Search NASA⌕ Search

Engineering topics

Maximov, A. V.

Publications and source records attributed to Maximov, A. V..

An extended Vlasov–Fokker–Planck approach for kinetic simulations of laser plasmas

Vlasov–Fokker–Planck simulation codes occupy an important niche in modeling laser-produced plasmas, since they are well suited to studying the effect of collisions on electron kinetic phenomena, especially energy transport. One of the most important elements of energy transport is the absorption of laser light by the plasma; however, simulating this in detail requires resolving oscillations of the laser light, whose characteristic timescale is orders of magnitude shorter than the simulation time needed to study transport physics. For this reason, most Vlasov–Fokker–Planck codes used to study electron transport in laser plasmas rely on simplified models of the laser–plasma coupling. Their underlying assumptions nominally preclude their use for modeling laser light having short-scale structure in space or time, such as broadband lasers. In this work, we derive a more general computational framework suitable for arbitrarily structured laser fields. Furthermore, our approach is based on an extended set of Vlasov–Fokker–Planck equations that separately solve for the low- and high-frequency plasma response. We implement these extended Vlasov–Fokker–Planck equations in the spherical harmonic code K2 and demonstrate the performance of the method on several laser absorption test problems, with particular attention to the judicious selection of time steps, time integrators, and spherical harmonic truncation, according to the intensity and spectrum of the laser light under consideration. Comparison with the widely used Langdon absorption operator shows the Langdon operator performs remarkably well for predicting laser heating in the simple cases considered here, even in situations that would seem to violate its underlying assumptions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Effect of overlapping laser beams and density scale length in laser-plasma instability experiments on OMEGA EP

Experiments have been conducted on the OMEGA EP laser facility to study the effect of density scale length and overlapping beam geometry on laser-plasma instabilities near and below the quarter-critical density. Experiments were conducted in both planar geometry (density scale length L n ~ 190 to 300 μm) and spherical geometry (L n ~ 150 μm) with up to four overlapping beams and were designed to have overlapped intensities and density scale lengths comparable to OMEGA spherical experiments, but with many fewer beams. In comparison with previous experiments on OMEGA and National Ignition Facility, it is confirmed that shorter density scale lengths favor the two-plasmon decay (TPD) instability, while longer density scale lengths favor stimulated Raman scattering (SRS). In addition, for experiments at the same scale length and overlapped laser intensity, higher single-beam intensities favor SRS, while a larger number of overlapping beams favor TPD.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Effect of laser preheat in magnetized liner inertial fusion at OMEGA

Integrated magnetized liner inertial fusion (MagLIF) experiments on the OMEGA laser system are modeled to investigate the effects of laser preheat on implosion performance. In both simulations and experiments, preheating the fuel with a laser enhances the neutron yield, with the maximum yield occurring at an optimal preheat laser energy. Increasing the preheat energy past the optimal value reduces the neutron yield. In simulations, the rate of the drop in neutron yield depends on the inclusion of the Nernst effect. The Nernst effect advects the magnetic field away from the center of the fuel region during the preheat stage of MagLIF on OMEGA and weakens magnetic-flux compression. If the Nernst effect is not included, the simulated drop in yield past the optimal preheat laser energy is more gradual as opposed to the sharper drop seen in experiments. Simulations are able to model trend in measured ion temperatures seen in experiments. Here, a mix model is used to show that including mix from the wall in the simulated fuel region further degrades the yield and lowers the optimal preheat laser energy. Simulations with mix predict that increasing the initial axial magnetic field may still enhance yield performance in integrated implosions.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Ionization state and dielectric constant in cold rarefied hydrocarbon plasmas of inertial confinement fusion

A combined approach to study cold rarefied matter is introduced that includes a semianalytical method based on the free-energy minimization and ab initio calculations based on the finite-temperature density-functional theory. The approach is used to calculate the ionization state of hydrocarbon (CH) under the shock-release conditions in inertial confinement fusion. Furthermore, the dielectric constant of CH is calculated using the Kubo-Greenwood formulation and contribution from atomic polarizabilities is found to be as important as the free-electron contribution. Using the ionization state and dielectric constant, the electron density profile in the rarefaction wave of the shock-release plasma is obtained.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Density evolution after shock release from laser-driven polystyrene (CH) targets in inertial confinement fusion

The evolution of the plasma density in the rarefaction wave formed after a laser-driven shock is released from a CH foil was measured using optical interferometry. Here, it was found that the plasma density profile is very sensitive to the conditions at the back surface of the foil before the shock release. Dedicated experiments demonstrated that radiation preheat by coronal x-rays caused early expansion of the back surface and faster expansion of the rarefaction wave. Radiation-hydrodynamics simulations with accurate modeling of radiation preheat from the plasma corona are in good agreement with the experimental results. The early expansion of material interfaces due to coronal x-ray preheat must be evaluated in designing and interpreting laser-driven inertial confinement fusion experiments.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Generation of strong magnetic fields for magnetized plasma experiments at the 1-MA pulsed power machine

Pulsed power technology provides a platform for investigating plasmas in strong magnetic fields using a university-scale machine. Presented here are methods for generating and measuring the 1–4-MG magnetic fields developed for the 1-MA Zebra pulsed power generator at the University of Nevada, Reno. A laser coupled with the Zebra generator produces a magnetized plasma, and experiments investigate how a megagauss magnetic field affects the two-plasmon decay and the expansion of the laser-produced plasma in both transverse and longitudinal magnetic fields.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Suppressing the enhancement of stimulated Raman scattering in inhomogeneous plasmas by tuning the modulation frequency of a broadband laser

The stimulated Raman scattering (SRS) instability can inhibit the performance of laser driven inertial confinement fusion (ICF) implosions by scattering light into unwanted directions or by generating hot electrons that preheat the target fuel. In principle, ICF target designs can avoid parameter regimes conducive to large, linear SRS gains. In practice, kinetic inflation—the nonlinear enhancement of SRS due to electron trapping in the excited plasma wave—makes this difficult. Here we show that laser bandwidth in the form of frequency modulation can either decrease or increase the inflationary SRS (iSRS) threshold in inhomogeneous plasmas depending on the maximum chirp of the laser pulse. The threshold, mapped out by a series of particle-in-cell simulations, exhibits a minimum when the frequency change within the pulse cancels the spatial detuning due to density inhomogeneities along the trajectory of the scattered light. In conclusion, by tuning the pump laser parameters away from this minimum, the iSRS threshold can be larger than at zero bandwidth, providing a path to mitigating kinetic inflation in ignition relevant plasmas.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Impact of spatiotemporal smoothing on the two-plasmon–decay instability

Higher levels of hot electrons from the two-plasmon–decay instability are observed when smoothing by spectral dispersion (SSD) is turned off in directly driven inertial confinement fusion experiments at the Omega Laser Facility. This finding is explained using a hot-spot model based on speckle statistics and simulation results from the laser–plasma simulation environment. The model accurately reproduces the relative increase in hot-electron activity at two different drive intensities, although it slightly overestimates the absolute number of hot electrons in all cases. Extrapolating from the current ≈ 360-GHz system while adhering to the logic of the hot-spot model suggests that larger SSD bandwidth should significantly mitigate hot-electron generation, and legacy 1-THz OMEGA experiments appear to support this conclusion. These results demonstrate that it is essential to account for laser speckles and spatiotemporal smoothing to obtain quantitative agreement with experiments. A compilation of hot-electron data from the past two decades reveals several other important points: (1) many prior experiments are more easily understood using recent results from multibeam absolute instability theory; and (2) experiments with ignition-scale conditions produce less hot electrons compared to OMEGA spherical experiments for a given vacuum overlapped intensity, which is a promising result for validating performance predictions based on hydrodynamic scaling relations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Nonlinear transmission of laser light through coronal plasma due to self-induced incoherence

The success of direct laser-driven inertial con nement fusion (ICF) relies critically on the efficient coupling of laser light to plasma. At ignition scale, the absolute stimulated Raman scattering (SRS) instability can severely inhibit this coupling by redirecting and strongly depleting laser light. This article describes a new dynamic saturation regime of the absolute SRS instability near one quarter of the critical density. The saturation occurs when spatiotemporal ion-acoustic fluctuations in the plasma density detune the instability resonance. Here, the dynamic saturation mitigates the strong depletion of laser light and enhances its transmission through the instability region, explaining the coupling of laser light to ICF targets at higher plasma densities.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Anomalous Absorption by the Two-Plasmon Decay Instability

Radiation-hydrodynamic simulations of directly driven fusion experiments at the Omega Laser Facility predict absorption accurately when targets are driven at low overlapped laser intensity. Discrepancies appear at increased intensity, however, with higher-than-expected laser absorption on target. Strong correlations with signatures of the two-plasmon decay (TPD) instability—including half-harmonic and hard-x-ray emission—indicate that TPD is responsible for this anomalous absorption. Scattered light data suggest that up to ≈ 30 % of the laser power reaching quarter-critical density can be absorbed locally when the TPD threshold is exceeded. A scaling of absorption versus TPD threshold parameter was empirically determined and validated using the laser–plasma simulation environment code.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Stimulated Raman scattering mechanisms and scaling behavior in planar direct-drive experiments at the National Ignition Facility

Stimulated Raman scattering (SRS) has been investigated comprehensively in planar-geometry experiments at the National Ignition Facility at conditions relevant to the corona of inertial con finement fusion (ICF) ignition-scale direct-drive targets. These experiments at measured electron temperatures of 4 to 5 keV, simulated density scale lengths Ln of 400 to 700 um, and laser intensities at the quarter-critical density of up to 1.5 x 10 15 W/cm 2 have determined SRS thresholds and the scaling behavior of SRS for various beam geometries. Several SRS mechanisms, including saturated absolute SRS near the quarter-critical density and additional SRS, including near-backscatter or sidescatter at lower densities, have been identi fied. Correlation of time-dependent SRS at densities ~0.15 to 0.21 of the critical density with hot-electron signatures, as well as the magnitudes of these signatures across different experiments, is observed. Additional modeling work is needed to de nitively identify the density region in which hot electrons are generated, and will guide SRS and hot-electron preheat mitigation strategies for direct-drive-ignition designs.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Study of laser-driven magnetic fields with a continuous wave Faraday rotation diagnostic

Magnetic fields driven by a laser in coil targets were studied for laser energies of ~25 J and two pulse durations of 2.8 ns and 70 ps. Axial magnetic fields in the coils were measured by continuous wave Faraday rotation diagnostics. The diagnostics indicated magnetic fields of 6–14 T in the coil and currents of 10–20 kA. Magnetic fields were compared for similar laser targets, focusing conditions, and laser energies. A 30-times increase in the intensity of the laser beam by reducing the pulse duration resulted in an increase in the magnetic field and current by a factor of 2. The relaxation time of the magnetic pulse was on the sub-microsecond scale.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Modeling magnetic confinement of laser-generated plasma in cylindrical geometry leading to disk-shaped structures

Radiation-magnetohydrodynamic simulations were able to reproduce features of the plasma structures observed in recent experiments1, where a laser was used to ablate plasma in a 3 MG magnetic field. The laser ablates the plasma, and localized structures are formed due to the inhibition of heat flow by the magnetic field. The large magnetic pressures cause the plasma to pinch. In an azimuthal fi eld, a disc-shaped plasma is generated. According to simulations, the disc has electron densities that are underdense to the laser, ranging from 10 18 to 10 19 cm -3 , and electron temperatures in the 300 to 1000 eV range during its evolution, similar to experimental data.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗