Search NASA⌕ Search

Engineering topics

Masse, L

Publications and source records attributed to Masse, L.

Achieving 280 Gbar hot spot pressure in DT-layered CH capsule implosions at the National Ignition Facility

We are reporting on a series of indirect-drive 0.9-scale CH capsule implosions (inner radius = 840 μm) fielded in low gas-fill (0.6 mg/cm 3 ) hohlraums of 6.72 mm diameter at the National Ignition Facility. Thanks to the 11%-reduction of the capsule size at a given hohlraum diameter compared to previously tested full-scale capsules, we achieved good hot spot symmetry control near 33% cone-fraction and without the need to invoke cross beam energy transfer. As a result, we achieved a hot spot pressure of 280 ± 40 Gbar, which is the highest pressure demonstrated in layered DT implosions with CH capsules to date. Pushing this design to higher velocity resulted in a reduction of neutron yield. Highly resolved capsule simulations suggest that higher Au M-shell preheat resulted in an increase in Atwood number at the ablator–ice interface, which leads to increased fuel-ablator instability and mixing. The results reported here provide important scaling information for next-generation CH designs.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Designs for highly nonlinear ablative Rayleigh-Taylor experiments on the National Ignition Facility

We present two designs relevant to ablative Rayleigh-Taylor instability in transition from weakly nonlinear to highly nonlinear regimes at the National Ignition Facility [E. I. Moses, J. Phys.: Conf. Ser. 112, 012003 (2008)]. The sensitivity of nonlinear Rayleigh-Taylor instability physics to ablation velocity is addressed with targets driven by indirect drive, with stronger ablative stabilization, and by direct drive, with weaker ablative stabilization. The indirect drive design demonstrates the potential to reach a two-dimensional bubble-merger regime with a 20 ns duration drive at moderate radiation temperature. The direct drive design achieves a 3 to 5 times increased acceleration distance for the sample in comparison to previous experiments allowing at least 2 more bubble generations when starting from a three-dimensional broadband spectrum.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Observation of the stabilizing effect of a laminated ablator on the ablative Rayleigh-Taylor instability

A laminated ablator is explored as an alternative concept for stabilizing the ablative Rayleigh-Taylor instability which develops in inertial fusion targets. Experiments measuring the growth of the Rayleigh-Taylor instability of laminated planar foils are reported. Consistent with both theory and simulations, a significant reduction of the perturbation growth is experimentally observed for laminated ablators in comparison to what is observed for classical uniform ablators. Such an enhanced hydrodynamic stability opens opportunities for the design of high-gain inertial fusion targets.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Reduced ablative Rayleigh-Taylor growth measurements in indirectly driven laminated foils

Indirectly driven, ablative Rayleigh-Taylor instability growth measurements in Ge-doped plastic foils were studied using face-on and side-on x-ray radiography. Laminated samples consisting of alternating layers of Ge-doped and undoped plastic and homogeneous Ge-doped foils were considered. We show for the first time that hydrodynamics do not depend upon structuration of the samples and that stabilization occurs in the case of laminated samples. All data were found to be in good agreement with bi-dimensional hydrosimulations based on theoretical and numerical predictions published earlier [L. Masse, Phys. Rev. Lett. 98, 245001 (2007)], encouraging new designs using laminated structures for ignition capsules.

36 MATERIALS SCIENCE↗