higher than control resins, in addition to, an increase in yield strength and thixotropic behavior. As a result, printing of simple geometries is demonstrated with parts showing excellent interlayer adhesion, unachievable using control resins.

3D printing↗