Search NASA⌕ Search

Engineering topics

Matthews, John

Publications and source records attributed to Matthews, John.

6 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2021

A search for spectral hardening in HAWC sources above 56 TeV

The High Altitude Water Cherenkov (HAWC) Observatory is a wide-field-of-view gamma-ray observatory that is optimized to detect gamma rays between 300 GeV and several hundred TeV. The HAWC Collaboration recently released their third source catalog (3HWC), which contains 65 sources. One of these sources, the ultra-high-energy gamma-ray source 3HWC J1908+063, may exhibit a hardening of the spectral index at the highest energies (above 56 TeV). At least two populations of particles are needed to satisfactorily explain the highest energy emission. This second component could be leptonic or hadronic in origin. If it is hadronic in origin, it would imply the presence of protons with energies up to ~1 PeV near the source. We have searched other 3HWC sources for the presence of this spectral hardening feature. If observed, this would imply that the sources could make good PeVatron candidates.

79 ASTRONOMY AND ASTROPHYSICS↗
DOE OSTI2021

The Ultra-High-Energy Source MGRO J1908+06

The TeV gamma-ray source MGRO J1908+06 is one of the highest-energy sources known, with observed emission by the High Altitude Water Cherenkov (HAWC) Observatory extending well past 100 TeV. The source exhibits both energy-dependent morphology and a spatially-dependent spectral index. The emission is likely to be dominantly leptonic, and associated with the radio-quiet PSR J1907+0602. However, one-population models do not describe the data well; a second particle population is needed to explain the shape of the spectral energy distribution at the highest energies. This component can be well-described by either leptonic or hadronic hypotheses. We discuss this feature and implications for detection by multi-wavelength and multi-messenger experiments.

79 ASTRONOMY AND ASTROPHYSICS↗
NASA NTRS1990

Foam formation in low gravity

An apparatus that produced the first polyurethane foam in low gravity has been described. The chemicals were mixed together in an apparatus designed for operation in low gravity. Mixing was by means of stirring the chemicals with an electric motor and propeller in a mixing chamber. The apparatus was flown on Consort 1, the first low-gravity materials payload launched by a commercial rocket launch team. The sounding rocket flight produced over 7 min of low gravity during which a polyurethane spheroidal foam of approximately 2300 cu cm was formed. Photographs of the formation of the foam during the flight show the development of the spheroidal form. This begins as a small sphere and grows to approximately a 17-cm-diam spheroid. The apparatus will be flown again on subsequent low-gravity flights.

Wessling, Francis C.↗
NASA NTRS1990

Fault-tolerant, embedded CLIPS applications

The enhancements to CLIPS4.3 presented in this paper provide an embedded CLIPS application with the ability to continue operation with minimal to no loss of information in the event of a hardware or a software failure. Given an arbitrary failure, the CLIPS application's environment (fact-list, agenda, and pattern matching network) will be reconstructed to the point at which the failure was experienced. The environment reconstruction is based on state files to which the application periodically checks environment information (fact-list and agenda). The routine for checkpointing the state of the application is as efficient as possible so that the overhead introduced to normal execution of the application is minimal. The only assumptions made by the CLIPS application are that it is running under an operating system that guarantees it access to uncorrupt state files and that the application will be automatically restarted should it terminate abnormally.

Hicks, Jaye↗
NASA NTRS1987

Highly Non-Linear Optical (NLO) organic crystals and films. Electrooptical organic materials

Devices employing nonlinear optics (NLO) hold great promise for important applications in integrated optics, optical information processing and telecommunications. Properly designed organics possess outstanding optical and electrooptical properties which will substantially advance many technologies including electrooptical switching, optical amplification for communications, and parallel processing for hybrid optical computers. A brief comparison of organic and inorganic materials is given.

Mcmanus, Samuel P.↗