Mcalister, K. W. — Page 2

NASA NTRS1975

Dynamic stall experiments on oscillating airfoils

Dynamic stall and unsteady boundary layer separation have been studied in incompressible flow at moderately large Reynolds numbers. By varying the leading-edge geometry of an NACA 0012 airfoil, three different types of stall were produced. For most of the configurations studied, including the basic NACA 0012 profile, dynamic stall was found not to originate with the bursting of a leading-edge laminar separation bubble, as is commonly believed. Instead, the vortex shedding phenomenon, which is the predominant feature of dynamic stall, appears to be fed its vorticity by the breakdown of the turbulent boundary layer.

Mccroskey, W. J.↗

NASA NTRS1974

Experimental evaluation of compliant surfaces at low speeds

An experimental study was devised to determine the profile drag on a subsonic wind tunnel model partially covered with various compliant surface materials. The model consisted of a large section of constant thickness bounded fore and aft by symmetric airfoil fairings. A flat rigid plate, the control surface, could be exchanged for four contiguous complaint panels. The flexible media generally consisted of thin polyvinylchloride membranes stretched to various tensions over trapped fluid cavities of air, water, or polyethelene oxide solution, or over dry or flooded open-celled polyurethane foams. On the basis of very accurate direct-force cell measurements, all configurations were found to yield profile drags equal to or slightly higher than that obtained for the conventional rigid surface case. The results indicate that the potential for practical drag-reducing applications will be limited to either high-density or high-speed flows where more sensible pressure perturbations occur.

Mcalister, K. W.↗