Search NASA⌕ Search

Engineering topics

Mcgee, T.

Publications and source records attributed to Mcgee, T..

Excimer laser system for atmospheric remote sensing of ozone

A high-power narrow-linewidth XeCl excimer laser system developed for use by NASA in the remote sensing of atmospheric ozone is described. The laser system is designed for incorporation in a DIAL lidar utilizing stimulated Raman generation for the reference wavelength and sophisticated data averaging techniques. The laser output has a linewidth of 0.002 nm and a beam divergence of 0.15 mrad (FWHM). The laser was operated over a six-hour period with a constant average power of 18 W and a wavelength stable to within + or - 0.0006 nm.

Tan, K. O.↗

Absolute two-photon excitation cross-sections in NO

A technique has been developed which allows the determination of a two-photon absorption cross-section to be made relative to the Raman scattering cross-section in nitrogen. Spatial and temporal effects associated with the lasers are ratioed out to give a result independent of laser parameters. The necessary theory to extract a cross-section from the measured ratio of a Coherent Anti-Stokes Raman Scattering (CARS) signal in N2 to a four-wave mixing signal in NO has been developed. The technique has been demonstrated on the R(22) + S(12) (J-double-prime = 9 1/2) line in NO and a cross-section of (2.9 + or - 1.8) x 10 to the -49th (cm to the 4th power)-s was determined. This technique appears to be applicable to a number of other diatomic molecules.

Burris, J.↗

Airborne laser induced fluorescence system for measuring OH and other trace gases in the parts-per-quadrillion to parts-per-trillion range

Described in detail is a laser induced fluorescence system which has been successfully interfaced with two aircraft sampling platforms (i.e., Sabreliner jet and an L-188C Electra). This system, which has been under development for four years, presently consists of the following major components: (1) a Nd-Yag laser driven oscillator-amplifier dye laser; (2) a sampling manifold with associated fluorescence detection optics; (3) an OH calibration chamber; (4) a laser beam steering assembly; and (5) sampling electronics and data processing hardware. During the last three years, this system has been flown some 50,000 air miles making tropospheric OH radical measurements over the latitude range of 70 N to 57 S. OH concentrations measured during these flights have ranged from 30 parts-per-quadrillion (3.7 x 10 to the 5th molecules/sq cm) at altitudes of 6 km to 0.8 parts-per-trillion (2.0 x 10 to the 7th molecules/sq cm) at 0.5 km. Computations have been completed which indicate that the existing aircraft system with modest modifications should also be capable of detecting natural tropospheric levels of NO, SO2, CH2O, NO2, HNO2, NO3, H2O2 and CS2 by using both conventional laser-induced fluorescence methodology and multiphoton techniques.

Davis, D. D.↗

Boundary layer measurements of the OH radical in the vicinity of an isolated power plant plume - SO2 and NO2 chemical conversion times

Direct measurements of the OH radical in the vicinity of an isolated power plant plume are reported. These measurements were used to estimate the conversion time of SO2 to H2SO4-sulfate aerosol via the initiating step OH + SO2 + M yields HSO3. Using the near-high-noon measured value of OH (9.5 million per cu cm), resulted in a 1/e conversion time of 1.4 days. The latter lifetime would correspond to a conversion rate of about 2%/hr. When the lifetime calculation was modified to take into consideration the OH diurnal cycle, the 1/e conversion time for SO2 was found to be 4.4 days, giving an apparent overall rate of conversion of about 0.7%/hr. Similar calculations carried out for the conversion of NO2 to NHO3 resulted in 1/e lifetimes for NO2 of 2-3 h for midday time periods.

Davis, D. D.↗