Search NASA⌕ Search

Engineering topics

Martinez, Ramon M.

Publications and source records attributed to Martinez, Ramon M..

Microstructure dependent shear localization in 316L SS

Shear localization is characterized by the concentration of plastic deformation within narrow bands of material and constitutes the precursor to failure in materials subjected to high strain rates. These bands have been observed experimentally, but classical continuum material models have not been able to fully capture their development. The aim of this research is to investigate the role of microstructural differences in the dynamic shear response of wrought and additively manufactured (AM) 316L SS. Compact Forced Simple Shear specimens for Digital Image Correlation (CFSS-DIC) of wrought and additively manufactured 316L SS were tested on a Split Hopkinson Pressure Bar (SHPB) in conjunction with infrared thermometry measurements. Results indicate that the microstructures of wrought and AM 316L SS exhibit differences that affect the shear response of this materials. In conclusion, CFSS-DIC samples tested on the SHPB did not exhibit recrystallization inside the shear region, fact confirmed by thermometry measurements.

36 MATERIALS SCIENCE↗

Additively manufactured tantalum microstructures

Additively manufacturing tantalum is a challenging process in which obstacles are stemming from the high melting temperature and susceptibility to oxidation of tantalum. In this paper, several combinations of deposition parameters were considered in an effort to obtain fully dense additively manufactured tantalum produced on an EOSINT M280 DMLS system. Deposition parameters significantly affect the resulting microstructure of additively manufactured tantalum, altering grain morphology, grain size, crystallographic preferred orientation, and deposition porosity. Due to the nature of the laser sintering process applied, which implies large directional temperature gradients, the resulting microstructures were strongly columnar along the building direction. Microstructural differences for different deposition conditions manifested themselves in both grain morphology and preferred crystal orientations in the columnar grains. Deposition speed and laser power were important parameters to consider for obtaining porosity-free material. Finally, stripe width had the most significant effect on grain growth.

36 MATERIALS SCIENCE↗