Search NASA⌕ Search

Engineering topics

Maywar, D N

Publications and source records attributed to Maywar, D N.

Measurement of the Self-Phase Modulation-Induced Bandwidth in a 30 kJ Class Laser Amplifier Chain

Self-phase modulation (SPM) in a multikilojoule laser system was detected spectroscopically and correlated with the time derivative of the intensity measured at the output of the system. This correlation provides an empirical relationship that makes it possible to rapidly determine the magnitude of the SPM being generated using measured experimental data. This empirical relationship was verified by modeling the propagation of an optical pulse in the laser amplifier chain to predict both pulse shape and the SPM.

Donaldson, W R↗

Optical Square-Wave Clock Generation Based on an All-Optical Flip-Flop

We demonstrate optical square-wave clock generation based on an all-optical flip-flop. The bistable output power from a resonant-type semiconductor optical amplifier (SOA) is switched ON and OFF by modulating its input with its output via cross-gain modulation in a traveling-wave SOA. All active components are driven by dc currents, and the wavelength and clock frequency are selectable. A clock frequency of 3.5 MHz is demonstrated, limited by the time of flight between bulk optical components. Optical square-wave clock signals are promising for applications in photonic integrated circuits and all-optical signal processing.

Clocks, flip-flops, optical bistability, optical s↗

Novel Laser and Diagnostic Technologies for the OMEGA EP High-Energy Petawatt Laser

OMEGA EP (extended performance) is a petawatt-class laser facility that includes two NIF-like beamlines designed to operate in a chirped-pulse-amplifi cation mode to produce up to 2.6 kJ in a pulsewidth range of <1 to 100 ps at 1,053 nm. The OMEGA EP performance and the laser engineering of enabling technologies required to meet these goals are discussed.

chirped pulse amplification↗

All-Optical Flip-Flop Operation of VCSOA

An all-optical flip-flop, the memory of which is based on dispersive bistability in a single vertical cavity semiconductor optical amplifier, is demonstrated experimentally. Flip-flop control is achieved using two mechanisms: cross-phase modulation to set the flip-flop and cross-gain modulation of the holding beam within a remote SOA to reset it. Optical control signals are sub-milliwatt in power and derived from a single 5 ns, 1539 nm initial pulse. Flip-flop operation at 1542 nm is polarisation insensitive to control signals and achieved with an on-off contrast greater than 3 dB.

Kaplan, A M↗

OMEGA EP High-Energy Petawatt Laser: Progress and Prospects

OMEGA EP (extended performance) is a petawatt-class addition to the existing 30-kJ, 60-beam OMEGA Laser Facility at the University of Rochester. It will enable high energy picosecond backlighting of high-energy-density experiments and inertial confinement fusion implosions, the investigation of advanced-ignition experiments such as fast ignition, and the exploration of high-energy-density phenomena. The OMEGA EP short-pulse beams have the flexibility to be directed to either the existing OMEGA target chamber, or the new, auxiliary OMEGA EP target chamber for independent experiments. This paper will detail progress made towards activation, which is on schedule for completion in April 2008.

Maywar, D N↗

Cryogenic Target-Implosion Experiments on OMEGA

The University of Rochester’s Laboratory for Laser Energetics has been imploding thick cryogenic targets for six years. Improvements in the Cryogenic Target Handling System and the ability to accurately design laser pulse shapes that properly time shocks and minimize electron preheat, produced high fuel areal densities in deuterium cryogenic targets (202+/-7 mg/cm^2). The areal density was inferred from the energy loss of secondary protons in the fuel (D2) shell. Targets were driven on a low final adiabat (alpha = 2) employing techniques to radially grade the adiabat (the highest adiabat at the ablation surface). The ice layer meets the target-design toughness specification for DT ice of 1-um rms (all modes), while D2 ice layers average 3.0-um-rms roughness. The implosion experiments and the improvements in the quality and understanding of cryogenic targets are presented.

Harding, D R↗