Search NASASearch

Engineering topics

Massey, G. A.

Publications and source records attributed to Massey, G. A..

Measurement of temperature and density fluctuations in turbulence using an ultraviolet laser

Noninvasive measurement of density and temperature fluctuations in turbulent air flow was examined. The approach used fluorescence of oxygen molecules which are selectively excited by a tunable vacuum ultraviolet laser beam. The strength of the fluorescence signal and its dependence on laser wavelength vary with the density and temperature of the air in the laser beam. Because fluorescence can be detected at 90 degrees from the beam propagation direction, spatial resolution in three dimensions, rather than path-integrated measurements can be achieved. With spatial resolutions of the order of a millimeter and at supersonic air velocities it is necessary to perform each measurement in a time of the order of a microsecond; this is possible by by using laser pulses of ten nanosecond duration. In this method atmospheric O2 is excited by the emission of a tunable ArF excimer laser, and the fluorescence, which spans the 210 to 420 range, is detected by an ultraviolet phototube.

Massey, G. A.

Feasibility of measuring temperature and density fluctuations in air using laser-induced O2 fluorescence

A tunable line-narrowed ArF laser can selectively excite several rotation al lines of the Schumann-Runge band system of O2 in air. The resulting ultraviolet fluorescence can be monitored at 90 deg to the laser beam axis, permitting space and time resolved observation of density and temperature fluctuations in turbulence. Experiments and calculations show that + or - 1 K, + or - 1 percent density, 1 cu mm spatial, and 1 microsecond temporal resolution can be achieved simultaneously under some conditions.

Massey, G. A.

Asymmetric photolysis of /RS/-leucine with circularly polarized ultraviolet light

(RS)-leucine in 0.1 M HCl solution has been subjected to photolysis with 212.8-nm right (R-) and left circularly polarized light (LCPL) obtained from a laser source. RCPL preferentially photolyzed the (R)-leucine component and LCPL the (S)-leucine component of the RS substrate. The enantiomeric excess produced were 1.98% for the 59% conversion with RCPL and 2.50% for the 75% conversion with LCPL. These 'equal and opposite' effects represent the second highest enantiomeric enrichments yet reported for an asymmetric photolysis and the first ever reported for a prebiotically important substrate - an amino acid. Implications regarding the origin of optical activity are briefly discussed.

Flores, J. J.

Vibration detection using lasers

Interference displacement patterns produced when light from a laser illuminates diffusely reflecting, vibrating surface are observed and photographed. Standing wave modes on model surface can be interpreted in order to yield amplitude and frequency of vibrations. Flat, white surfaces yield best interference patterns, even over considerable surface curvature.

Massey, G. A.

Laser method for finding axis of rotation

Illumination of rotating surface with laser beam and examination of interference patterns resulting from diffused reflections determines position of axis and direction of motion. Interference patterns are viewed through a lens or recorded on film as circular streaking patterns.

Massey, G. A.

Less-expensive Rochon prisms

Inexpensive Rochon prisms can be produced by substituting easily polished glass for one-half of the calcite. Reciprocal polarizing properties of a conventional Rochon prism are retained, and angular separation between ordinary and extraordinary rays is the same as in all-calcite prism.

Ammann, E. O.