Search NASA⌕ Search

Engineering topics

Mcdonnell, J. A. M.

Publications and source records attributed to Mcdonnell, J. A. M..

34 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

The dust distribution within the inner coma of comet P/Halley 1982i - Encounter by Giotto's impact detectors

Analyses are presented of Giotto's Dust Impact Detection System experiment measurements of dust grains incident on the Giotto dust shield along its trajectory through the coma of comet P/Halley on March 13 and 14, 1986. Ground-based CCD imagery of the inner coma dust continuum at the time of the encounter are used to derive the area of grains intercepted by Giotto. Data obtained at large masses show clear evidence of a decrease in the mass distribution index at these masses within the coma; it is shown that such a value of the mass index can furnish sufficient mass for consistency with an observed deceleration.

Mcdonnell, J. A. M.↗
NASA NTRS1986

Mass distribution of particulates measured by Giotto's Dust Impact Detection System (DIDSY) in the close encounter period

The cumulative mass distribution of the comet Halley dust efflux in the close encounter period -300 to +300 sec was analyzed. Analysis of the cumulative mass distribution index (alpha) shows considerable short time scale variation. There is clear evidence from the flux rates of passage through at least one major dust enhancement (dust jet) just after closest approach and this is associated with a steepening of the alpha. Comparison with measurements from other sources, and with preencounter predictions, is also made.

Zarnecki, J. C.↗
NASA NTRS1986

Dust density and mass distribution near comet Halley from Giotto observations

The density and the mass spectrum of the dust near comet Halley have been measured by the Giotto space probe's dust impact detection system. The dust spectrum obtained at 291,000 km from the comet nucleus show depletion in small and intermediate masses; at about 600 km from the nucleus, however, the dust activity rises and the spectrum is dominated by larger masses. Most of the mass striking Giotto is noted to reside in the few large particles penetrating the dust shield. Momentum balances and energy considerations applied to an observed deceleration suggest that a large mass of the spacecraft was detached by an impact.

Mcdonnell, J. A. M.↗
NASA NTRS1986

The Giotto dust impact detection system

The Giotto Dust Impact Detection System (DIDSY) consists of six independent subsystems to register the impact of all particulates of significant mass incident on the probe during the post-perihelion encounter with Comet Halley. Mounted on Giotto's front dust shield, the detectors will determine the mass spectrum of the dust, with a limiting sensitivity of 10 to the minus 17th power f, increasing to the largest grain masses encountered along Giotto's trajectory throught the cometary environment with an ultimate spatial resolution of 70 km. An additional detector is located on the rear shield to monitor dust particles that penetrate the from dust shield. An ambient plasma monitor measures the impact plasma generated by dust and gass impacts on the spacecraft.

Mcdonnell, J. A. M.↗
NASA NTRS1986

Cosmic dust and space debris; Proceedings of the Topical Meetings and Workshop 6 of the 26th COSPAR Plenary Meeting, Toulouse, France, June 30-July 11, 1986

These proceedings encompass topics in the fields of extraterrestrial material samples, IRAS solar system and dust model results, and earth orbit debris. Attention is given to chemical fractionation during high velocity impact, particle deceleration and survival in multiple thin foil targets, and IRAS studies of asteroids, comets, cometary tails, the zodiacal background, and the three-dimensional modeling of interplanetary dust. Also discussed are the evolution of an earth orbit debris cloud, orbital debris due to future space activities, collision probabilities in geosynchronous orbits, and a bitelescopic survey of low altitude orbital debris.

Mcdonnell, J. A. M.↗
NASA NTRS1984

Multiple-foil microabrasion package (A0023)

The specific scientific objectives of this experiment are to measure the spatial distribution, size, velocity, radiance, and composition of microparticles in near-Earth space. The technological objectives are to measure erosion rates resulting from microparticle impacts and to evaluate thin-foil meteor 'bumpers'. The combinations of sensitivity and reliability in this experiment will provide up to 1000 impacts per month for laboratory analysis and will extend current sensitivity limits by 5 orders of magnitude in mass.

Mcdonnell, J. A. M.↗
NASA NTRS1983

The ISPM dust experiment

The ISPM Dust Experiment observes particulate matter with masses between 10 to the minus 19th power and 10 to the minus 10th power kg in the solar system; investigates its physical and dynamical properties as a function of ecliptic latitude and heliocentric distance; and studies its interaction with solar radiation, the solar wind, and the interplanetary magnetic field. Measurement of the three dimensional spatial distribution of cosmic dust particles and their dynamics allows the relative significance of their probable sources (comets, asteroids and interstellar dust) to be determined. An instrument that measures the mass, speed, flight direction and electric charge of individual dust particles is used. It is a multicoincidence detector with a sensitivity 100,000 times higher than that of previous experiments. The instrument weighs 3.750 kg, consumes 2.0 W, and has a normal data transmission rate of 8 bit/sec in spacecraft tracking mode.

Gruen, E.↗
NASA NTRS1982

Science on the Space Shuttle

On the Space Shuttle's third flight, scientific instruments will study the electromagnetic environment with charging and electron beams. Beam plasma discharge will be studied. The plasma diagnostics package contains electromagnetic and particle sensors to study the ionosphere. An attempt will be made to establish a more accurate base of solar UV irradiance measurements with an absolute error of 10 percent or less over the wavelength region 120-400 nm. The solar flare X-ray polarimeter will observe flare X-rays emitted between 5 and 30 keV and measure their polarization as a function of time and photon energy. A photopolarimeter will help study zodiacal light, and interplanetary dust will be sampled by a section of thick aluminum foil. Plant seedlings will be grown to research the effect of near-zero gravity on lignification. A thermal canister experiment will help determine whether instruments can be maintained at a fixed temperature under varying thermal loads.

Neupert, W. M.↗
NASA NTRS1982

Recent researches into solid bodies and magnetic fields in the solar system; Proceedings of the Topical Meeting and Symposium, Ottawa, Canada, May 16-June 2, 1982

Topics discussed include the magnetic history of the early solar system, impact processes in solid bodies (e.g., meteoroids and asteroids), and topics related to cometary missions. The section devoted to cometary missions lays particular stress on missions to Comet Halley; attention is given to such aspects of these missions as the investigation of hypervelocity impact on the Giotto Halley mission dust shield, the detection of energetic cometary and solar particles by the EPONA instrument on the Giotto mission, the dust hazard near Comet Halley in regard to the Vega project, and cometary ephemerides for spacecraft flyby missions.

Vette, J. I.↗
NASA NTRS1978

Lunar surface processes - Report of the 12054 consortium

A variety of lunar surface phenomena were studied using a well-characterized glass-coated ilmenite basalt, 12054, which had a simple surface residence history. Surface processes related to the following effects were studied: microcraters, solar flare and cosmic ray tracks, cosmogenic Al-26, solar wind sputtering, accreta or accretionary material, solar wind implanted noble gases, and loose dust accumulation.

Hartung, J. B.↗
NASA NTRS1972

A technique for position sensing and improved momentum evaluation of microparticle impacts in space.

The design of a three element piezoelectric microparticle impact sensing diaphragm is described which is sensitive to the detection of momentum propagated by the bending wave. The design achieves a sensitivity of .03 microdyn/sec and optimizes the detection of the direct-path pulse from impact relative to secondary reflections and interference from discontinuities. Measurement of the relative arrival times and the maximum amplitudes of the outputs from the three piezoelectric sensors leads to the determination of the impact position and the normally resolved impact momentum exchange. Coincidence of the signals and a partial redundancy of data leads to a very high noise discrimination.

Mcdonnell, J. A. M.↗