Engineering topics

Maurer, R. E.

Publications and source records attributed to Maurer, R. E..

3 records

NASA NTRS1985

Computer-aided selection of materials for cryogenic turbopump bearings

The life requirement for the angular contact ball bearings in the Space Shuttle Main Engine (SSME) high-pressure-oxygen turbopump (HPOTP) is 7.5 hours. In actual operation, significantly shorter service life has been experienced. The objective of this current program is to identify bearing materials and/or materials processing techniques offering significant potential for extending HPOTP bearing performance life. A thermomechanical analysis of the HPOTP shaft/bearing system was performed with the SHABERTH (SHaft-BEaring-THermal) computer program. Bearing fatigue life, ball-race contact stress, heat generation rate, bulk ring temperatures, and circumferential stress in the inner rings were quantified as functions of radial load, thrust load, and ball-race contact friction. The analysis results were used to formulate criteria that are being used for the selection of special materials for future turbopump bearings.

Maurer, R. E.↗

NASA NTRS1985

Development of new materials for turbopump bearings

The life requirement for the angular contact ball bearings in the Space Shuttle Main Engine (SSME) high pressure oxygen turbopump (HPOTP) is 7.5 hours. In actual operation, significantly shorter service life was experienced. The objective is to identify bearing materials and/or materials processing techniques offering signficant potential for extending HPOTP bearing performance life. Interactive thermomechanical analysis of the HPOTP bearing-shaft system was performed with the SHABERTH computer program. Bearing fatigue life, ball-race contact stress, heat generation rate, bulk ring temperatures and circumferential stress in the inner rings were quantified as functions of radial load, thrust load and ball-race contact friction. Criteria established from the output of this analysis are being used for material candidate selection.

Maurer, R. E.↗

NASA NTRS1977

Arc heater code validation tests of heat shield materials

Results are reported for tests of candidate heat-shield materials for outer-planet entry probes, which were conducted in two different arc-heater facilities at heating rates below those predicted for entry. One facility supplied a combined radiative-convective heating environment in air while the other provided a hydrogen/helium environment for convective heating only. Both 'infinite-slab' and 'finite-slab' models consisting of various carbon phenolic (CP) and fused silica (FS) materials were tested. The test results obtained are expressed in terms of ablation rates and surface as well as in-depth temperature variations with time for the air environment and in terms of normalized ablation rate as a function of temperature for the H/He environment. The measured values are compared with calculations based on a charring material thermal response and ablation code. For the CP models, good agreement between predicted and measured mass-loss rates is noted, surface temperatures in air are predicted within 18%, and in-depth temperature predictions are shown to be conservative in comparison with measured values. For the FS models, discrepancies are found between the predicted and measured mass-loss rates and surface temperatures.

Kesselring, J. P.↗